2022 YAMAHA YFM90R steering wheel

Operating the drive select lever and driving in reverse ....................................... 7-3
Engine break-in ........................................... 7-4
Parking ........................................................ 7-5
Parking on a slope ...................................... 7-5
Accessories and loading ............................. 7-6
RIDING YOUR ATV ........................................ 8-1 GETTING TO KNOW YOUR ATV ................ 8-2
RIDE WITH CARE AND GOOD JUDGMENT .............................................. 8-2
BE CAREFUL WHERE YOU RIDE ............... 8-9
TURNING YOUR ATV................................ 8-12
CLIMBING UPHILL ................................... 8-13
RIDING DOWNHILL .................................. 8-16
CROSSING A SLOPE................................ 8-17
CROSSING THROUGH SHALLOW WATER .................................................... 8-18
RIDING OVER ROUGH TERRAIN ............. 8-20
SLIDING AND SKIDDING .......................... 8-20
WHAT TO DO IF... ..................................... 8-21
PERIODIC MAINTENANCE AND
ADJUSTMENT................................................ 9-1 Owner’s Manual and tool kit ....................... 9-2
Periodic maintenance chart: Emission control system .......................................... 9-3 Periodic maintenance chart: General
maintenance and lubrication .................... 9-5
Checking the spark plug............................. 9-9
Engine oil .................................................. 9-10
Why Yamalube.......................................... 9-13
Transmission oil ........................................ 9-14
Cleaning the air filter element ................... 9-15
Cleaning the spark arrester ...................... 9-18
Adjusting the carburetor ........................... 9-19
Adjusting the engine idling speed ............ 9-19
Adjusting the throttle lever free play ......... 9-20
Valve clearance......................................... 9-21
Brakes....................................................... 9-21
Checking the front and rear brake shoes ...................................................... 9-21
Adjusting the front brake lever free play... 9-23
Adjusting the rear brake lever free play .... 9-24
Drive chain slack....................................... 9-25
Lubricating the drive chain ....................... 9-27
Checking and lubricating the cables ........ 9-28
Checking and lubricating the front and rear brake levers ..................................... 9-28
Checking the wheel hub bearings ............ 9-29
Lubricating the front arm pivots ............... 9-29
Lubricating the front knuckle pivots ......... 9-30
Lubricating the steering shaft ................... 9-30
Battery ...................................................... 9-31
UBD366E0.book Page 2 Thursday, June 10, 2021 2:39 PM

3-5
3
ungrounded or broken wiring. Visually check
for broken wiring and leaking fuel. Leaking
fuel can be confirmed by the odor of gasoline.
4. Once immediate safety hazards are con- firmed not to exist, you may remove your hel-
met to more closely inspect your vehicle.
Check for external signs of wear, broken
parts, fluid leaks, cracks in the frame, sus-
pension damage, wheel damage, and so on.
Fuel, oil, and coolant usually give off a notice-
able odor.
5. If your vehicle will not restart or if it is unsafe to ride, then turn off all vehicle systems (en-
gine stop switch, main switch, and fuel cock),
and then signal or go for help.
Aftermarket Parts, Accessories, and Modifica-
tions
While you may find aftermarket products similar in
design and quality to genuine Yamaha accesso-
ries, recognize that some aftermarket accessories
or modifications are not suitable because of po-
tential safety hazards to you or others. Installing
aftermarket products or having other modifica-
tions performed to your vehicle that change any of
the vehicle’s design or operation characteristics
can put you and others at greater risk of serious injury or death. You are responsible for injuries re-
lated to changes in the vehicle. Keep the following
guidelines in mind, as well as those found in the
Loading section (page 7-7) when mounting acces-
sories.

Never install accessories that would impair the
performance of your ATV. Carefully inspect the
accessory before using it to make sure that it
does not in any way reduce ground clearance,
limit suspension travel, steering travel or control
operation.
 Accessories fitted to the ATV can create insta-
bility due to improper weight distribution.
 Bulky or large accessories may seriously affect
the stability of the ATV.
 Certain accessories can displace the operator
from his or her normal riding position. This im-
proper position limits the freedom of movement
of the operator and may limit control ability,
therefore, such accessories are not recom-
mended.
 Use caution when adding electrical accesso-
ries. If electrical accessories exceed the capac-
ity of the ATV’s electrical system, an electric
failure could result, which could cause a dan-
UBD366E0.book Page 5 Thursday, June 10, 2021 2:39 PM

8-18
8

Never attempt to turn the ATV around on any
hill until you have mastered the turning tech-
nique as described in the Owner’s Manual on
level ground. Be very careful when turning
on any hill.
Traversing a sloping surface on your ATV requires
you to properly position your weight to maintain
proper balance. Be sure that you have learned the
basic riding skills on flat ground before attempting
to cross a sloping surface. Avoid slopes with slip-
pery surfaces or rough terrain that may upset your
balance.
As you travel across a slope, lean your body in the
uphill direction. It may be necessary to correct the
steering when riding on loose surfaces by pointing
the front wheels slightly uphill. When riding on
slopes, be sure not to make sharp turns either up
or down hill.
If your ATV does begin to tip over, gradually steer
in the downhill direction if there are no obstacles
in your path. As you regain proper balance, grad-
ually steer again in the direction you wish to travel. CROSSING THROUGH SHALLOW WATER
WARNING
EWB01642Operating this vehicle through deep or fast-
flowing water can lead to loss of control or an
overturn. To reduce your risk of drowning or
other injuries, use care when crossing through
water. Never operate this ATV water deeper
than the depth specified in your Owner’s Man-
ual, as tires may float, increasing the risk of an
overturn.
OK
UBD366E0.book Page 18 Thursday, June 10, 2021 2:39 PM

8-21
8To reduce the tendency for the front wheels to
slide in loose or slippery conditions, positioning
your weight over the front wheels will sometimes
help.
If the rear wheels of your ATV start to slide side-
ways, control can usually be regained (if there is
room to do so) by steering in the direction of the
slide. Applying the brakes or accelerating is not
recommended until you have corrected the slide.
With practice, over a period of time, skill at con-
trolled sliding can be developed. The terrain
should be chosen carefully before attempting
such maneuvers, since both stability and control
are reduced. Bear in mind that sliding maneuvers
should always be avoided on extremely slippery
surfaces such as ice, since all control may be lost.
WHAT TO DO IF...
This section is designed to be a reference guide
only. Be sure to read each section on riding tech-
niques completely.
UBD366E0.book Page 21 Thursday, June 10, 2021 2:39 PM

12-2
12
PParking ........................................................................... 7-5
Parking brake ................................................................. 5-5
Parking on a slope ......................................................... 7-5
Part locations ................................................................. 4-1RReverse indicator light ................................................... 5-1
Riding your ATV ............................................................. 8-1SSafety information .......................................................... 3-1
Seat .............................................................................. 5-13
Shock absorber, rear ...................................................5-15
Shock absorbers, front ................................................ 5-13
Spark arrester, cleaning ............................................... 9-18
Spark plug, checking .....................................................9-9
Specifications ............................................................... 11-1
Speed limiter .................................................................. 5-3
Starter (choke) .............................................................. 5-12
Start switch .................................................................... 5-2
Steering shaft, lubricating ............................................ 9-30
Storage ......................................................................... 10-2TThrottle lever .......................................................... 5-2, 6-3
Throttle lever free play, adjusting ................................. 9-20
Tires ............................................................................... 6-3
Transmission .................................................................. 6-3
Transmission oil ........................................................... 9-14
Troubleshooting ........................................................... 9-36
Troubleshooting chart .................................................. 9-37VValve clearance ............................................................ 9-21Vehicle identification number ......................................... 1-1
WWheel hub bearings, checking ..................................... 9-29
Wheel, installing ........................................................... 9-35
Wheel, removing .......................................................... 9-34YYamalube ..................................................................... 9-13
UBD366E0.book Page 2 Thursday, June 10, 2021 2:39 PM