2022 MAZDA MODEL MX-30 EV battery

Sunvisors
▼Sunvisors
Lower the sunvisor to block sunlight
from the front.
To block sunlight from the side, lower
and unhook the sunvisor, and then
swing it to the side.
▼Side Extension Sunvisors
The visor extender extends the
sunvisor's range of sun shading.
To use, pull it out.
CAUTION
When moving the sunvisor, retract the
visor extender to its original position.
Otherwise, the visor extender could hit
the rearview mirror.
▼Va n i t y M i r ro rs
The vanity mirror is on the backside of
the sunvisor.
If your vehicle is equipped with a
vanity mirror light, it will illuminate
when you open the cover.
The vanity mirror will only illuminate in
the tilt range shown in the figure.

1. Vanity mirror light
2. On
3.
Off

NOTE
If a vanity mirror light is left on with the
power switch switched OFF, the light is
turned o ff automatically to prevent the
lead-acid battery from being
discharged.

The vanity mirror light can be turned
on again by doing any of the following
operations:
Opening/closing any door.Unlocking any door.Switching the power switch to ACC
or ON.
Switching an overhead light/front
map light on.
Interior Features
Interior Equipment
5-36
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Interior Lights
▼Interior Lights
NOTE
Do not leave the lights on for long
periods while the EV system is
stopped. Otherwise the lead-acid
battery power could be depleted.
Overhead lights
Front
1. Indicator light

Switch
Overhead Lights
ON/OFFPress the switch to turn it on.
Press the switch again to turn o
ff
the lights.
Switch Overhead Lights
DOOR OFFThe door interlock can be switch-
ed ON/OFF.
When the door interlock is OFF,
the indicator light in the switch
turns on.

Door interlock ON (indicator
light in switch is o
ff)The lights turn on when any of
the doors is opened.
The lights turn on/o ff in con-
junction with the illuminated
entry system.

Rear
(Vehicles without rear map lights)
(Vehicles with rear map lights)

NOTE
The rear overhead light also turn on
and off when the front overhead light
switch is operated.
Interior Features
Interior Equipment
5-37
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Map lights
Front
Press the switch to illuminate the front
map lights, and then press the switch
again to turn them off.
NOTE
The front map lights will not turn o ff
even if the switch is pressed in the
following cases:
The overhead lights turn on by
operating the overhead light
ON/OFF switch (
).The overhead lights turn on in
conjunction with a door opening/
closing.
The illuminated entry system is on.
Rear
*
When the overhead light ON/OFF
switch (
) is o ff, press the switch to
illuminate the rear map lights, and
then press the switch again to turn
them o ff.
NOTE
Once the rear map lights have been
turned o ff, they will turn on and o ff
in conjunction with the overhead
light operation.
The rear map lights will not turn off
even if the switch is pressed in the
following cases:
The overhead lights turn on by
operating the overhead light
ON/OFF switch (
).The overhead lights turn on in
conjunction with a door opening/
closing.
The illuminated entry system is on.
Luggage compartment light
The luggage compartment light is on
when the liftgate is open and off when
it is closed.
NOTE
Do not leave the liftgate open for long
periods while the EV system is
stopped. Otherwise the lead-acid
battery power could be depleted.
▼ Illuminated Entry System
The overhead lights turn on when any
of the following operations is done
with the overhead light switch in the
DOOR position.
The driver's door is unlocked with
the power switch switched OFF.
Interior Features
Interior Equipment
5-38*Some models.
MX
-30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

The power switch is switched OFF
with all doors closed.
NOTE
The illumination time differs
depending on the operation.
The vehicle is equipped with a
battery saver. If an interior light is left
on with the power switch switched
OFF, the light turns o ff automatically
after a certain period of time has
passed to prevent lead-acid battery
depletion.
The operation of the illuminated
entry system can be changed.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
The illuminated entry system does
not operate in conjunction with the
overhead lights when the overhead
lights are turned on using the
overhead light ON/OFF switch.
Accessory Sockets
▼ Accessory Sockets
Only use genuine Mazda accessories
or the equivalent requiring no greater
than 120 W (DC 12 V, 10 A).
The power switch must be switched to
ACC or ON.

Connecting the accessory socket
1. Open the lid.
2. Pass the connection plug cord
through the cutout of the console
and insert the plug into the
accessory socket.
1. Plug

CAUTION
 To prevent accessory socket damage
or electrical failure, pay attention to
the following:
 Do not use accessories that require
more than 120 W (DC 12 V, 10 A).
Interior Features
Interior Equipment
5-39
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Do not use accessories that are not
genuine Mazda accessories or the
equivalent.
 Close the cover when the
accessory socket is not in use to
prevent foreign objects and liquids
from getting into the accessory
socket.
 Correctly insert the plug into the
accessory socket.
 Do not insert the cigarette lighter
into the accessory socket.
 Noise may occur on the audio
playback depending on the device
connected to the accessory socket.
 Depending on the device connected
to the accessory socket, the vehicle's
electrical system may be aff ected,
which could cause the warning light
to illuminate. Disconnect the
connected device and make sure
that the problem is resolved. If the
problem is resolved, disconnect the
device from the socket and switch
the power switch o ff. If the problem
is not resolved, consult an
Authorized Mazda Dealer.
NOTE
To prevent the lead-acid battery from
depleting, do not use the socket for
long periods with the EV system
stopped.
AC Power Outlet*
▼ AC Power Outlet
The AC power outlet can be used as a
socket for accessories when the power
switch is switched to ACC or ON.
Only use AC 120 V/60 Hz accessories
that have a maximum power
consumption of 150 W or below.
WARNING
Never use medical instruments with
the power outlet:
Otherwise, the operation of the
medical device might be
aff ected.
Heed the following cautions when
using the AC power supply to prevent
electrical shock, smoking, or
combustion.
 Be careful with the AC power outlet
and plug during and after use.
 Because an electrical appliance
could operate at the moment it is
plugged in, check the safety before
plugging it in.
 Do not plug accessories into the
power outlet or unplug them with
wet hands.
 Be careful not to allow liquid to
penetrate the AC power outlet.
 Do not put anything other than plugs
into the AC power outlet.
 Do not disassemble the AC power
outlet.
 Do not use the AC power outlet if it
is damaged. If part replacement or
repair is required, consult an
Authorized Mazda Dealer.

Interior Features
Interior Equipment
5-40*Some models.
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

CAUTION
Always close the cover when it is not
in use. If foreign matter or liquid
penetrates the AC power outlet, it
may cause a problem.
 Insert electrical appliance plugs into
the AC power outlet securely. If the
plug is not inserted securely, it may
heat excessively and blow a fuse.
 Do not connect multiple electrical
appliances to the AC power outlet.
Otherwise, it could cause smoking or
combustion.
 Do not use electrical appliances that
exceed the prescribed power
capacity. Otherwise, it could cause a
malfunction.
NOTE
To prevent the lead-acid battery from
depleting , do not use the socket for
long periods with the EV system
stopped.

How to connect
1. Open the lid.
2. Connect the plug to the AC power
outlet.
1. Plug

NOTE
Use electrical appliances only in the
cabin. If they are us ed outside of the
vehicle cabin, they may not operate
correctly due to noise.
The following electrical appliances
may not operate even if their
electrical capacity is 150 W or lower.
Appliances requiring large
amounts of power for activation
(such as refrigerators with a
compressor, electrical pumps, and
electrical tools)
Appliances with a power supply
frequency switch function (such as
clocks and audio)
Appliances for precise data
processing (such as measurement
equipment)
Electrical appliances other than the
above may not be used.
When using an electrical appliance
for data processing such as a
personal computer, back up the data
frequently.
The protection function operates and
the AC power outlet cannot be used
in the following cases:
Battery power is weakAppliances with a capacity of 150
W or higher are used
Interior Features
Interior Equipment
5-41
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

6Maintenance and Care
How to keep your Mazda in top condition.
Essential Information................. 6-2 Introduction.......................... 6-2
Scheduled Maintenance............ 6-4 Scheduled Maintenance......... 6-4
Owner Maintenance................. 6-7 Owner Maintenance
Precautions........................... 6-7
Hood.................................... 6-8
Motor Compartment
Overview............................ 6-10
Coolant.............................. 6-11
Brake Fluid.......................... 6-12
Washer Fluid....................... 6-13
Lubrication system............... 6-14
Wiper Blades....................... 6-14
Lead-acid Battery................. 6-19
Key Battery Replacement...... 6-21
Tires.................................... 6-23
Light Bulbs...........................6-26
Fuses.................................. 6-27
Appearance Care.................... 6-34 Exterior Care....................... 6-34
Interior Care........................ 6-40
6-1
MX-30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Mazda workmanship, will not be
honored.

Any auto repair shop using parts
equivalent to your Mazda's original
equipment may perform maintenance.
But we recommend that it always be
done by an Authorized Mazda Dealer
using genuine Mazda parts.
Selecting “Vehicle Status Monitor”
enables the system to notify you of
your vehicle's approaching inspection/
servicing period. Refer to the
Information section in the Mazda
Connect Owner's Manual.

The malfunction diagnosis connector is
designed exclusively for connecting the
specially designed device to perform
on-board diagnosis.
Do not connect any devices other than
the specially designed malfunction
diagnosis devices for servicing. If any
device other than the malfunction
diagnosis device is connected, it may
aff ect the vehicle's electrical devices or
lead to damage such as lead-acid
battery depletion.
1. Malfunction diagnosis connector
Maintenance and Care
Essential Information
6-3
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07