2022 YAMAHA VX LIMITED HO ESP

Watercraft operation
35
EJU45930Cruise assist
The cruise assist is a function for maintaining
a desired engine speed within a fixed range
while operating the watercraft. Once the
cruise assist is activated, the set engine
speed can be increased or decreased. How-
ever, the adjustment is limited to a maximum
of five increments above or below the initial
cruise assist setting.
TIP
The cruise assist can only be set between en-
gine speeds of approximately 3000 r/min and
approximately 7000 r/min.
Activating and deactivating the cruise as-
sist
Activation of the cruise assist can be con-
firmed by the cruise assist indicator on the
multifunction information center.
To activate the cruise assist:
(1) Operate the throttle lever until the de-sired engine speed is reached.
(2) When the engine speed reaches the de- sired cruise assist setting, push the
“CRUISE/NO WAKE” switch. Once the
beeper sounds three times and the
cruise assist indicator is displayed, the
cruise assist is activated. (3) When the cruise assist is activated, slow-
ly squeeze the throttle lever to keep it
squeezed further than the position at
which the cruise assist was set.
TIP
Check the multifunction information center to
make sure that the cruise assist is activated
before squeezing the throttle lever to the full
throttle position. If the cruise assist is not ac-
tivated, the engine will respond normally to
the throttle operation.
(4) Once the cruise assist is activated, pushthe upper side of the “SPEED ADJUST”
switch to increase the set engine speed
or the lower side of the “SPEED AD-
JUST” switch to decrease the set engine
speed. The engine speed can be
changed in the range of the cruise assist
levels –5 to +5.
1Cruise assist indicator
2 Cruise assist level
14.3V
RPM
Cruise Assist +4
km/h
21
1“CRUISE/NO WAKE” switch
1
UF4S71E0.book Page 35 Wednesday, August 4, 2021 5:18 PM

Instrument operation
41
To select the display units:
Select “US Unit” or “Metric”, and then push
the “BACK” button of the touchpad control.
Selecting the display language (“Lan-
guage”)
The display language for the multifunction in-
formation center can be selected from the
following languages.
English
French
Spanish
To select the display language:
Select the desired language, and then push
the “OK” button of the touchpad control.
Displaying the time since the last mainte-
nance (“Wellness”)
The total number of hours that the engine has
been running since the last watercraft main-
tenance can be displayed.
To reset the number of hours of opera-
tion:
Select “Reset”.
Resetting the settings (“Reset”)
The settings can be reset to their factory de-
fault settings. The items that are reset and the
default settings are as follows.
Display units: US Unit
Language: English
Trip time: 0.0
Distance traveled: 0.0
Average fuel consumption per gallon or li-
ter: 0.0
Total fuel used: 0.0
To reset the settings:
Select “Reset”.EJU45190Engine lock screen “ ”
The engine lock screen shows the setting
screen for the Yamaha Security System in the
Unit
Metric
US Unit
Language
English
Français
Español
Wellness
Time Since Last Maintenance 0Hrs
Reset
Reset
Reset To Factory?
Reset
UF4S71E0.book Page 41 Wednesday, August 4, 2021 5:18 PM

Operation
74
steer without throttle. You may still have
some turning ability immediately after re-
leasing the throttle lever, but once the
engine slows down, the watercraft will no
longer respond to handlebar input until
you apply throttle again or you reach
trolling speed.
At trolling speed, the watercraft can be
turned gradually by handlebar position
alone using just the amount of thrust
available at idle.
D. If the engine is stopped while riding, there is no thrust. The watercraft will go
straight even though the handlebars are
turned.
You need throttle to steer.
E. If the RiDE lever is squeezed and the handlebars are turned when the water-
craft is cruising at planing speed, the wa- tercraft will turn gradually while slowing
down.
This model is equipped with the Yamaha En-
gine Management System (YEMS) that in-
cludes an off-throttle steering (OTS) system.
It will activate at planing speeds should you
attempt to steer the watercraft after releasing
the throttle lever (see condition C above).
The OTS system assists in turning by con-
tinuing to supply some thrust while the water-
craft is decelerating, but you can turn more
sharply if you apply throttle while turning the
handlebars. The OTS system does not func-
tion below planing speeds or when the en-
gine is off. Once the engine slows down, the
watercraft will no longer turn in response to
handlebar input until you apply throttle again
or you reach trolling speed.
EJU43253Stopping the watercraft
The watercraft is not equipped with a sepa-
rate braking system. The watercraft slows
down by water resistance or, when operating
in reverse, by the water jet. The watercraft
slows down as soon as the throttle lever is re-
leased, but will coast for a distance before
fully stopping. If you are not sure you can
stop in time before hitting an obstacle, apply
throttle and turn in another direction.
From full speed, the watercraft comes to a
complete stop due to water resistance in ap-
1 Reverse gate
E
1
UF4S71E0.book Page 74 Wednesday, August 4, 2021 5:18 PM

101
Index
A
Accessory outlet ...................................... 45
After removing the watercraft from the water ..................................................... 81
Audio control............................................ 44
Audio system (equipped models) ............ 44
B
Battery care.............................................. 83
Battery checks ......................................... 64
Battery, jumping....................................... 98
Beaching and docking the watercraft ...... 80
Bilge water check..................................... 64
Bilge water, draining ................................ 58
Bilge water, draining on land ................... 58
Bilge water, draining on water ................. 58
Boarding alone ......................................... 76
Boarding and starting off from a dock ..... 79
Boarding the watercraft ........................... 76
Boarding with passenger(s) ..................... 77
Bow eye ................................................... 49
Bow storage compartment ...................... 50
Builder’s plate ............................................ 3
C
Capsized watercraft ................................. 79
Cleaning ................................................... 85
Cleaning the watercraft ............................ 83
Cleat ......................................................... 49
Cooling water pilot outlet ......................... 26
Cooling water pilot outlet check .............. 68
Craft Identification Number (CIN)............... 1
Cruise assist............................................. 35
Cruising limitations................................... 10
D
Display ..................................................... 37
Drive control mode................................... 33
Drive control mode screen ....................... 40
E
Emergency procedures ............................ 97
Engine break-in ........................................ 60
Engine compartment check ..................... 63
Engine cover, removing and installing ..... 87
Engine idling speed check ....................... 69
Engine lock screen ................................... 41
Engine oil ................................................. 56
Engine oil and oil filter .............................. 91 Engine oil level check ............................... 64
Engine oil requirements ........................... 56
Engine serial number ................................. 1
Engine shut-off cord (lanyard) check ....... 65
Engine shut-off switch ............................. 25
Engine start/stop switch .......................... 25
Engine unit check ..................................... 64
Enjoy your watercraft responsibly ............ 18
Equipment ................................................ 47
F
Fire extinguisher check ............................ 67
Fire extinguisher holder and cover........... 53
Fire extinguisher holder, cover, and
band checks ......................................... 66
Flushing the cooling water passages....... 82
Fuel .......................................................... 54
Fuel level check........................................ 63
Fuel requirements .................................... 54
Fuel system checks ................................. 63
G
Getting to know your watercraft .............. 70
Glossary, watercraft ................................. 19
Glove compartment ................................. 51
H
Handgrip .................................................. 48
Hazard information................................... 14
Home screen ............................................ 39
Hood check .............................................. 68
Hull and deck check ................................ 67
I
Identification numbers ............................... 1
Information screen ................................... 39
J
Jet intake and impeller, cleaning.............. 97
Jet intake checks ..................................... 67
Jet thrust nozzle and reverse gate check .................................................... 67
Jumper cables, connecting ...................... 98
L
Labels, important ....................................... 4
Labels, other .............................................. 8
Labels, warning .......................................... 5
Launching the watercraft ......................... 71
Learning to operate your watercraft......... 70
Leaving the watercraft.............................. 72
UF4S71E0.book Page 101 Wednesday, August 4, 2021 5:18 PM