2022 TOYOTA YARIS ECU

53
1
HV Owner's Manual_Europe_M52N30_en
1-2. Child safety
For safety and security
Right-hand drive vehicles
*1: Move the front seat fully rearward. If
the passenger seat height can be
adjusted, move it to the upper most
position.
*2: Adjust the seatback angle to the
most upright position. When install-
ing a forward-facing child seat, if
there is a gap between the child seat
and the seatback, adjust the
seatback angle until good contact is
achieved.
*3: If the head restraint interferes with
your child restraint system, and the
head restraint can be removed,
remove the head restraint.
Otherwise, put the head restraint in
the upper most position.
*4: Deactivation of front passen-
ger airbag.
*5: Activation of front passenger
airbag. Never use a rear-facing child
restraint system on the front passen-
ger seat when the airbag manual on-
off switch is on.
*6: Not suitable for child restraint sys-
tems with support leg.
Suitable for “universal” category
child restraint system fixed with
the seat belt.
Suitable for forward-facing “Uni-
versal” category child restraints
system fixed with the seat belt.
Suitable for child restraint sys-
tems given on recommended
child restraint systems and
compatibility table ( P.56).
Suitable for i-Size and ISOFIX
child restraint system.
Includes a top tether anchorage
point.

55
1
HV Owner's Manual_Europe_M52N30_en
1-2. Child safety
For safety and security
1st lock position
12th lock position
ISOFIX child restraint systems are divided into different “fixt ure”. The child
restraint system can be used in the seating positions for “fixt ure” mentioned
in the table above. For kind of “ fixture” relation, confirm the following table.
If your child restraint system ha s no kind of “fixture” (or if you cannot find
information in the table below), please refer to the child rest raint system
“vehicle list” for compatibility information or ask the retaile r of your child
seat.
Mass
groupsChild weightSize classFixtureDescription
0up to 10 kg
(22 lb.)
ER1Rearward-facing infant seat
FL1Left lateral-facing infant seat
(Carrycot)
GL2Right lateral-facing infant seat
(Carrycot)
0+up to 13 kg
(28 lb.)
CR3Full-size, rearward-facing child
restraint systems
DR2Reduced-size, rearward-facing
child restraint systems
—R2XReduced-size, rearward-facing
child restraint systems
ER1Rearward-facing infant seat

57
1
HV Owner's Manual_Europe_M52N30_en
1-2. Child safety
For safety and security
*: Be sure to attach the seat belt through the SecureGuard.
Key of letters inserted in the above table:
U: Suitable position for recommended child restraint system of “Universal”
category
UF: Suitable position for recommended forward-facing child rest raint sys-
tem of “Universal” category
X: Not suitable position
The child restraint systems mentioned in the table may not be a vailable out-
side the EU area.
KIDFIX XP SICTII
15 to 25 kg
(34 to 55 lb.)
UUUXU
KIDFIX II S*UUUXU
MAXI PLUSUUUXU
KIDFIX XP SICTIII
22 to 36 kg
(48 to 79 lb.)
UUXXX
KIDFIX II S*UUXXX
MAXI PLUSUUUXU
Recommended Child
Restraint SystemMass groups
Seating position
Airbag man-
ual on-off
switch
ONOFF

58
HV Owner's Manual_Europe_M52N30_en
1-2. Child safety
Recommended child restraint system fixed with an ISOFIX lower anchor-
age
*: Be sure to attach the seat belt through the SecureGuard.
Key of letters inserted in the above table:
IUF: Suitable position for recommended ISOFIX forward-facing ch ild
restraint system of “Universal” category
IL: Suitable position for recommended ISOFIX forward-facing chi ld restraint
system of “Semi-universal” category
X: Not suitable position for recommended ISOFIX forward-facing child
restraint system
The child restraint systems mentioned in the table may not be a vailable out-
side the EU area.
Recommended Child
Restraint SystemMass groups
Seating position
Airbag man-
ual on-off
switch
ONOFF
G0+, BABY SAFE
PLUS
0, 0+
Up to 13 kg
(28 lb.)
XXXXX
DUO PLUS
I
9 to 18 kg
(20 to 39 lb.)
XXIUFXIUF
KIDFIX XP SICTII
15 to 25 kg
(34 to 55 lb.)
XXILXIL
KIDFIX II S*XXILXIL
MAXI PLUSXXILXIL
MAXI PLUS
III
22 to 36 kg
(48 to 79 lb.)
XXILXIL

59
1
HV Owner's Manual_Europe_M52N30_en
1-2. Child safety
For safety and security
i-Size child restraint system fixed with an ISOFIX lower anchorage
If your child restraint system is “i-Size” category, you can install it on the
positions mentioned by i-U in the table below.
Child restraint system category can be found in the restraint s ystem man-
ual.
Key of letters inserted in the above table:
i-U: Suitable position for i-Size child restraint system forwar d-facing and/or
rearward-facing
X: Not suitable position for i-Size child restraint system
When securing some types of child
restraint systems in rear seat, it
may not be possible to properly use
the seat belts in positions next to
the child restraint without interfering
with it or affecting seat belt effec-
tiveness. Be sure your seat belt fits
snugly across your shoulder and
low on your hips. If it does not, or if
it interferes with the child restraint,
move to a different position. Failure
to do so may result in death or seri-
ous injury.
 When installing a child restraint
in the rear seats, adjust the front
seat so that it does not interfere
with the child or child restraint
system.
 When installing a child seat with
support base, if the child seat
interferes with the seatback
when latching it into the support
base, adjust the seatback rear-
ward until there is no interfer-
ence.
 If the seat belt shoulder anchor is
ahead of the child seat belt
guide, move the seat cushion
forward.
Seating position
Airbag manual
on-off switch
ONOFF
i-Size Child Restraint SystemXXi-UXi-U

60
HV Owner's Manual_Europe_M52N30_en
1-2. Child safety
When installing a junior seat, if
the child in your child restraint
system is in a very upright posi-
tion, adjust the seatback angle to
the most comfortable position.
And if the seat belt shoulder
anchor is ahead of the child seat
belt guide, move the seat cush-
ion forward.
 When using the child restraint
system with SecureGuard, be
sure to guide the lap belt into
SecureGuard as shown in the
illustration.

61
1
HV Owner's Manual_Europe_M52N30_en
1-2. Child safety
For safety and security
Confirm with the operation manual enclosed with the child restraint system
about the installation of the child restraint system.
■Installing child restraint sys-
tem using a seat belt
Install the child restraint system in
accordance to the operation man-
ual enclosed with the child restraint
system.
If the child restraint system on hand
is not within the “universal” cate-
gory (or the necessary information
Child restraint system installation method
Installation methodPage
Seat belt attachmentP. 6 1
ISOFIX lower anchorage
attachmentP. 6 3
Top tether anchorage
attachmentP. 6 4
Child restraint system fixed
with a seat belt

62
HV Owner's Manual_Europe_M52N30_en
1-2. Child safety
is not in the table), refer to the
“Vehicle List” provided by the child
restraint system maker for various
possible installation positions, or
check the compatibility after asking
the retailer of the child seat.
( P.51, 52)
1 If installing the child restraint
system to the front passenger
seat is unavoidable, refer to
P.48 for the front passenger seat
adjustment.
2 If the head restraint interferes
with your child restraint system,
and the head restraint can be
removed, remove the head
restraint. Otherwise, put the
head restraint in the upper most
position. ( P.147)
3 Run the seat belt through the
child restraint system and insert
the plate into the buckle. Make
sure that the belt is not twisted.
Securely fix the seat belt to the
child restraint system in accor-
dance to the directions enclosed
with the child restraint system.
4 If your child restraint system is
not equipped with a lock-off (a
seat belt locking feature),
s e c u r e t h e c h i l d r e s t r a i n t s y s t e m
using a locking clip.
5 After installing the child restraint
system, rock it back and forth to
ensure that it is installed
securely. ( P. 6 3 )
■Removing a child restraint
system installed with a seat
belt
Press the buckle release button
and fully retract the seat belt.
When releasing the buckle, the child
restraint system may spring up due to
the rebound of the seat cushion.
Release the buckle while holding down
the child restraint system.
Since the seat belt automatically reels
itself, slowly return it to the stowing
position.
■When installing a child restraint system
You may need a locking clip to install the child restraint system. Follow the
instructions provided by the manufac- turer of the system. If your child restraint system does not provide a locking clip,
you can purchase the following item from any authorized Toyota retailer or Toyota authorized repairer, or any reli-
able repairer: Locking clip for child restraint system