Page 419 of 616
4196-3. Do-it-yourself maintenance
6
Maintenance and care
Engine compartment
2TR-FE engine
Washer fluid tank (P. 430)
Radiator cap
Engine coolant reservoir ( P. 423)
Engine oil filler cap ( P. 422)
Power steering fluid reservoir ( P. 426) Engine oil level dipstick
( P. 421)
Brake fluid reservoir ( P. 425)
Fuse box ( P. 454)
Battery ( P. 428)
Condenser ( P. 425)
Radiator ( P. 425)1
2
3
4
5
6
7
8
9
10
11 
     
        
        Page 420 of 616
4206-3. Do-it-yourself maintenance
2GR-FKS engine
Washer fluid tank (P. 430)
Power steering fluid reservoir ( P. 426)
Radiator cap
Engine oil level dipstick ( P. 421)
Engine coolant reservoir ( P. 423) Engine oil filler cap (
P. 422)
Brake fluid reservoir ( P. 425)
Fuse box ( P. 454)
Battery ( P. 428)
Condenser ( P. 425)
Radiator ( P. 425)1
2
3
4
5
6
7
8
9
10
11 
     
        
        Page 421 of 616
4216-3. Do-it-yourself maintenance
6
Maintenance and care
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
■Checking the engine oil
Park  the  vehicle  on  level  ground.  After  warming  up  the  engine
and  turning  it  off,  wait  more  than  5  minutes  for  the  oil  to  dra in
back into the bottom of the engine.
Holding a rag under the end, pull the dipstick out.
Wipe the dipstick clean.
Reinsert the dipstick fully.
Holding  a  rag  under  the  end,
pull  the  dipstick  out  and
check the oil level.
Low
Normal
Excessive
The  shape  of  the  dipstick
may  differ  depending  on  the
type of vehicle or engine.
Wipe the dipstick and reinsert it fully.
Engine oil
1
2
2TR-FE engine2GR-FKS engine
3
4
5
1
2
3
6 
     
        
        Page 422 of 616

4226-3. Do-it-yourself maintenance
■Adding engine oil
If the oil level is below or near the low level mark, add engine oil of
the same type as that a lready in the engine.
Make  sure  to  check  the  oil  type  and  prepare  the  items  needed
before adding oil. Remove the oil fille r cap by turning it counterclockwise.
Add engine oil slowly,  checking the dipstick.
Install the oil filler cap  by turning it clockwise.
■Engine oil consumption
A certain amount of engine oil will be consumed while driving.  In the following
situations,  oil  consumption  may  increase,  and  engine  oil  may  ne ed  to  be
refilled in between oil maintenance intervals.
● When the engine is new, for example directly after purchasing t he vehicle or
after replacing the engine
● If low quality oil or oil of an inappropriate viscosity is used
● When  driving  at  high  engine  speeds  or  with  a  heavy  load,  when  t owing,  or
when driving while accelerating or decelerating frequently
● When  leaving  the  engine  idling  for  a  long  time,  or  when  driving   frequently
through heavy traffic
2TR-FE engine2GR-FKS engine
Engine oil selection P. 545
Oil quantity
(Low  Full) 1.6 qt. (1.5 L, 1.3 Imp.qt.)
Items
Clean funnel
1
2
3 
     
        
        Page 423 of 616

4236-3. Do-it-yourself maintenance
6
Maintenance and care
The coolant level is satisfactory if it is between the “FULL” a nd “LOW”
lines on the reservoir when the engine is cold.
Reservoir cap
“FULL” line
“LOW” line
If  the  level  is  on  or  below  the
“LOW”  line,  add  coolant  up  to
the “FULL” line. ( P. 534)
WARNING
■Used engine oil
● Used  engine  oil  contains  potentially  harmful  contaminants  which   may
cause  skin  disorders  such  as  inflammation  and  skin  cancer,  so  care
should be taken to avoid prolonged and repeated contact. To remove used
engine oil from your skin, wash thoroughly with soap and water.
● Dispose  of  used  oil  and  filters  only  in  a  safe  and  acceptable  manner.  Do
not dispose of used oil and filters in household trash, in sewers or onto the
ground. 
Call  your Toyota  dealer,  service  station  or  auto  parts  store  fo r information
concerning recycling or disposal.
● Do not leave used engine oil within the reach of children.
NOTICE
■To prevent serious engine damage
Check the oil level on a regular basis.
■ When replacing the engine oil
● Be careful not to spill engine oil on the vehicle components.
● Avoid overfilling, or the engine could be damaged.
● Check the oil level on the dipstick every time you refill the vehicle.
● Be sure the engine oil filler cap is properly tightened.
Engine coolant
1
2
3 
     
        
        Page 545 of 616
5458-1. Specifications
8
Vehicle specifications
*: The engine oil  capacity is a reference  quantity to be  used when changing
the engine oil. Warm up and turn off the engine, wait more than 5 minutes,
and check the oil level on the dipstick.
■
Engine oil selection
“Toyota  Genuine  Motor  Oil”  is  us ed  in  your  Toyota  vehicle.  Use
Toyota approved “Toyota Genuine Motor Oil” or equivalent to sat -
isfy the following grade and viscosity.
Oil grade: ILSAC GF-6A multigrade engine oil
Recommended viscosity: SAE 0W-20
SAE  0W-20  is  the  best  choice
for  good  fuel  economy  and
good starting in cold weather.
If  SAE  0W-20  is  not  available,
SAE  5W-20  oil  may  be  used.
However,  it  must  be  replaced
with  SAE  0W-20  at  the  next  oil
change.
Lubrication system
Oil capacity
(Drain and refill—reference
*)With filterWithout filter
2TR-FE engine6.2 qt. 
(5.9 L, 5.2 Imp.qt.)
5.8 qt. 
(5.5 L, 4.8 Imp.qt.)
2GR-FKS engine5.9 qt. 
(5.6 L, 4.9 Imp.qt.)
Outside temperature