2022 SUZUKI JIMNY full

FOR SAFE DRIVING
If your child restraint system has no size class (or if you cannot find information in the following table), refer to the child restraint system suitability information for the vehicle or ask the retailer of your child seat.
Mass group Size class
F
0 G (upto 10kg)
E
E
O+ D (up to 13kg)
C
D
C
I B (9kg to 18kg)
B1
A
II X (15kg to 25kg)
Ill X (22kg to 36kg)
Key of letters to be inserted in the above table X; There is no fixture for this mass group.
Fixture Description
L1 Left Lateral facing position Child Restraint Systems (carry-cot)
L2 Right Lateral facing position Child Restraint Systems (carry-cot)
R1 Rear-facing seat
R1 Rear-facing seat
R2 Reduced-Size rear-facing toddler Child Restraint Systems
R3 Full-Size rear-facing toddler Child Restraint Systems
R2 Reduced-Size rear-facing toddler Child Restraint Systems
R3 Full-Size rear-facing toddler Child Restraint Systems
F2 Reduced-Height front-facing toddler Child Restraint Systems
F2X Reduced-Height front-facing toddler Child Restraint Systems
F3 Full-Height front-facing toddler Child Restraint Systems
X -
X -
1-26

FOR SAFE DRIVING
68LM268
2) Use your hands to carefully align the connecting bar tips with the anchor­ages. Take care not to pinch your fin­gers.
1-31
54G184
3) Push the child restraint toward the anchor­ages so that the connecting bar tips are partially hooked to the anchorages. Use your hands to confirm the position.
54G185
4) Grasp the front of the child restraint and push the child restraint forcefully to latch the connecting bars. Check that they are securely latched by trying to move the child restraint system in all directions, especially forward. 5) Attach the top tether strap referring to "Installation of child restraint with top tether" section. When you put your child in the child restraint system, appropriately slide the front seat forward not to touch a part of your child's body.
NOTICE
When installing a child restraint sys­tem to the rear seat, adjust the front seat position so that the front seat does not interfere with the child restraint system.

FOR SAFE DRIVING
NOTICE
When installing a child restraint sys­tem to the rear seat, adjust the front seat position so that the front seat does not interfere with the child restraint system.
NOTE: For Australian models, refer to "For Austra­lia" in the "SUPPLEMENT" section.
1-33
Seat belt pretensioner system
A WARNING
This section describes your SUZUKI vehicle's seat belt pretensioner sys­tem. Read and follow all these instructions carefully to minimize your risk of severe injury or death.
To determine if your vehicle is equipped with a seat belt pretensioner system at the front or rear seating positions, check the label on the seat belt at the bottom part. If the letters "p" and/or "PRE" appear as illus­trated, your vehicle is equipped with the seat belt pretensioner system. You can use the pretensioner seat belts in the same manner as ordinary seat belts. Read this section and "Supplemental restraint system (airbags)" section to learn more about the pretensioner system.
The seat belt pretensioner system works with the supplemental restraint system (air­bags). The crash sensors and the elec­tronic controller of the airbag system also control the seat belt pretensioners. The pretensioners are triggered only when there is a frontal or side collision severe enough to trigger the airbags and the seat belts are fastened. For precautions and general information including servicing the pretensioner system, refer to "Supplemen­tal restraint system (airbags)" section in addition to this "Seat belt pretensioner sys­tem" section, and follow all those precau­tions.

The pretensioner is located in each front seat belt retractor and each rear seat belt retractor in outboard seating position. The pretensioner tightens the seat belt so the belt fits the occupant's body more snugly in the event of a frontal or side collision. The retractors will remain locked after the pre­tensioners are activated. Upon activation, some noise will occur and some smoke may be released. These conditions are not harmful and do not indicate a fire in the vehicle.
The driver and all passengers must be properly restrained by fastening seat belts at all times, whether or not a pretensioner is equipped at their seating position, to minimize the risk of severe injury or death in the event of a collision.
Sit fully back in the seat; sit up straight; do not lean forward or sideways. Adjust the belt so the lap portion of the belt is worn low across the pelvis, not across the waist. Please refer to "Seat adjustment" section and the instructions and precautions about the seat belts in this "Seat belts and child restraint systems" section for details on proper seat and seat belt adjustments.
Please note that the pretensioners along with the airbags will activate in severe fron­tal or side collisions. They are not designed to activate in rear impacts, roll­overs, or minor frontal side collisions. The pretensioners can be activated only once. If the pretensioners are activated (that is, if the airbags are activated), have the pre­tensioner system serviced by a SUZUKI dealer as soon as possible.
FOR SAFE DRIVING
If AIRBAG light on the instrument cluster does not blink or come on briefiy when the ignition switch is turned to "ON" position, stays on for more than 1 O seconds, or comes on while driving, the pretensioner system or the airbag system may not work properly. Have both systems inspected by a SUZUKI dealer as soon as possible.
Service on or around the pretensioner sys­tem components or wiring must be per­formed only by a SUZUKI dealer who is specially trained. Improper service could result in unintended activation of preten­sioners or could render the pretensioner inoperative. Either of these two conditions may result in personal injury.
To prevent damage or unintended activa­tion of the pretensioners, check that the lead-acid battery is disconnected and the ignition switch has been in "LOCK" position for at least 90 seconds before performing any electrical service work on your SUZUKI vehicle.
Do not touch pretensioner system compo­nents or wiring. The wires are wrapped with yellow tape or yellow tubing, and the couplers are yellow. When scrapping your SUZUKI vehicle, ask a SUZUKI dealer, body repair shop, or scrap yard for assis­tance.
1-34

FOR SAFE DRIVING
Supplemental restraint
system (airbags)
,A. WARNING
This section describes the protection provided by your SUZUKI vehicle's supplemental restraint system (air­bags). Read and follow all instruc­tions carefully to minimize your risk of severe injury or death in the event of a collision.
Your vehicle is equipped with a supple­mental restraint system consisting of the following components in addition to a lap­shoulder belt at each seating position.
(1) Forward crash sensor (2) Side crash sensor (if equipped) (3) Driver's front airbag module (4) Side curtain airbag module (if equipped) (5) Front passenger's front airbag module (6) Side airbag module (if equipped) (7) Front seat belt pretensioners (if equipped) (8) Rear seat belt pretensioners (if equipped) (9) Airbag controller
1-35
2 3
9 6 7
4 5 2 4 6 8
' ., : I!,..---._ -----': ~ /~~wcil',,.--··---.~:r
1_;· v-;
2 8 7 2
78RB02022

80J125
Impact from the side by a motorcycle or
bicycle
80J126
Collision with a utility pole or stumpage
FOR SAFE DRIVING
Side airbags and side curtain airbags do not inflate How the system works
80J120
• Impact from the rear
80J110
• Vehicle rollover
In a frontal collision, the crash sensors will detect rapid deceleration, and if the con­troller judges that the deceleration rep­resents a severe frontal collision, the controller will trigger the infiators. If your vehicle is equipped with side airbags and side curtain airbags, crash sensors will detect a side collision, and if the controller judges that the side collision is severe enough, it will trigger the side airbag and side curtain airbag infiators. The infiators inflate the appropriate airbags with nitro­gen or argon gas. The infiated airbags pro­vide a cushion for your head (front airbags and side curtain airbags only) and upper body. The airbag inflates and defiates so quickly that you may not even realize that it has activated. The airbag will neither hin­der your view nor make it harder to exit the vehicle.
Airbags must infiate quickly and forcefully in order to reduce the chance of serious or fatal injuries. However, an unavoidable consequence of the quick infiation is that the airbag may irritate bare skin, such as the facial area against a front airbag. Wash off any residue as soon as possible to pre­vent skin irritation. Also, upon inflation, a loud noise will occur and some powder and smoke will be released. These condi­tions are not harmful and do not indicate a fire in the vehicle. Be aware, however, that some airbag components may be hot for a while after infiation.
1-44

FOR SAFE DRIVING
A seat belt helps keep you in the proper po_sition for maximum protection when an airbag infiates. Adjust your seat as far back as possible while still maintaining control of the vehicle. Sit fully back in your seat; sit up straight; do not lean over the steering wheel or dashboard. Front occu­pants should not lean on or sleep against the door. Refer to "Seat adjustment" sec­tion and "Seat belts and child restraint sys­tems" section in this section for details on proper seat and seat belt adjustments.
1-45
A WARNING
• The driver should not lean over the steering wheel. The front passen­ger should not rest his or her body against the dashboard, or other­wise get too close to the dash­board. For vehicles with side airbags and side curtain airbag, occupants should not lean on or sleep against the door. In these sit­uations, the out-of-position occu­pant would be too close to an inflating airbag, and may suffer severe injury. • Do not attach any objects to, or place any objects over, the steering wheel or dashboard. Do not place any objects between the airbag and the driver or front passenger. These objects may interfere with airbag operation or may be pro­pelled by the airbag in the event of a collision. Also, these objects may move when you start moving vehi­cle or while vehicle is moving, they may interfere with driver's view or safe driving. In each conditions may cause severe injury. (Continued)

BEFORE DRIVING
Electric window controls
(if equipped)
The electric windows can only be operated when the ignition switch is in "ON" position.
(1)
The center console has a switch (1) to operate the driver's window, and a switch (2) to operate the front passenger's win­dow.
2-11
OPEN CLOSE
78RB02007
To open a window, push the switch. To close the window, lift up the switch.
The driver's window has AUTO-DOWN and AUTO-UP (if equipped) features for greater convenience (at toll booths or drive-through restaurants, for example). These features allow the driver to open or close the window without holding the win­dow switch in DOWN or UP position. Press down or lift up the driver's window switch completely and release it. To stop the win­dow before it reaches the FULL-DOWN or FULL-UP position, pull up or push down the switch briefly.
A WARNING
• You should always prevent chil­dren from operating the electric window switches when there are children in the vehicle. Children can be seriously injured if they get part of their body caught by the window during operation. To avoid injuring an occupant by window entrapment, check that no part of the occupant's body such as hands or head is in the path of the electric windows when closing them. Always remove the ignition key when leaving the vehicle even only for a short time. Also do not leave children alone in a parked vehicle. Unattended children could use the electric window switches and get trapped by the window.