Page 318 of 470

Full-size dissimilar spare
When driving with the full-size dissimilarspare wheel and tire assembly, do not:
•Exceed 50 mph (80 km/h).
•Use more than one dissimilar sparewheel and tire assembly at a time.
•Use snow chains on the end of thevehicle with the dissimilar spare wheeland tire assembly.
When driving with the full-size dissimilarspare wheel and tire assembly, 4WDfunctionality may be limited, especiallywhen driving in a mechanically locked 4WDmode. You may experience the following:
•Additional noise from the transfer caseor other drive components.
•Difficulty shifting out of a mechanicallylocked 4WD mode.
When driving with the full-size dissimilarspare wheel and tire assembly you do not:
•Exceed 50 mph (80 km/h) in 4WD.
•Engage 4WD unless the vehicle isstationary.
•Use 4WD on dry pavement.
The usage of a full-size dissimilar sparewheel and tire assembly can lead toimpairment of the following:
•Handling, stability and brakingperformance.
•Comfort and noise.
•Ground clearance and parking at curbs.
•Winter weather driving capability.
•Wet weather driving capability.
•Four-wheel drive capability.
When driving with the full-size dissimilarspare wheel and tire assembly additionalcaution should be given to:
•Towing a trailer.
•Driving vehicles equipped with acamper body.
•Driving vehicles with a load on thecargo rack.
Drive cautiously when using a full-sizedissimilar spare wheel and tire assemblyand seek service as soon as possible.
Tire Change Procedure
WARNING: The jack supplied withthis vehicle is only intended for changinga flat tire in an emergency. Do notattempt to do any other work on yourvehicle when it is supported by the jack,as your vehicle could slip off the jack.Failure to follow this instruction couldresult in personal injury or death.
WARNING: To help prevent yourvehicle from moving when changing awheel, shift the transmission into park(P), set the parking brake and use anappropriate block or wheel chock tosecure the wheel diagonally opposite tothe wheel being changed. For example,when changing the front left wheel,place an appropriate block or wheelchock on the right rear wheel.
WARNING: Do not attempt tochange a tire on the side of the vehicleclose to moving traffic. Pull far enoughoff the road to avoid the danger of beinghit when operating the jack or changingthe wheel.
WARNING: Only use the jackprovided as original equipment with yourvehicle.
314
2023 Ranger (TFG) Canada/United States of America, Vehicles Built From: 10-10-2022, enUSA, Edition date: 202208, First-PrintingWheels and Tires
Page 319 of 470

WARNING: No person should placeany portion of their body under a vehiclethat is supported by a jack.
WARNING: The jack supplied withthis vehicle is only intended for changingwheels. Do not use the vehicle jack otherthan when you are changing a wheel inan emergency.
WARNING: The jack should beused on level firm ground whereverpossible.
WARNING: Check that the vehiclejack is not damaged or deformed andthe thread is lubricated and clean.
WARNING: Never place anythingbetween the vehicle jack and the ground.
WARNING: Never place anythingbetween the vehicle jack and yourvehicle.
WARNING: It is recommended thatthe wheels of the vehicle be chocked,and that no person should remain in avehicle that is being jacked.
Park on a level surface, activate the hazardflashers and set the parking brake. Then,place the transmission in park (P) and turnthe engine off.
Note:Only use the spare tire carrier to stowthe tire and wheel combination providedwith your vehicle. Other tire and wheelcombinations will cause the tire carrier tofail.
Note:Do not use impact tools or powertools on the spare tire carrier, as this couldcause a winch malfunction and prevent asecure fit. The spare tire carrier tighteningtorque should be 29.50 lb.ft (40 Nm) +/-4.43 lb.ft (6 Nm).
Note:When jacking the vehicle passengersshould not be in the vehicle.
Vehicle Jack
WARNING: Ensure screwthread isadequately lubricated before use.
WARNING: The jack should beused on level firm ground whereverpossible.
WARNING: Switch the ignition offand apply the park brake fully beforelifting vehicle.
WARNING: It is recommended thatthe wheels of the vehicle be chocked,and that no person should remain in avehicle that is being jacked.
WARNING: No person should placeany portion of their body under a vehiclethat is supported by a jack.
WARNING: Do not get under avehicle that is supported by a jack.
WARNING: The jack supplied withthis vehicle is only intended for changingwheels. Do not use the vehicle jack otherthan when you are changing a wheel inan emergency.
315
2023 Ranger (TFG) Canada/United States of America, Vehicles Built From: 10-10-2022, enUSA, Edition date: 202208, First-PrintingWheels and TiresE166722
Page 320 of 470
Vehicle Jack Assembly
Wheel brace.A
Jack handle and extensions.B
Vehicle jack.C
The jack, wheel brace, extensions and jackhandle are in the cab.
Your jack does not require maintenance oradditional lubrication over the service lifeof your vehicle.
Do not use the jack if it is visibly damagedor does not operate freely. Replace thedamaged jack with a jack specified for useon your vehicle if you detect theseconditions.
316
2023 Ranger (TFG) Canada/United States of America, Vehicles Built From: 10-10-2022, enUSA, Edition date: 202208, First-PrintingWheels and TiresE271861
Page 321 of 470
SuperCab
1.Pull the release strap on the left-handside rear seat.
2.Remove the rear seat.
3.Carefully remove the cover.
4.Remove the bolt.
5.Lift the jack from the foam block andremove the jack from your vehicle.
6.Remove the tools.
Note:Pay close attention to the orientationof the jack and tool kit bag, because youneed to reinstall them after changing thetire.
317
2023 Ranger (TFG) Canada/United States of America, Vehicles Built From: 10-10-2022, enUSA, Edition date: 202208, First-PrintingWheels and TiresE134701 E131838 E296014
Page 322 of 470
SuperCrew
1.Lift the release strap.
2.Lower the seat backrest.
3.Remove the bolt.
4.Lift the jack from the foam block andremove the jack from your vehicle.
Note:The jack and tools are storedseparately.
Note:Pay close attention to the orientationof the jack and tool kit bag, because youneed to reinstall them after changing thetire.
SuperCrew
1.Pull the release strap out.
2.Fully lift the seat cushion up into thelocked position.
3.Loosen the D-ring straps to form aloop.
4.Remove the tools.
Spare Wheel
1.Assemble the handle.
318
2023 Ranger (TFG) Canada/United States of America, Vehicles Built From: 10-10-2022, enUSA, Edition date: 202208, First-PrintingWheels and TiresE277295 E284137 E266665
Page 323 of 470

2.Insert the jack handle into the guidehole. Turn counterclockwise until thewheel rests on the ground, and there isslack in the cable.
3.Pass the bracket and cable through thewheel opening.
Note:If the spare wheel is not the sametype and size as your vehicle road wheel,drive the shortest distance possible.
Note:Do not fit more than one spare wheelon your vehicle at any one time.
Note:The spare wheel has a label showingthe maximum driving speed. Drive withcaution and at no more than the permittedmaximum speed.
Note:The usage of a dissimilar spare wheelor tire at any one wheel location can leadto impairment of the handling, stability andbraking performance, comfort and noise.
Note:When driving with a spare tire, do notswitch on four-wheel drive mode unless youneed to get your vehicle unstuck.
Note:The spare wheel is underneath therear of the vehicle.
Note:Only two extensions are used tolower the rear wheel.
Jacking and Lifting Points
WARNING: Use only the specifiedjacking points. If you use other locations,you could damage the body, steering,suspension, engine, braking system orthe fuel lines.
319
2023 Ranger (TFG) Canada/United States of America, Vehicles Built From: 10-10-2022, enUSA, Edition date: 202208, First-PrintingWheels and TiresE283035 E133590
Page 324 of 470
Note:Only use the jack on the specifiedfront jacking points.
Note:Only use the jack on the specifiedpoints on the rear axle tube for the rearjacking points.
Note:Use the arrow indicator on the framefor the front jacking point.
320
2023 Ranger (TFG) Canada/United States of America, Vehicles Built From: 10-10-2022, enUSA, Edition date: 202208, First-PrintingWheels and TiresE361899 E361924 E296118
Page 325 of 470

Removing a Road Wheel
WARNING: Park your vehicle insuch a position that neither the trafficnor you are hindered or endangered.
WARNING: Make sure that thewheels are pointing straight ahead.
WARNING: If your vehicle has amanual transmission, shift into first orreverse gear. If your vehicle has anautomatic transmission, shift into park(P).
WARNING: Secure the diagonallyopposite wheel with an appropriateblock or wheel chock.
WARNING: Make sure that thevehicle jack is vertical to the jacking pointand the base is flat on the ground.
WARNING: Never place anythingbetween the vehicle jack and yourvehicle.
1.Assemble the jack handle.
2.Ensure screwthread on the jack isadequately lubricated before use.
3.Loosen the wheel nuts.
4.Raise your vehicle until the tire is clearof the ground.
5.Remove the wheel nuts and the roadwheel.
Note:Assemble the three handles to jackthe rear of the vehicle.
Note:Do not lay alloy road wheels facedown on the ground.
Installing a Road Wheel
WARNING: Use only approvedwheel and tire sizes. Using other sizescould damage your vehicle.
WARNING: Do not fit run flat tireson vehicles that were not originally fittedwith them. See an authorized dealer formore details about compatibility.
WARNING: Make sure there is nogrease or oil on the threads or thesurface between the wheel lugs andnuts. This can cause the lug nuts toloosen while driving.
WARNING: Have the lug nutschecked for tightness and the tirepressure checked as soon as possible.
1.Install the wheel.
321
2023 Ranger (TFG) Canada/United States of America, Vehicles Built From: 10-10-2022, enUSA, Edition date: 202208, First-PrintingWheels and TiresE266665 E134693