2022 MAZDA MODEL MX-5 MIATA RF light

[x] Cancel search: light

Page 410 of 503

MAZDA MODEL MX-5 MIATA RF 2022  Owners Manual ▼Ve r i f y  D i s p l a y  C o n t e n t
Displays in the following cases:
Display
Indicated Condition/Action to be taken
The following message is displayed when the temperature around the
center di

Page 411 of 503

MAZDA MODEL MX-5 MIATA RF 2022  Owners Manual Warning Sound isActivated
▼Lights-On Reminder
The lights-on reminder is operable when
the time setting
*1 of the auto headlight off
function is off.
If lights are on and the ignition is switched
to

Page 412 of 503

MAZDA MODEL MX-5 MIATA RF 2022  Owners Manual NOTE
To allow the passenger occupant
classification sensor to function
properly, do not place and sit on an
additional seat cushion on the
passengers seat. The sensor may not
function properly bec

Page 413 of 503

MAZDA MODEL MX-5 MIATA RF 2022  Owners Manual Vehicles without advanced keyless
function
If the key is taken out of the vehicle while
the ignition is not switched OFF and all
the doors are closed, a beep will be heard
in the cabin 6 times.
NOTE
B

Page 414 of 503

MAZDA MODEL MX-5 MIATA RF 2022  Owners Manual NOTE
A personalized function is available to
change the Blind Spot Monitoring (BSM)
warning beep sound volume.
Refer to the Settings section in the Mazda
Connect Owners Manual.
Reversing
The Blind Sp

Page 417 of 503

MAZDA MODEL MX-5 MIATA RF 2022  Owners Manual 4. Switch the ignition OFF.
5. Remove the fasteners on the right sideof the vehicle.
 
6. Push the stopper rubber through thecover on the right side of the vehicle
while slightly lifti ng the cover up

Page 419 of 503

MAZDA MODEL MX-5 MIATA RF 2022  Owners Manual 4. Push the stopper rubber through thecover on the right side of the vehicle
while slightly lifti ng the cover up.
 
Cover
Stopper Rubber 
5. Lift up the cover from the outside of the vehicle.
 
6. In

Page 421 of 503

MAZDA MODEL MX-5 MIATA RF 2022  Owners Manual CAUTION
Do not drive the vehicle with the roof partia lly open. The vehicle operation may be affected
by the wind and could result in an accident.
 Do not perform the procedure in a strong wind