2022 LINCOLN NAUTILUS engine

[x] Cancel search: engine

Page 314 of 586

LINCOLN NAUTILUS 2022  Owners Manual REDUCED ENGINE PERFORMANCE
WARNING: If you continue to driveyour vehicle when the engine isoverheating, the engine could stop withoutwarning. Failure to follow this instructioncould result in the loss

Page 315 of 586

LINCOLN NAUTILUS 2022  Owners Manual •Do not add unnecessary accessories tothe exterior of your vehicle, for examplerunning boards. If you use a roof rack,remember to fold it down or remove itwhen not in use.
•Do not shift into neutr

Page 316 of 586

LINCOLN NAUTILUS 2022  Owners Manual Note:Driving through deep water couldcause damage to the transmission. If thefront or rear axle is submerged in water,have the axle lubricant and power transferunit lubricant checked and changed ifnec

Page 317 of 586

LINCOLN NAUTILUS 2022  Owners Manual Note:Do not rock your vehicle if the engineis not at normal operating temperature, asdamage to the transmission could occur.
Note:Do not rock your vehicle for more thana minute, as damage to the trans

Page 321 of 586

LINCOLN NAUTILUS 2022  Owners Manual WARNING: Keep batteries out ofreach of children. Batteries contain sulfuricacid. Avoid contact with skin, eyes orclothing. Shield your eyes when workingnear the battery to protect against possiblespla

Page 322 of 586

LINCOLN NAUTILUS 2022  Owners Manual 2.Connect the other end of the positive (+)jumper cable to the positive (+) terminalof the booster vehicle battery.
3.Connect the negative (-) jumper cable tothe negative (-) terminal of the boosterve

Page 323 of 586

LINCOLN NAUTILUS 2022  Owners Manual POST-CRASH ALERT SYSTEMLIMITATIONS
Depending on applicable laws in the countryyour vehicle was built for, the horn does notsound in the event of a serious impact.
SWITCHING THE POST-CRASH ALERTSYSTEM

Page 328 of 586

LINCOLN NAUTILUS 2022  Owners Manual Accessing the Under Hood Fuse Box -Bottom
1.Release the latches on both sides of thefuse box.
2.Raise the inboard side of the fuse boxfrom the cradle.
3.Move the fuse box toward the center ofthe engin