Page 437 of 524

Cadillac CT4 Owner Manual (GMNA-Localizing-U.S./Canada-16500442) -
2023 - CRC - 5/4/22
436 Vehicle Care
balancing are not necessary
on a regular basis. Consider an
alignment check if there is
unusual tire wear or the
vehicle is significantly pulling
to one side or the other. Some
slight pull to the left or right,
depending on the crown of the
road and/or other road
surface variations such as
troughs or ruts, is normal.
If the vehicle is vibrating when
driving on a smooth road, the
tires and wheels may need to
be rebalanced. See your
dealer for proper diagnosis.
Wheel Replacement
Replace any wheel that is
bent, cracked, or badly rusted
or corroded. If wheel nuts
keep coming loose, the wheel,
wheel bolts, and wheel nuts
should be replaced. If the
wheel leaks air, replace it.
Some aluminum wheels can be
repaired. See your dealer if
any of these conditions exist.
Your dealer will know the kind
of wheel that is needed.Each new wheel should have
the same load-carrying
capacity, diameter, width,
offset, and be mounted the
same way as the one it
replaces.
Replace wheels, wheel bolts,
wheel nuts, or Tire Pressure
Monitor System (TPMS)
sensors with new GM original
equipment parts.
{Warning
Using the wrong
replacement wheels, wheel
bolts, or wheel nuts can be
dangerous. It could affect
the braking and handling of
the vehicle. Tires can lose air
and cause loss of control,
resulting in a crash. Always
use the correct wheel, wheel
bolts, and wheel nuts for
replacement.
{Warning
Replacing a wheel with a
used one is dangerous. How
it has been used or how far
it has been driven may be
unknown. It could fail
suddenly and cause a crash.
When replacing wheels, use
a new GM original
equipment wheel.
Caution
The wrong wheel can also
cause problems with bearing
life, brake cooling,
speedometer or odometer
calibration, headlamp aim,
bumper height, vehicle
ground clearance, and tire or
tire chain clearance to the
body and chassis.
Page 455 of 524

Cadillac CT4 Owner Manual (GMNA-Localizing-U.S./Canada-16500442) -
2023 - CRC - 5/4/22
454 Vehicle Care
The vehicle is equipped with a
tow eye. Only use the tow eye
to pull the vehicle onto a
flatbed car carrier from a flat
road surface. Do not use the
tow eye to pull the vehicle
from snow, mud, or sand. The
tow eye is located under the
carpet in the trunk.
Carefully open the cover in the
fascia by using the small notch
that conceals the tow eye
socket.
Install the tow eye into the
socket and turn it until it is
fully tightened. When the tow
eye is removed, reinstall the
cover with the notch in the
original position.Rear Tow Eye
If equipped, carefully open the
cover by using the small notch
that conceals the rear tow eye
socket. Install the tow eye into
the socket and turn it until it is
fully tightened. When the tow
eye is removed, reinstall the
cover with the notch in the
original position.
Recreational Vehicle
Towing
Caution
Dolly towing or dinghy
towing the vehicle may
cause damage because of
reduced ground clearance.
Always put the vehicle on a
flatbed truck or trailer.
The vehicle was neither
designed nor intended to be
towed with any of its wheels
on the ground. If the vehicle
must be towed, see
Transporting a Disabled
Vehicle (Electronic Shifter)
0 450 or
Transporting a Disabled
Vehicle (Mechanical Shifter)
0 452.
Page 456 of 524

Cadillac CT4 Owner Manual (GMNA-Localizing-U.S./Canada-16500442) -
2023 - CRC - 5/4/22
Vehicle Care 455
Appearance Care
Exterior Care
Locks
Locks are lubricated at the
factory. Use a de-icing agent
only when necessary, and
have the locks greased after
using. See Recommended
Fluids and Lubricants0474.
Washing the Vehicle
To preserve the vehicle finish,
wash it often and out of direct
sunlight.
Caution
Do not use
petroleum-based, acidic,
or abrasive cleaning agents
as they can damage the
vehicle's paint, metal,
or plastic parts. If damage
occurs, it would not be
covered by the vehicle
warranty. Approved cleaning
products can be obtained
(Continued)
Caution (Continued)
from your dealer. Follow all
manufacturer directions
regarding correct product
usage, necessary safety
precautions, and
appropriate disposal of any
vehicle care product.
Caution
Avoid using high-pressure
washes closer than 30 cm
(12 in) to the surface of the
vehicle. Use of power
washers exceeding
8 274 kPa (1,200 psi) can
result in damage or removal
of paint and decals. Automatic Car Wash
Caution
Automatic car washes can
cause damage to the
vehicle, wheels, ground
effects, and convertible top
(if equipped).
Do not use automatic car
washes due to lack of
clearance for the
undercarriage, wide rear
tires, and wheels.
Caution
To avoid damage to a matte
paint finish, do not use an
automatic car wash
equipped with brushes or
scrubbers. Only use
touchless automatic car
washes.
If using an automatic car wash,
follow the car wash
instructions. The windshield
wiper and rear window wiper,
if equipped, must be off.