2022 TOYOTA GR86 light

721-3. Emergency assistance
WA R N I N G
• During an Emergency Call, the sys-
tem makes repeated attempts to
connect to the PSAP. However, if it cannot connect to the PSAP due to
poor radio wave reception, the sys-
tem may not be able to connect to the cellular network and the call
may finish without connecting. The
red indicator light will blink for
approximately 5 seconds to indicate this disconnection.
●If the battery’s voltage decreases or there is a disconnection, the system
may not be able to connect to the
PSAP.
■When the Emergency Call sys-
tem is replaced with a new one
The Emergency Call system should
be registered. Contact any authorized
Toyota retailer or Toyota authorized repairer, or any reliable repairer.
■For your safety
●Please drive safely.
The function of this system is to
assist you in making the Emer- gency Call in case of accidents
such as traffic accidents or sudden
medical emergencies, and it does not protect the driver or passengers
in any way. Please drive safely and
fasten your seatbelts at all times for your safety.
●In case of an emergency, make lives the top priority.
●If you smell anything burning or other unusual smells, leave the
vehicle and evacuate to a safe area
immediately.
●If the airbag deploys when the sys-
tem is operating normally, the sys- tem makes an emergency call.
Even if the airbag has not deployed,
the system may also make an emergency call when the vehicle is
hit from behind.
●For safety, do not make the Emer- gency Call while driving.
Making calls during driving may
cause mishandling of the steering wheel, which may lead to unex-
pected accidents.
Stop the vehicle and confirm the safety of your surroundings before
making the Emergency Call.
●When changing fuses, please use
the specified fuses. Using other
fuses may cause ignition or smoke in the circuit and lead to a fire.
●Using the system while there is smoke or an unusual smell may
cause a fire. Stop using the system
immediately and consult any authorized Toyota retailer or Toyota
authorized repairer, or any reliable
repairer.
NOTICE
■To prevent damage
Do not pour any liquids onto the
“SOS” button panel, etc. and do not
impact it.
■If the “SOS” button panel,
speaker or microphone malfunc- tions during an Emergency Call
or manual maintenance check
It may not be possible to make Emer- gency Calls, confirm the system sta-
tus, or communicate with the
emergency operator. If any of the above equipment is damaged, please
consult any authorized Toyota retailer
or Toyota authorized repairer, or any reliable repairer.

73
1
1-3. Emergency assistance
For safety and security
Implementing Regulation
Implementing Regulation Annex1 PART3 User InformationConformity
1. DESCRIPTION OF THE ECALL IN-VEHICLE SYSTEM
1.1.Overview of the 112-based eCall in-vehicle sys-
tem, its operation and functionalitiesO
1.2.
The 112-based eCall service is a public service
of general interest and is accessible free of
charge.
O
1.3.
The 112-based eCall in-vehicle system is acti-
vated by default. It is activated automatically by
means of in-vehicle sensors in the event of a
severe accident. It will also be triggered automat-
ically when the vehicle is equipped with a TPS
system which does not function in the event of a
severe accident.
O
1.4.
The 112-based eCall in-vehicle system can also
be triggered manually, if needed. Instructions for
manual activation of the system
O
1.5.
In the event of a critical system failure that would
disable the 112-based eCall in-vehicle system,
the following warning will be given to the occu-
pants of the vehicle:
Red indicator light will illuminate
O
2. INFORMATION ON DATA PROCESSING

75
1
1-3. Emergency assistance
For safety and security
2.3. Types of data and its recipients
2.3.1.
The 112-based eCall in-v ehicle system may col-
lect and process only the following data: Vehicle
Identification Number, Vehicle type (passenger
vehicle or light commercia l vehicle), Vehicle pro-
pulsion storage type (gasoline/die-
sel/CNG/LPG/electric/hydr ogen), Vehicle last
three locations and direction of travel, Log file of
the automatic activation of the system and its
timestamp
O
2.3.2.
Recipients of data processed by the 112-based
eCall in-vehicle system are the relevant public
safety answering points designated by the
respective public authorities of the country on
which territory they are located, to first receive
and handle eCalls to the single European emer-
gency number 112.
O
Implementing Regulation Annex1 PART3 User InformationConformity

79
1
1-4. Theft deterrent system
For safety and security
1-4.Theft deterrent system
The indicator light flashes after the
engine switch has been turned off
to indicate that the system is oper-
ating.
The indicator light stops flashing
after the engine switch has been
turned to ACC or ON to indicate
that the system has been canceled.
■System maintenance
The vehicle has a maintenance-free
type engine immobilizer system.
■Conditions that may cause the sys-
tem to malfunction
●If the grip portion of the key is in con-
tact with a metallic object
●If the key is in close proximity to or
touching a key registered to the secu- rity system (key with a built-in
transponder chip) of another vehicle
Engine immobilizer sys-
tem
The vehicle’s keys have
built-in transponder chips that
prevent the engine from start-
ing if a key has not been previ-
ously registered in the
vehicle’s on-board computer.
Never leave the keys inside the
vehicle when you leave the
vehicle.
This system is designed to
help prevent vehicle theft but
does not guarantee absolute
security against all vehicle
thefts.
Operating the system
NOTICE
■To ensure the system operates
correctly
Do not modify or remove the system.
If modified or removed, the proper
operation of the system cannot be guaranteed.

81
1
1-4. Theft deterrent system
For safety and security
*: If equipped
■Items to check before locking
the vehicle
To prevent unexpected triggering of
the alarm and vehicle theft, make
sure of the following:
 Nobody is in the vehicle.
 The windows are closed before
the alarm is set.
 No valuables or other personal
items are left in the vehicle.
■Setting
Close the doors and trunk, and lock
both side doors using the entry
function or wireless remote control.
The system will se t automatically
after 30 seconds.
The indicator light changes from being
on to flashing when the system is set.
■Canceling or stopping
Do one of the following to deacti-
vate or stop the alarms:
 Unlock the doors or open the
trunk using the entry function or
wireless remote control.
 Turn the engine switch to ACC or
ON, or start the engine.
1 Check that both side doors and
the trunk are closed.
2 Turn the engine switch to ON.
3 Open the driver’s door while
pressing and holding on the
door lock switch and continue to
press for approximately 10
seconds after the driver’s door
has opened.
The alarm system changes between
Alarm*
The alarm uses light and
sound to give an alert when an
intrusion is detected.
The alarm is triggered when a
locked door or the trunk is
unlocked or opened in any way
other than using the entry
function or wireless remote
control while the alarm is set.
Setting/canceling/stopping
the alarm system
Activating/deactivating the
alarm system

2
83
2
Vehicle status information and indicators
Vehicle status information
and indicators
.2-1. Instrument cluster
Warning lights and indicators
......................................... 84
Gauges and meters ............ 88
Multi-information display ..... 92

842-1. Instrument cluster
2-1.Instrument cluster
For the purpose of explanation, the following illustrations display all warning
lights and indicators illuminated.
Warning lights inform the driver of
malfunctions in the indicated vehi-
cle systems.
War ning lights and indicators
The warning lights and indicators on the instrument cluster and
overhead console inform the driver of the status of the vehicle’s var-
ious systems.
Warning lights and indicators displayed on the instrument
cluster
Warning lights
(red)
Brake system warning light*1
( P.336)
(yellow)
Vacuum pressure system
warning light*1 ( P.336)
(red)
High coolant temperature
warning light*1 ( P.336)
Charging system warning
light*1 ( P.337)
Low engine oil pressure
warning light*1 ( P.337)
Malfunction indicator lamp*1
( P.337)
SRS warning light*1 ( P. 5 3 ,
P.337)
ABS warning light*1 ( P.338)
Electric power steering sys-
tem warning light*1 ( P.338)
Slip indicator*1 ( P.338)

85
2
2-1. Instrument cluster
Vehicle status information and indicators
*1: These lights turn on when the engine
switch is turned to ON to indicate
that a system check is being per-
formed. They will turn off after the
engine is started, or after a few sec-
onds. There may be a malfunction in
a system if a light does not come on,
or turn off. Have the vehicle
inspected by any authorized Toyota
retailer or Toyota authorized repairer,
or any reliable repairer.
*2: The front passenger’s seat belt
reminder light is located on the over-
head console.
*3: This light illuminates on the over-
head console.
The indicators inform the driver of
the operating state of the vehicle’s
various systems.
Automatic transmission fluid
temperature warning light (if
equipped) ( P.339)
Open door warning light
( P.339)
Low fuel level warning light*1
( P.339)
Driver’s and front passen-
ger’s seat belt reminder
light*1, 2 ( P.339)
Rear passengers’ seat belt
reminder lights*1, 3 ( P.340)
(yellow)
Conventional Cruise Control
indicator (if equipped)
( P.340)
BSD/RCTA warning light (if
equipped) ( P.340)
SRH warning light (if
equipped) ( P.340)
RAB warning light (if
equipped) ( P.341)
LED headlight warning light
( P.341)
Automatic headlight leveling
system warning light
( P.341)
Master warning light*1
( P.341)
EyeSight warning light (if
equipped) ( P.341)
Tire pressure warning light*1
( P.342)
GPF system warning light
( P.342)
WA R N I N G
■If a safety system warning light
does not come on
Should a safety syst em light such as the ABS and SRS warning light not
come on when you start the engine,
this could mean that these systems are not available to help protect you in
an accident, which could result in
death or serious injury. Have the vehi- cle inspected by your Toyota dealer
immediately if this occurs.
Indicators
Turn signal indicator
( P.150)
Tail light indicator ( P.153)
Headlight high beam indica-
tor ( P.154)
High beam assist indicator (if
equipped) ( P.156)
Rear fog light indicator
( P.159)
EyeSight temporary stop indi-
cator (if equipped) ( P.223)