2022 LUCID AIR belt

Child Safety
Guidelines for Seating Children
All child restraint systems are designed to be
secured by lap belts or the lap belt portion of
the lap-shoulder belt.
WARNING: Do not use a child
restraint on a seat with an operational
airbag in front of it. There is a risk
of death or serious injury when the
airbag deploys. Crash statistics show
that children are safest when properly
restrained in a child or infant restraint
system that is secured in a rear seating position.WARNING: Do not use a forward-
facing child seat until the child using
it is above the minimum weight of 20
lb (9 kg) and able to sit up unaided.
Up to the age of two years, a child

Weight GroupRear Outer
SeatRear Center
SeatGroup II33-55 lb
(15-25 kg)U, UF-Group III48-76 lb
(22-36 kg)U, UF-
U: Universal belt rearward child restraint
system
UF: Universal belt forward child restraint
system
Weight GroupFront
Passenger
SeatRear
Outer
SeatRear
Center
SeatGroup
0Under 22 lb
(10 kg)-IL-Group
0+Under 29 lb
(13 kg)-IL-Group I20-40 lb
(9-18 kg)-IL-Group
II33-55 lb
(15-25 kg)-IL,
IUF-Group
III48-76 lb
(22-36 kg)-IL,
IUF-
IL: Any semi-universal LATCH/ISOFIX child
restraint system
IUF: Any universal LATCH/ISOFIX child
restraint system
Seating Larger Children
WARNING: Make sure the booster
seat or vehicle seat properly supports
the child

different recommended seating location
or ano
ther child safety seat.
5. If the child seat has an upper tether provided, fit and tighten the upper tether
correctly. See Attaching Upper Tether
Straps. WARNING: When the combined
w

eight of the child plus the child
restraint is more than 64 lb (29 kg),
you should not use the lower LATCH/
ISOFIX anchors with the child seats or
booster seats that have an integrated
safety belt. Use the seat belt instead.
Installing Seat Belt Retained Child Seats First, make sure that the child falls into the
corr

ect weight range for the child seat being
used. See Choosing a Child Safety Seat on
page 41.
The following is a general procedure for
installing a seat belt retained child restraint.
You should always read and follow the
instructions provided by the manufacturer of
the child safety seat you are installing. 1. Place the child safety seat in the vehicle
seat and fully e
xtend the seat belt to
engage the ALR. See Automatic Locking
Retractor (ALR). Route the seat belt to
secure the child safety seat and secure
the buckle following the manufacturer

Airbag Safety InformationWARNING: Even with airbags, the
driver and occupants must always
wear their seat belts to minimize the
risk of severe injury or death in the
event of a collision.WARNING: Do not attach or place
objects on or near the front airbags,
the side of the front seats, the
headliner at the side of the vehicle, or
any other location that could interfere
with the inflation of an airbag. Objects
can cause serious injury if the vehicle
is in a collision severe enough to
cause the airbag to deploy.WARNING: For the curtain airbags
to deploy correctly, the roof lining
and A )post trim must be undamaged
and installed correctly. Any damage
or suspect installation should be
referred to a Lucid Service Center for
inspection.WARNING: Front-seat occupants
should not place any part of their
arms, body against the steering wheel
or dashboard area, as an inflating
airbag can cause fractures or other injuries.WARNING: Do not use seat covers
in the vehicle. A seat cover could
interfere with the deployment of the
seat-mounted side airbags in the
event of a collision.WARNING: Airbags inflate with
considerable speed and force. To
reduce the risk of injuries, ensure that
all occupants are wearing seat belts
and are correctly seated, with seats
positioned as far back from any front
airbags as possible.WARNING: Never use a child safety
seat or seat young children on a seat
with an operational airbag in front of
it. Doing so can cause serious injury
or death if the airbag deploys.WARNING: To ensure correct inflation
of the side airbags, maintain
an unobstructed gap between an
occupant

Front passenger seat OCS precautionsWARNING: Failure to observe the following precautions regarding the front passenger OCS
may cause death or serious injury.
- Wear the seat belt properly. See Wearing Seat Belts on page 37.
- Make sure the front passenger

Parking brake fault detected
Door open or ajarSeat belt not fastenedSystem warningSystem alertDriver

Multi-Point Inspection
Your vehicle should be given a full multi-point
inspection service every 12 months or 12,000
miles (19300 km), whichever comes first.
Note: A message displays on the Cockpit
Panel to remind you to service your vehicle.
This service includes inspections and checks
for the following systems:
-Steering alignment
- Battery (12V) condition
- Battery pack (HV) condition
- Coolant condition
- Brake
fluid condition
- Brake rotors and pads wear
- Chassis bolts torque
- Closures (doors, hood, and trunk)
operation
- Condenser (check for debris)
- Electronic parking brake operation
- Heating, ventilation, and air conditioning
operation
- Horn
- Interior and exterior lights
- Key fob operation
- Seat belts operation
- Tire pressure and tire wear
- Visual signs of fluid leaks
- Wipers and washers
- Charging system and charging cable
- Firmware
Your vehicle will also be given a road test to inspect its current driving condition (such
as pedal operation, vehicle handling, and
steering alignment) and to check for any abnormal operational noises.WARNING: Your vehicle is equipped
with two 12V batteries. It

CAUTION: Do not use statically-
charged materials (such as a cloth
that was recently machine-washed
and dried) on the displays.CAUTION: Do not use cleansers (such
as glass cleaner) to clean displays.
Display screens should only be cleaned using
a soft, lint-free cloth designed for cleaning
screens and monitors.
Before cleaning the display screens, use the
Pilot Panel to enable screen cleaning mode
to prevent accidental operation of vehicle
controls. Select
> Displays > Displays
& Accessibility > SCREEN CLEANING MODE.
Airbags
WARNING: Airbag covers should only
be cleaned using a slightly dampened
cloth or cleaning wipe. Water or any
other liquid entering into an airbag
or its associated electrical wiring may
cause the airbags to deploy or not
function properly in an accident.WARNING: Any damage or cracks on
an airbag cover should be referred to a
Lucid Service Center for inspection.
Seats
WARNING: Never use steam or
upholstery cleaners on the seats,
or any cleaning method that would
saturate the seat with liquid. This can
damage the occupancy weight sensor
in the seat, which in turn can affect
the operation of the airbag system and
result in serious injury or death.
For cloth seats:
-If necessary, gently vacuum the seats
first to remove any loose dust, dirt, or
debris.
- Use a soft, colorless cloth moistened
with warm water and (if necessary) non- detergent soap. Wipe gently in a circular
motion. Allow the seats to air dry after
cleaning.
For leather and artificial leather seats:
-To clean, use a soft, colorless cloth
moistened only with warm water. Do
not use polishes, oils, cleaning fluids,
solvents, or detergents.
- Avoid vacuuming. Instead, use your
moistened cleaning cloth to gently
remove any loose particles.
- Application of a leather conditioner is
not necessary to maintain the original
condition of the seats.
Seat beltsWARNING: Never allow any substance
to enter a seat belt mechanism,
as this can negatively affect its
performance in an impact.
Extend the seat belt and clean using a cloth
moistened only with water. Do not use any
type of detergent or chemical cleaning agent.
Allow the belts to air dry while extended, away
from direct sunlight if possible.
Chrome and metal surfaces
Do not use abrasive cleansers, rough cloths,
or polish, as these materials can damage the
finish of these surfaces.
Plastic materials
WARNING: Do not use polish or wax
cleaner on the upper surfaces of the dashboard. Polished surfaces are
reflective and may interfere with the
driver