2023 GENESIS G80 reset
[x] Cancel search: resetPage 344 of 661
6-18
Driving Your Vehicle
„Type A
ORG3EV041071L
„Type B
ORG3EV041010AU
The selected regenerative braking level is
displayed on the instrument cluster.
Initial setting of the regenerative
braking level and adjustable range vary
according to the selected Drive mode.
Drive mode Adjustable Range
SNOW 0 to 1
ECO 0 to 3
COMFORT 0 to 3
SPORT 0 to 3
For more details, refer to "Drive Mode
Integrated Control System" in this
chapter.
One Pedal Driving
The driver can stop the vehicle by pulling
the left side paddle shifter .
To operate:
[ Pull and hold the left side paddle
shifter while coasting.
[ When the vehicle speed is above 1.8
mph (3 km/h), release the paddle
shifter to return to the preset
regenerative braking stage.
[ When the vehicle speed is below 1.8
mph (3 km/h), the function maintains
control to stop the vehicle even
though the paddle shifter is released.
[ While the One pedal driving is
operating, the driver can control the
vehicle stopping position using the
accelerator pedal.
Limitations
The vehicle may move even if one pedal
driving is normally operated. Therefore,
the driver should be careful to stop
the vehicle by this function under
circumstances as follows:
-Driving on icy, snowy, wet, sandy,
muddy roads, manhole/pit hole
surfaces
-Wheels not aligned
-Conditions in which wheel slip or spin
occurs
-On heavy loading
-By leaning left of right
-Under bad tire wear
-Driving uphill or downhill
-Driving where the slope starts or ends
-By repeating stop and go on ramp
Page 378 of 661
6-52
Driving Your Vehicle
Drive Modes Characteristic
The characteristic of each components varies according to which drive mode is
selected.
Drive modeSNOW COMFORT ECO SPORTMY DRIVE
MODE
CharacteristicsSnow
drivingCOMFORT
driving
modeHigh electric
energy
efficiency
modeSporty
driving
modeSelected
Button activationPress more
than 1 sec.Press Press PressPress more
than 1 sec.
Indicator on the
clusterSNOW - ECO SPORTMY
Climate system
controlCOMFORT COMFORTECO (ECO/
COMFORT)
*1COMFORTCOMFORT
Speed Limit----
-
Regenerative
braking level0~1 0~3
*1 : It is possible to set the driving condition for each drive mode, at the drive mode setting in
Infotainment system, See additional information in supplied Infotainment Manual.
ÃYou can reset CUSTOM mode from the Settings menu in the infotainment system screen.
- 6 H W X S
Page 451 of 661
7-59
07
OJK071213N
(1) Speed Limit indicator
(2) Set speed
You can set the speed limit when you do
not want to drive over a specific speed.
If you drive over the preset speed limit,
Manual Speed Limit Assist will operate
(set speed limit will blink and chime will
sound) until the vehicle speed returns
within the speed limit.
Manual Speed Limit Assist
Operation
Setting speed limit
ORG3EV071028L
1. Press and hold Driving Assist
() button at the desired speed. The
Speed Limit () indicator will
illuminate on the cluster.
ORG3EV071029L
2. Push the + switch up or - switch down,
and release it at the desired speed.
Push the + switch up or - switch down
and hold it. The speed will increase
or decrease to the nearest multiple of
five (multiple of ten in km/h) at first,
and then increase or decrease by 5
mph (10 km/h).
0 $ 1 8 $ / 6 3 ( ( ' / , 0 , 7 $ 6 6 , 6 7
Page 452 of 661
7-60
Driver Assistance System
OJK071214N
3. The set speed limit will be displayed
on the cluster.
If you would like to drive over the
preset speed limit, depress the
accelerator pedal beyond the pressure
point to activate the kickdown
mechanism.
The set speed limit will blink and
chime will sound until you return the
vehicle speed within the speed limit.
Information
[ When the accelerator pedal is not
depressed beyond the pressure point,
vehicle speed will maintain within the
speed limit.
[ A clicking sound may be heard from
the kickdown mechanism when the
accelerator pedal is depressed beyond
the pressure point.
Temporarily pausing Manual Speed
Limit Assist
ORG3EV071111L
Press the switch to temporarily
pause the set speed limit. The set speed
limit will turn off but the Speed Limit
(
) indicator will stay on.
Page 453 of 661
7-61
07
Resuming Manual Speed Limit Assist
ORG3EV071029L
To resume Manual Speed Limit Assist
after the function was paused, operate
the +, -,
switch.
If you push the + switch up or – switch
down, vehicle speed will be set to the
current speed on the cluster.
If you press the
switch, vehicle
speed will resume to the preset speed.
Turning off Manual Speed Limit
Assist
ORG3EV071028L
Press the Driving Assist () button to
turn Manual Speed Limit Assist off. The
Speed Limit (
) indicator will go
off.
WARNING
Take the following precautions when
using Manual Speed Limit Assist:
[ $ O Z D \ V V H W W K H Y H K L F O H V S H H G W R W K H
V S H H G O L P L W L Q \ R X U F R X Q W U \ O R F D O
D U H D
[ Keep Manual Speed Limit Assist off
Z K H Q W K H I X Q F W L R Q L V Q R W L Q X V H W R
D Y R L G L Q D G Y H U W H Q W O \ V H W W L Q J D V S H H G
Check that the Speed Limit (
)
L Q G L F D W R U L V R I I
[ Manual Speed Limit Assist does
Q R W V X E V W L W X W H I R U S U R S H U D Q G V D I H
G U L Y L Q J , W L V W K H U H V S R Q V L E L O L W \ R I
W K H G U L Y H U W R D O Z D \ V G U L Y H V D I H O \
D Q G V K R X O G D O Z D \ V E H D Z D U H R I
X Q H [ S H F W H G D Q G V X G G H Q V L W X D W L R Q V
I U R P R F F X U U L Q J 3 D \ D W W H Q W L R Q W R W K H
U R D G F R Q G L W L R Q V D W D O O W L P H V
Page 462 of 661
7-70
Driver Assistance System
[ The driver’s attention level is displayed
on the scale of 1 to 5. The lower the
level is, the more inattentive the driver
is.
[ The level decreases when the driver
does not take a break for a certain
period of time.
7 D N L Q J D E U H D N
OTM070105L
[ The ‘Consider taking a break’ message
will appear on the cluster and an
audible warning will sound to suggest
that the driver take a break, when the
driver’s attention level is below 1.
[ Driver Attention Warning will not
suggest a break when the total driving
time is shorter than 10 minutes or 10
minutes has not passed after the last
break was suggested.
WARNING
) R U \ R X U V D I H W \ R Q O \ F K D Q J H W K H
6 H W W L Q J V D I W H U S D U N L Q J W K H Y H K L F O H D W D
V D I H O R F D W L R Q
& $ 8 7 , 2 1
[ ' U L Y H U $ W W H Q W L R Q : D U Q L Q J P D \
V X J J H V W D E U H D N G H S H Q G L Q J R Q W K H
G U L Y H UT V G U L Y L Q J S D W W H U Q R U K D E L W V
H Y H Q L I W K H G U L Y H U G R H V QT W I H H O I D W L J X H
[ ' U L Y H U $ W W H Q W L R Q : D U Q L Q J L V D
V X S S O H P H Q W D O I X Q F W L R Q D Q G P D \ Q R W
E H D E O H W R G H W H U P L Q H Z K H W K H U W K H
G U L Y H U L V L Q D W W H Q W L Y H
[ 7 K H G U L Y H U Z K R I H H O V I D W L J X H G V K R X O G
W D N H D E U H D N D W D V D I H O R F D W L R Q H Y H Q
W K R X J K W K H U H L V Q R E U H D N V X J J H V W L R Q
E \ ' U L Y H U $ W W H Q W L R Q : D U Q L Q J
Information
[ For more details about setting
instrument panel, refer to “LCD
Display Control” section in chapter 4.
[ Driver Attention Warning will reset the
last break time to 00:00 in the following
situations:
-The vehicle is turned off
-The driver unfastens the seat belt
and opens the driver’s door
-The vehicle is stopped for more than
10 minutes
[ When the driver resets Driver Attention
Warning, the last break time is set to
00:00 and the driver’s attention level is
set to High.
Page 476 of 661
7-84
Driver Assistance System
ORG3EV071124
To temporarily cancel Smart Cruise
Control
Press the switch or depress the
brake pedal to temporarily cancel Smart
Cruise Control.
ORG3EV071125
To resume Smart Cruise Control
To resume Smart Cruise Control after the
function was canceled, operate the +, -
or
switch.
If you press the + switch up or - switch
down, vehicle speed will be set to the
current speed on the cluster.
If you push the
switch, vehicle speed
will resume to the preset speed.
WARNING
& K H F N W K H G U L Y L Q J F R Q G L W L R Q E H I R U H
using the V Z L W F K ' U L Y L Q J V S H H G
P D \ V K D U S O \ L Q F U H D V H R U G H F U H D V H Z K H Q
\ R X S U H V V W K H
V Z L W F K
ORG3EV071028L
To turn off Smart Cruise Control
Press the Driving Assist () button to
turn Smart Cruise Control off.
Information
If your vehicle is equipped with Manual Speed
Limit Assist, press and hold the Driving Assist
(
) button to turn off Smart Cruise Control.
However Manual Speed Limit Assist will turn on.
Based on Drive Mode
Smart Cruise Control will change
acceleration based on the drive mode
selected from Drive Mode Integrated
Control system. Refer to the following chart.
' U L Y H P R G HSmart Cruise Control
COMFORT Normal
ECO Slow
SPORT Fast
MY DRIVE
(CUSTOM)Depending on power
train mode
SNOW Normal
Information
[ For more details on drive mode, refer
to “Drive Mode Integrated Control
System” section in chapter 6.
[ Smart Cruise Control may not turn on
or off in some of the drive modes for the
operating conditions are not satisfied.
[ If your vehicle is not equipped with
Drive Mode Integrated Control system,
Smart Cruise Control accelerates your
vehicle at a standard level.
Page 495 of 661
7-103
07
Information
[ Highway Set Speed Auto Change
function only operates based on
the speed limits of the highway (or
motorway), it does not work with the
speed cameras.
[ When Highway Set Speed Auto Change
function is operating, the vehicle
automatically accelerates or decelerates
when the highway (or motorway) speed
limit changes.
[ The maximum set speed for Highway
Set Speed Auto Change function is 86
mph (140 km/h).
[ If the speed limit of a new road is not
updated in the navigation, Highway Set
Speed Auto Change function may not
operate properly.
[ If the speed unit is set to a unit other
than the speed unit used in your
country, Highway Set Speed Auto
Change function may not operate
properly.
/ L P L W D W L R Q V R I 1 D Y L J D W L R Q % D V H G
Smart Cruise Control
Navigation-based Smart Cruise Control
may not operate properly under the
following circumstances:
[ The navigation is not working properly
[ Map information is not transmitted
due to infotainment system's
abnormal operation
[ Speed limit and road information in
the navigation is not updated
[ The map information and the actual
road is different because of real-time
GPS data or map information error
[ The navigation searches for a route
while driving[ GPS signals are blocked in areas such
as a tunnel
[ A road that divides into two or more
roads and joins again
[ The driver goes off course the route
set in the navigation
[ The route to the destination is
changed or canceled by resetting the
navigation
[ The vehicle enters a service station or
rest area
[ Android Auto or Car Play is operating
[ The navigation cannot detect the
current vehicle position (for example,
elevated roads including overpass
adjacent to general roads or nearby
roads exist in a parallel way)
[ The navigation is being updated while
driving
[ The navigation is being restarted while
driving
[ The speed limit of some sections
changes according to the road
situations
[ Driving on a road under construction
[ Driving on a road that is controlled
[ There is bad weather, such as heavy
rain, heavy snow, etc.
[ Driving on a road that is sharply
curved