2023 BMW X2 light

tem reduces the speed to the set value, within
the physical limits.
Only use Hill Descent Control in low gears or in selector lever position D or R.
Overview Button in the vehicle
Hill Descent Control
Activate Hill Descent Control Press the button. The LED above the
button lights up.
Speeds between approx. 2 mph/3 km/h and approx. 20 mph/30 km/h are adopted as theset speed.
Display in the instrument cluster An icon and the selected desired
speed are displayed.

The indicator lights in the instrument clusterlight up and the mark in the speedometer is set
to the current speed.
Cruise control is active and maintains the set
speed.
If necessary, the Dynamic Stability Control will be turned on.
Turning off
To switch off the system while standing, step on brake pedal at the same time.
Press the button on the steering
wheel.
The displays turn off. The stored set speed is
deleted.
Interrupting manually Press the button on the steering
wheel.
If interrupting the system while stationary,
press on the brake pedal at the same time.
Interrupting automatically The system is automatically interrupted in thefollowing situations:

Press and hold this button.
The indicator light in the instrument cluster lights up.
To switch distance control back on, press but

Indicator/warning lightsWhen the hood is unlocked, a Check Control
message is displayed.
Closing the hood
Energetically close the hood from approx.
20 in/50 cm.
The hood must engage on both sides.
Seite 258MOBILITYEngine compartment258
Online Edition for Part no. 01405A540A1

Adding coolant1.Let the engine cool down.2.Open the hood.3.Turn the lid of the coolant reservoir slightly
counterclockwise to allow any excess pres

4.Attach a new wiper blade. The wiper blade
must engage audibly.5.Fold in the wiper arm.
Replacing the rear wiper blade
1.Lift the wiper up fully and detach the wiper blade, arrow.2.Position the new wiper blade and press it
on until it you hear it snap into place.3.Fold the wipers in.
Light and bulb replacement
General information
Lights and bulbs
Lights and bulbs make an essential contribu

Headlight glassThe inside of the headlight glass can fog up incool or humid weather. When driving with thelights switched on, the condensation evapo

Remove cover, arrow 2.3.Loosen both nuts, arrow 1, of the outer tail
light. Use the handle of the screwdriver from the onboard vehicle tool kit to loosen.
Carefully pull out the tail light from the body
toward the front, arrow 2. Ensure that the
wiring is not damaged.4.Detach the connector from the light bracket
and detach the tail light wiring.Replacing the bulbs1.Turn the light bracket counterclockwise and remove.2.Press the faulty bulb gently into the socket,turn counterclockwise and remove.3.Proceed in the reverse order to insert thenew bulb and attach the light bracket.
Installing the tail light
1.Connect the plug and hook the wiring onthe tail light, arrow 1.2.Place the tail light with the lugs, arrows 2,on the attachment points of the body and
push onto both of the threaded bolts.3.Press on the tail lights until flush and
tighten both of the nuts.4.Mount the cover. Make sure that the plastic tabs of the cover are correctly seated in the
corresponding recesses of the body.
Lights in the tailgate
General
Follow the safety information, refer to
page 268.
Seite 270MOBILITYReplacing components270
Online Edition for Part no. 01405A540A1