2022 MAZDA MODEL MX-30 EV ev system

3. Mid
4. Low
NOTE
When the , is swiped upward,
the temperature changes to high.
When it is swiped downward, the
seat warmer changes to OFF.
The seat warmer does not operate
when the EV system is stopped even
if the
or is touched or swiped.
When the
is touched or swiped,
the setting screen of the seat warmer
can be displayed.
When each icon for the setting screen
is touched or swiped, the temperature
level can also be changed on the
setting screen.
When the
is touched or swiped, the
setting screen can be closed.
1. Setting screen
NOTE
If the EV system is stopped while the
seat warmer is operating in manual
mode, the seat warmer does not turn
on automatically the next time the EV
system is started. To turn the seat
warmer on, touch or swipe the icon
again.

Auto mode
The seat warmer can be operated in
conjunction with auto mode for the
climate control system.
Auto mode operates when auto mode
is enabled in the Mazda Connect
settings.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
Press the AUTO switch to select auto
mode.
While operating in auto mode, the
is displayed. The (white) for
the driver's seat/front passenger's seat
is displayed individually on the settings
screen.
The seat temperature is automatically
controlled at 4 levels (High, Mid, Low,
and OFF) according to the conditions
in the cabin.
NOTE
When auto mode is enabled using
Mazda Connect and auto mode is
not operating, the
(gray) is
displayed on the setting screen of the
seat warmer.
If the front passenger’s seat belt is
fastened, the front passenger’s seat
warmer turns on.
Essential Safety Equipment
Seat Warmer/Heated Steering Wheel
2-22
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

If the or is operated during
auto mode, the seat warmer on the
side where the icon was operated
switches to manual mode. To return
to auto mode, press the AUTO
switch.
If the power switch is switched OFF
while the seat warmer is operating in
auto mode, the seat warmer
operates in auto mode again the
next time the EV system is started.
Heated Steering Wheel*
▼ Heated Steering Wheel
The grips on the left and right of the
steering wheel can be warmed up
when the power switch is switched
ON.
1. Heated position
WARNING
The following types of persons should
be careful not to touch the steering
wheel. Otherwise, it could cause a
low-temperature burn.

Infants, small children, elderly
people, and physically challenged
people
 People with delicate skin
 People who are excessively fatigued
 People who are intoxicated
 Pe o pl e w h o have ta ke n
sleep-inducing medicine such as
sleeping pills or cold medicine
NOTE
The steering warmer cannot be used
while charging the vehicle.
Essential Safety Equipment
Seat Warmer/Heated Steering Wheel
*Some models.2-23
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

The steering warmer can be operated
in the operation screen of the climate
control system.
1. AUTO switch
2. Steering warmer icon
3. Steering warmer setting icon
The steering warmer has manual mode
and auto mode.
Manual mode
When the is touched or swiped
upward, the steering warmer operates
for about 30 minutes, and then
automatically turns o ff.
To turn the steering warmer o ff
manually, touch the
again or swipe
it downward.

When the
is touched or swiped
downward, the setting screen of the
steering warmer can be displayed.
When each icon for the setting screen
is touched or swiped, the steering
warmer can also be switched on/o ff
on the setting screen.
When the is touched or swiped, the
setting screen can be closed.
1. Setting screen
Auto mode
The steering warmer can be operated
in conjunction with auto mode for the
climate control system.
Auto mode operates when auto mode
is enabled in the Mazda Connect
settings.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
Press the AUTO switch to select auto
mode.
While in auto mode, the
is
displayed.
The
(white) is displayed on the
settings screen.
The steering warmer automatically
operates/turns o ff according to the
conditions in the cabin.
Essential Safety Equipment
Seat Warmer/Heated Steering Wheel
2-24
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Seat Belt Precautions
▼Seat Belt Precautions
Seat belts help to decrease the
possibility of severe injury during
accidents and sudden stops. Mazda
recommends that the driver and all
passengers always wear seat belts.

All the seats have lap/shoulder belts.
These belts have retractors with inertia
locks that keep them out of the way
when not in use. The locks allow the
belts to remain comfortable on users,
but they will lock in position during a
collision.

However, the front passenger's seat
and all rear lap/shoulder belt
retractors operate in two modes:
emergency locking mode, and for
child-restraint systems, automatic
locking mode. While we recommend
you put all children in the rear seats, if
you must use the front passenger seat
for a child, slide the front passenger
seat as far back as possible and make
sure any child-restraint system is
secured properly.
WARNING
Always wear your seat belt and make
sure all occupants are properly
restrained:
Not wearing a seat belt is extremely
dangerous. During a collision,
occupants not wearing seat belts could
hit someone or things inside the
vehicle or even be thrown out of the
vehicle. They could be seriously injured
or even killed. In the same collision,
occupants wearing seat belts would be
much safer.
Do not wear twisted seat belts:
Twisted seat belts are dangerous. In a
collision, the full width of the belt is
not available to absorb the impact.
This puts more force on the bones
beneath the belt, which could cause
serious injury or death. So, if your seat
belt is twisted, you must straighten the
seat belt to remove any twists and to
allow the full width of the belt to be
used.
Never use one seat belt on more than
one person at a time:
Using one seat belt for more than one
person at a time is dangerous. A seat
belt used in this way cannot spread the
impact forces properly and the two
passengers could be crushed together
and seriously injured or even killed.
Never use one belt for more than one
person at a time and always operate
the vehicle with each occupant
properly restrained.
Do not operate a vehicle with a
damaged seat belt:
Using a damaged seat belt is
dangerous. An accident could damage
the belt webbing of the seat belt in
use. A damaged seat belt cannot
provide adequate protection in a
collision. Have an Authorized Mazda
Dealer inspect all seat belt systems in
use during an accident before they are
used again.
Essential Safety Equipment
Seat Belt Systems
2-26
MX
-30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Have your seat belts changed
immediately if the pretensioner or
load limiter has been expended:
Always have an Authorized Mazda
Dealer immediately inspect the seat
belt pretensioners and air bags after
any collision. Like the air bags, the seat
belt pretensioners and load limiters
will only function once and must be
replaced after any collision that caused
them to deploy. A seat belt with an
expended pretensioner or load limiter
is still better than wearing no seat belt
at all; however, if the seat belt
pretensioners and load limiters are not
replaced, the risk of injury in a collision
will increase.
Positioning the Shoulder Portion of
the Seat Belt:
Improper positioning of the shoulder
portion of the seat belt is dangerous.
Always make sure the shoulder portion
of the seat belt is positioned across
your shoulder and near your neck, but
never under your arm, on your neck, or
on your upper arm.
Do not use a front seat belt while
seated in a rear seat:
Using a front seat belt, which is stored
in the rear door, is dangerous as the
seat belt cannot function at its full
capacity during sudden braking or in a
collision, which could result in serious,
injury or death. In addition, using the
seat belt in this manner could damage
the rear seat belt buckle.
Positioning the Lap Portion of the Seat
Belt:The lap portion of the seat belt worn
too high is dangerous. In a collision,
this would concentrate the impact
force directly on the abdominal area,
causing serious injury. Wear the lap
portion of the belt snugly and as low as
possible.

In a rollover crash, an unbelted person
is significantly more likely to die than a
person wearing a seat belt.

CAUTION
Belt retraction may become di fficult if
the belts and rings are soiled, so try to
keep them clean. For more details
about cleaning the seat belts, refer to
"Seat Belt Maintenance" (page
6-40).

1. Ring

▼ Pregnant Women and Persons with
Serious Medical Conditions
Pregnant women should always wear
seat belts. Ask your doctor for specifi
c
recommendations.
The lap belt should be worn SNUGLY
AND AS LOW AS POSSIBLE OVER THE
HIPS.
The shoulder belt should be worn
across your shoulder properly, but
never across the stomach area.
Essential Safety Equipment
Seat Belt Systems
2-27
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Persons with serious medical
conditions also should wear seat belts.
Check with your doctor for any special
instructions regarding specific medical
conditions.
▼ Emergency Locking Mode
When the seat belt is fastened, it will
always be in the emergency locking
mode.
In the emergency locking mode, the
belt remains comfortable on the
occupant and the retractor will lock in
position during a collision.
If the belt is locked and cannot be
pulled out, retract the belt once, and
then try pulling it out slowly. If this
fails, pull the belt strongly 1 time and
loosen, then pull it out again slowly.
(Seat Belt with Automatic Locking
Mode)
When the seat belt is fastened, it will
always be in the emergency locking
mode until it is switched to automatic
locking mode by pulling it all the way
out to its full length. If the belt feels
tight and hinders comfortable
movement while the vehicle is stopped
or in motion, it may be in the
automatic locking mode because the
belt has been pulled too far out. To
return the belt to the more
comfortable emergency locking mode,
wait until the vehicle has stopped in a
safe, level area, retract the belt fully to
convert it back to emergency locking
mode and then extend it around you
again.
▼
Automatic Locking Mode
Always use the automatic locking
mode to keep the child-restraint
system from shifting to an unsafe
position in the event of an accident. To
enable seat belt automatic locking
mode, pull it all the way out and
connect it as instructed on the
child-restraint system. It will retract
down to the child-restraint system and
stay locked on it. See the section on
child restraint (page 2-42).
Essential Safety Equipment
Seat Belt Systems
2-28
MX
-30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Seat Belt
▼Fastening the Seat Belt
Insert the seat belt tongue into the
buckle.
1. Seat belt tongue
2. Seat belt buckle

Position the lap belt as low as possible,
not on the abdominal area, then adjust
the shoulder belt so that it
fits snugly
against your body.
1. Keep low on hip bone
2. Take up slack
3. Too high

Before fastening the rear seat belt,
make sure that the seat belt passes
through the seat belt guide correctly
and it is not twisted.
▼ Unfastening the Seat Belt
Depress the button on the seat belt
buckle. If the belt does not fully retract,
pull it out and check for kinks or twists.
Then make sure it remains untwisted as
it retracts.
1. Button
NOTE
If a belt does not fully retract, inspect it
for kinks and twists. If it is still not
retracting properly, have it inspected at
an Authorized Mazda Dealer.
▼Front Shoulder Belt Adjuster
The front seat belts have a front
shoulder belt adjuster. If the seat belt
contacts your neck or it slips o
ff the
shoulder, adjust the seat belt height.
Essential Safety Equipment
Seat Belt Systems
2-29
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

To ra i s e
To heighten the seat belt, slide the
front shoulder belt adjuster upward.
To l o w e r
To lower the seat belt, slide the front
shoulder belt adjuster downward with
the adjuster lever pulled.

After adjusting , press the front
shoulder belt adjuster downward and
make sure that it is securely locked.
Seat Belt WarningSystems
▼Seat Belt Warning Systems
If it detects that the occupant seat belt
is unfastened, the warning light or
beep alerts the occupant.
Refer to Seat Belt Warning Indication/
Warning Light (Front seat) on page
7-29.
Refer to Seat Belt Warning Light (Rear
seat) (Red) on page 7-30.
Refer to Seat Belt Warning Beep on
page 7-37.

Seat belt indicator light (rear seat)
(green)
The light turns on when the rear seat
belt is fastened while the power switch
is switched ON, and it turns o
ff after a
certain period.
Essential Safety Equipment
Seat Belt Systems
2-30
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07