2023 CITROEN C-ELYSÉE belt

59
Driving
6Deactivation/Reactivation
The function is activated by default when the
ignition is switched on.
To deactivate/reactivate the function:
With the dashboard button



► Press the button.
A message on the instrument panel confirms the
change of status.
When the function is deactivated, the orange
indicator lamp is lit; if the engine was in standby,
it restarts immediately.
With the touch screen button
The settings are changed via the Driving/Vehicle touch screen
menu.
A message on the instrument panel confirms the
change of status.
When the function is deactivated, if the engine
was in standby, it restarts immediately.
Associated indicator lamp
Function activated: engine on standby
(STOP mode).
Opening the bonnet
Before doing anything under the bonnet,
deactivate the Stop & Start system to avoid
any risk of injury caused by the engine
restarting automatically.
Driving on flooded roads
Before entering into a flooded area, it is
strongly recommended that you deactivate
the Stop & Start system.
For more information on Driving
recommendations, particularly on flooded
roads, refer to the corresponding section.
Operation
Main conditions for operation
– The driver ’s door must be closed.
– The driver's seat belt must be fastened.
–

The level of charge in the battery must be
sufficient.
–


The temperature of the engine must be within
its nominal operating range.
–


The outside temperature must be between
0°C and 35°C.
Putting the engine into standby
(STOP mode)
The engine automatically enters standby mode
as soon as the driver indicates their intention to
stop:
With a manual gearbox: at speeds below 12
mph (20
km/h) or with the vehicle stationary
(depending on engine), with the gear lever in
neutral and the clutch pedal released.
With an automatic gearbox: with the brake
pedal depressed or the gear selector in
position

N
, with the vehicle stationary.
Time counter
A time counter adds up the time spent in standby
during the journey. It is reset to zero every time
the ignition is switched on.
Special cases
The engine will not go into standby if the
conditions for operation are not met and in the
following cases:
–
V
ehicle has not exceeded 6 mph (10 km/h)
since the last engine start.
–

Needed
to maintain a comfortable temperature
in the passenger compartment.
–

Demisting active.
–


Braking assistance being used.
In these cases, this indicator lamp flashes
for a few seconds, then goes off.

93
In the event of a breakdown
8► Release the bonnet by pulling the internal
release lever , then the external safety catch.
►

Raise the bonnet.
(+)

Positive terminal with a quick-release
terminal.
(-) Negative terminal.
As the battery's negative terminal is not
accessible, a remote earth point is located on
the engine.
Starting using another battery
If the vehicle's battery is flat, the engine can be
started using a backup battery (either external or
from another vehicle) and jump leads or using a
battery booster.
Never start the engine by connecting a
battery charger.
Never use a 24
V or higher battery booster.
Check beforehand that the backup battery
has a nominal voltage of 12
V and a capacity
at least equal to that of the discharged
battery.
The two vehicles must not be in contact with
each other.
Switch off all electricity-consuming equipment
on both vehicles (audio system, wipers,
lighting, etc.).
Make sure that the jump leads are well away
from the engine’s moving parts (fan, belt,
etc.).
Do not disconnect the (+) terminal while the
engine is running.


► Lift the plastic cover on the (+) terminal, if the
vehicle has one.
►

Connect the red cable to the (+) terminal of
flat battery

A (at the metal elbow), then to the
(+) terminal of the backup battery
B or of the
booster.
►

Connect one end of the green or black cable
to the (-) terminal of the backup battery

B or of
the booster (or to an earth point on the assisting
vehicle).
►

Connect the other end of the green or black
cable to the earth point


C
.
►

Start the engine on the assisting vehicle and
leave it running for a few minutes.
►


Operate the starter on the broken down
vehicle and let the engine run.
If the engine does not start immediately

, switch
off the ignition and wait a few moments before
trying again.
►

W
ait for it to return to idle.
►

Disconnect the jump leads in reverse order.
► Refit the plastic cover to the (+) terminal, if
the vehicle has one.
►

Allow the engine to run for at least
30

minutes, with the vehicle stationary, so that
the battery reaches an adequate state of charge.
Driving immediately without having
reached a sufficient level of charge may
affect some of the vehicle's functions (e.g.
Stop & Start).
Charging the battery using a battery
charger
For optimum service life of the battery, it is
essential to maintain an adequate state of
charge.
In some circumstances, it may be necessary to
charge the battery:
–

When using the vehicle mainly for short
journeys.
–


If the vehicle is to be taken off the road for
several weeks.
Contact a CITROËN dealer or a qualified
workshop.
To charge the vehicle's battery yourself, use only a charger compatible with
lead-acid batteries with a nominal voltage of
12

V.
Follow the instructions provided by the
manufacturer of the charger.
Never reverse polarities.

149
Vehicle data recording and privacy
13Vehicle data recording
and privacy
Electronic control units are installed in your
vehicle. These control units process data
received from the vehicle's sensors, for example,
or data they generate themselves or exchange
with each other. Some of these control units are
required for the correct operation of your vehicle,
some others assist you while driving (driving or
manoeuvring aids), while others provide comfort
or infotainment functions.
The following contains general information about
how data is processed within the vehicle.
You will find additional information about the
specific data which is downloaded, stored
and transmitted to third parties and what it is
used for in your vehicle under the keyword
"Data protection". This information is directly
associated with the references for the functions
in question contained in the corresponding
vehicle handbook, or in the general terms and
conditions of sale.
This information is also available online.
Vehicle operating data
The control units process the data used for the
operation of the vehicle.
This data includes, for example:
–
Information about the state of the vehicle
(e.g.

speed, travel time, lateral acceleration,
wheel rotation rate, fastened seat belts display). –

Environmental conditions (e.g.
temperature,
rain sensor, distance sensor).
As a general rule, this data is temporary, is
not stored for longer than one operating cycle
and is only used within the vehicle itself. The
control units often record this data (including the
vehicle's key). This function allows either the
temporary or permanent storage of information
about the state of the vehicle, stresses on
components, servicing requirements, as well as
events and technical errors.
Depending on the vehicle's equipment level, the
data stored is as follows:
–
Operating state of system components
(e.g.
filling level, tyre pressures, battery charge
status).
–
Faults and malfunctions in important system
components (e.g.
lamps, brakes).
–
System reactions in specific driving situations
(e.g.
deployment of an airbag, triggering of
stability control and braking systems).
–
Information about events which have
damaged the vehicle.
–

For electric and rechargeable hybrid vehicles,
the traction battery charge level and the
estimated driving range.
In particular circumstances (e.g.
if the vehicle
has detected a malfunction), it may be necessary
to record data which would otherwise simply not
be stored.
When taking your vehicle in for servicing
(e.g.
repairs, maintenance), the stored operating
data may be read along with the vehicle's identification number and used if necessary.
The personnel working for the servicing network
(e.g.
garages, manufacturers) or third parties
(e.g. roadside assistance agents) may read
the vehicle's data. This also applies to work
carried out under warranty and quality assurance
measures.
This data is generally read via the OBD
(On-Board Diagnostics) port fitted by law to
the vehicle. It is used to report on the technical
state of the vehicle or its components and
facilitates the diagnosis of malfunctions, in
compliance with warranty obligations and for
quality improvement. This data, in particular the
information relating to stress on components,
technical events, operator errors and other
malfunctions, is sent to the Manufacturer, if
necessary, along with the vehicle's identification
number. The Manufacturer's liability may also be
engaged. The Manufacturer may also use the
operating data taken from the vehicle for product
recalls. This data may also be used to check the
customer's warranty and any claims made under
warranty.
Any malfunctions stored in the vehicle may be
reset by an after-sales service company during
servicing or repair work, or at your request.

155
Alphabetical index
Opening the bonnet 76
Opening the boot
17, 20–21
Opening the doors

17, 20
P
Pads, brake 80
Paint
81, 100
Paint colour code

100
Parking brake

54, 80
Parking sensors, audible and visual

66
Plates, identification

100
Player, Apple®

118, 140
Player, MP3 CD

104, 139
Player, USB

104, 117, 139
Port, USB

31, 104–105, 117–118, 139
Pressures, tyres

80, 101
Pre-tensioning (seat belts)

40
Priming pump

83
Priming the fuel system

83
Profiles

121, 144
Protecting children

42–49
Puncture

84
R
Radio 103, 115–116, 137–139
Radio, digital (Digital Audio
Broadcasting - DAB)

117, 138–139
Range, AdBlue®

79
RDS 116, 138
Reading lamps
32
Rear bench seat

24
Rear screen (demisting)

29–30
Recharging the battery

92–93
Recorder, trip distance

13
Reduction of electrical load (mode)

74
Regeneration of the particle filter

79
Reinitialising the remote control

20
Reinitialising the under-inflation
detection system

61
Reminder, key in ignition

54
Reminder, lighting on

33
Remote control

17–19, 52
Removing a wheel

85–86
Replacing bulbs

87–88, 90
Replacing fuses

91
Replacing the air filter

79
Replacing the oil filter

79
Replacing the passenger
compartment filter

79
Reservoir, screenwash

78
Resetting the trip recorder

13
Reversing camera

62, 67
Reversing lamps

90
Roof bars

75
Running out of fuel (Diesel)

83
S
Safety, children 42–45, 47–48
Saturation of the particle filter (Diesel) 79
Screen, cold climate
74
Screen menu map

119
Screen, multifunction (with audio system)

103
Screens, very cold conditions

75
Screenwash

35
Screenwash, front

35
SCR (Selective Catalytic Reduction)

70
Seat belts

39–40, 45
Seat belts, rear

40
Seats, front

23
Seats, rear

24, 44
Sensors (warnings)

62
Serial number, vehicle

100
Servicing

11, 79
Settings, system

122, 144
Shield, snow

74
Sidelamps

34, 88–90
Side repeater (turn signal)

90
Snow chains

61, 73
Snow screen

74
Socket, 12 V accessory

31
Socket, auxiliary

105, 117, 139
Socket, Jack

31, 105, 139
Sockets, audio

31, 105
Speed limiter

63–64
Speedometer

63
Stability control (ESC)

38
Starting a Diesel engine

69
Starting the vehicle

53–54, 57
Starting using another battery

93
Station, radio

103, 115–116, 137–138

156
Alphabetical index
Stay, engine bonnet 76
Steering mounted controls,
audio

102, 113, 126
Steering wheel (adjustment)

25
Stickers, customising

82
Stopping the vehicle

53–54, 57
Stop & Start

16, 27, 29, 58–60, 69, 75, 79, 95
Storage

30–31
Sunshine sensor

26
Sun visor

30
Switch, ignition

53–54
Synchronising the remote control

20
T
Tables of engines 98–99
Tank, fuel
69–70
Technical data

98–99
Telephone

107, 120–121, 140–143
Third brake lamp

91
Time (setting)

14, 122, 145
TMC (Traffic info)

132
Tools

83, 84
Topping-up AdBlue®

72
Top Tether (fixing)

47
Total distance recorder

13
Towbar

74
Towed loads

97
Towing

95–96
Towing another vehicle

96
Towing the vehicle

95–96
Traction control (ASR) 38–39
Traffic information (TA)
103
Traffic information (TMC)

132
Trailer

74, 98–99
Trajectory control systems

38
Triangle, warning

83
Trip computer

14–16
Tyres

80, 101
Tyre under-inflation detection

60–62
U
Under-inflation (detection) 60
Unlocking
17
Unlocking from the inside

18
Unlocking the boot

17
Unlocking the doors

18–19
Updating the date

123, 145
Updating the time

122, 145
USB

104, 117–118, 139
V
Vehicle data recording and privacy 149
Ventilation
26–29
Voice commands

128–130
W
Warning and indicator lamps 7
Warning lamp, driver's
seat belt not fastened

40
Warning lamps

7
Warning lamp, seat belts

40
Warnings and indicators

7–8
Washing

63
Washing (advice)

81–82
Weights

97
Wheel, spare

80, 83–85
Windscreen, bottom of heated

29
Windscreen, heated

29
Wiper blades (changing)

35–36
Wipers

35