2022 LEXUS ES300h door lock

3286-3. Do-it-yourself maintenance
The 12-volt battery is located on the
right-hand side of the trunk.
QBefore recharging
When recharging, the 12-volt battery pro-
duces hydrogen gas which is flammable
and explosive. Therefore, observe the fol-
lowing precautions before recharging:
OIf recharging with the 12-volt battery
installed on the vehicle, be sure to dis-
connect the ground cable.
OMake sure the power switch on the char-
ger is off when connecting and discon-
necting the charger cables to the 12-volt
battery.
QAfter recharging/reconnecting the 12-
volt battery
OThe hybrid system may not start.
Follow the procedure below to initialize the
system.
1 Shift the shift lever to P.
2 Open and close any of the doors.
3 Restart the hybrid system.
OUnlocking the doors using the smart
access system with push-button start may
not be possible immediately after recon-
necting the 12-volt battery. If this hap-
pens, use the wireless remote control or
the mechanical key to lock/unlock the
doors.
OStart the hybrid system with the power
switch in ACCESSORY mode. The
NOTICE
QDo not use any fluid other than
washer fluid
Do not use soapy water or engine anti-
freeze instead of washer fluid.
Doing so may cause streaking on the
vehicle’s painted surfaces, as well as
damaging the pump leading to problems
of the washer fluid not spraying.
QDiluting washer fluid
Dilute washer fluid with water as neces-
sary.
Refer to the freezing temperatures listed
on the label of the washer fluid bottle.
12-volt battery
Location

3897-2. Steps to take in an emergency
7
When trouble arises
QWhen the electronic key does not work
properly
OMake sure that the smart access system
with push-button start has not been deac-
tivated using the Remote Touch or at
your Lexus dealer. If it is off, turn the func-
tion on.
OCheck if battery-saving mode is set. If it is
set, cancel the function. (P.117)
Use the mechanical key ( P.102) in
order to perform the following opera-
tions:
QUnlocking the door
1 Pull the driver’s door handle and
insert the mechanical key.
2 Unlock the door.
3 Remove the key, return the handle,
and then pull the handle again.
QLocking the door
1 With the door open, push down the
inside lock button.
2 Close the door.
QOpening the trunk
Turn the mechanical key clockwise to
If the electronic key does not
operate properly
If communication between the
electronic key and vehicle is inter-
rupted ( P.117) or the electronic
key cannot be used because the
battery is depleted, the smart
access system with push-button
start and wireless remote control
cannot be used. In such cases, the
doors and trunk can be opened and
the hybrid system can be started by
following the procedure below.
NOTICE
QIn case of a smart access system with
push-button start malfunction or
other key-related problems
Take your vehicle with all the electronic
keys provided with your vehicle (includ-
ing the card key) to your Lexus dealer as
soon as possible.
Locking and unlocking the
doors, opening the trunk and
using the key linked functions

3917-2. Steps to take in an emergency
7
When trouble arises
QAlarm (for Canada)
Using the mechanical key to lock the doors
will not set the alarm system.
If a door is unlocked using the mechanical
key when the alarm system is set, the alarm
may be triggered.
QChanging power switch modes
Release the brake pedal and press the
power switch in step 3 above.
The hybrid system does not start and modes
will be changed each time the switch is
pressed. ( P.151)
If you have a set of jumper (or booster)
cables and a second vehicle with a 12-
volt battery, you can jump start your
vehicle using the following procedure.
1 Confirm that the electronic key is
being carried.
When connecting the jumper (or booster)
cables, depending on the situation, the
alarm may activate and doors locked.
( P.69)
2 Open the hood ( P.321) and
open the fuse box cover.
If the 12-volt battery is dis-
charged
The following procedures may be
used to start the hybrid system if the
12-volt battery is discharged.
You can also call your Lexus dealer
or a qualified repair shop.
Restarting the hybrid system

3937-2. Steps to take in an emergency
7
When trouble arises
6Open and close any of the doors of
your vehicle with the power switch
off.
7 Maintain the engine speed of the
second vehicle and start the hybrid
system of your vehicle by turning
the power switch to ON mode.
8 Make sure the “READY” indicator
comes on. If the indicator does not
come on, contact your Lexus
dealer.
9 Once the vehicle’s hybrid system
has started, remove the jumper
cables in the exact reverse order
from which they were connected.
10 Close the exclusive jump starting
terminal cover, and reinstall the
fuse box cover to its original posi-
tion.
Once the hybrid system starts, have the
vehicle inspected at your Lexus dealer as
soon as possible.
QStarting the hybrid system when the 12-
volt battery is discharged
The hybrid system cannot be started by
push-starting.
QTo prevent 12-volt battery discharge
OTurn off the headlights and the audio sys-
tem while the hybrid system is stopped.
OTurn off any unnecessary electrical com-
ponents when the vehicle is running at a
low speed for an extended period, such
as in heavy traffic.
QWhen the 12-volt battery is removed or
discharged
OInformation stored in the ECU is cleared.
When the 12-volt battery is depleted,
have the vehicle inspected at your Lexus
dealer.
OSome systems may require initialization.
(  P.433)
QWhen removing the 12-volt battery ter-
minals
When the 12-volt battery terminals are
removed, the information stored in the
ECU is cleared. Before removing the 12-
volt battery terminals, contact your Lexus
dealer.
QCharging the 12-volt battery
The electricity stored in the 12-volt battery
will discharge gradually even when the
vehicle is not in use, due to natural dis-
charge and the draining effects of certain
electrical appliances. If the vehicle is left for
a long time, the 12-volt battery may dis-
charge, and the hybrid system may be
unable to start. (The 12-volt battery
recharges automatically while the hybrid
system is operating.)
QWhen recharging or replacing the 12-
volt battery
OIn some cases, it may not be possible to
unlock the doors using the smart access
system with push-button start when the
12-volt battery is discharged. Use the
wireless remote control or the mechani-
cal key to lock or unlock the doors.
OThe hybrid system may not start on the
first attempt after the 12-volt battery has
recharged but will start normally after the
second attempt. This is not a malfunction.
OThe power switch mode is memorized by
the vehicle. When the 12-volt battery is
reconnected, the system will return to the
mode it was in before the 12-volt battery
was discharged. Before disconnecting
the 12-volt battery, turn the power switch
off.
If you are unsure what mode the power
switch was in before the 12-volt battery
discharged, be especially careful when
reconnecting the 12-volt battery.
QWhen replacing the 12-volt battery
OUse a 12-volt battery that conforms to
European regulations.
OUse a 12-volt battery that the case size is
same as the previous one (LN2), 20 hour
rate capacity (20HR) is equivalent
(60Ah) or greater, and performance rat-
ing (CCA) is equivalent (563A) or
greater.

4238-2. Customization
8
Vehicle specifications
*1: For details about each function: P.89
*2: The default setting varies according to country.
*3:Except F SPORT models
*4:F SPORT models
QHead-up Display* ( P.91)
*: If equipped
QDoor lock ( P.104, 108, 389)
Suggestion functionOn
On (when the vehi-
cle is stopped)
OO
Off
FunctionDefault settingCustomized set- ting
Gauge informationHybrid System IndicatorTachometerONo content
Route guidance to destina-
tion/street name
*OnOffO
Driving support system displayOnOffO
Compass*OnOffO
Audio system operation statusOnOffO
FunctionDefault settingCustomized set- ting
Unlocking using a mechanical
key
Driver’s door
unlocked in one step, all doors
unlocked in two step
All doors unlocked in one stepO
Automatic door locking func-
tionShift lever linked
door locking oper- ationOff
OOSpeed linked door locking operation
Function*1Default settingCustomized set- tingABC
ABC
ABC

4248-2. Customization
QRear seat reminder (P.106)
QSmart access system with push-button start and wireless remote control
( P.104, 115)
QSmart access system with push-button start ( P.104, 115)
Automatic door unlocking
functionShift lever linked
door unlocking operation
Off
OODriver’s door linked door
unlocking opera- tion
Locking/unlocking of the trunk
when all doors are
locked/unlocked
OnOffO
FunctionDefault settingCustomized set-ting
Rear seat reminder functionOnOffO
FunctionDefault settingCustomized set-ting
Operating signal (Buzzers)5OffOO1 to 7
Operation signal (Emergency
flashers)OnOffOO
Time elapsed before automatic
door lock function is activated if
door is not opened after being
unlocked
60 seconds
Off
OO30 seconds
120 seconds
Open door warning buzzer
(When locking the vehicle)OnOffO
FunctionDefault settingCustomized set-ting
Smart access system with push-
button startOnOffO
Smart door unlockingDriver’s doorAll the doorsOO
FunctionDefault settingCustomized set-tingABC
ABC
ABC
ABC

4258-2. Customization
8
Vehicle specifications
QWireless remote control (P.100, 104, 108)
QTrunk ( P.108)
*: If equipped
Time elapsed before unlocking
all the door when gripping and
holding the driver’s door handle
2 seconds
Off
O1.5 seconds
2.5 seconds
Number of consecutive door
lock operations2 timesAs many as desiredO
FunctionDefault settingCustomized set-
ting
Wireless remote controlOnOffO
Unlocking operation
Driver’s door
unlocked in one step, all doors
unlocked in two step
All doors unlocked in one stepOO
Locking operation when door
openedOnOffOO
Trunk unlocking operationPress and hold (short)
One short press
O
Push twice
Press and hold (long)
Off
Theft deterrent panic modeOnOffO
FunctionDefault settingCustomized set- ting
Hands Free Power Trunk Lid
(kick sensor)
*OnOffO
FunctionDefault settingCustomized set-tingABC
ABC
ABC

4268-2. Customization
QDriving position memory* ( P.121)
*: If equipped
QOutside rear view mirrors ( P.128)
*: If equipped
QPower windows and moon roof ( P.131, 133)
FunctionDefault settingCustomized set-
ting
Selecting doors linked to the
memory recall function
*Driver’s doorAll doorsO
Driver’s seat slide movement
when exiting the vehicle
*FullOffOOPartial
Steering wheel movementTilt only
Off
OTelescopic only
Tilt and telescopic
FunctionDefault settingCustomized set-ting
Automatic mirror folding and
extending operation
*
Linked to the lock-ing/ unlocking of the doorsOff
OLinked to opera-
tion of the power switch
FunctionDefault settingCustomized set- ting
Mechanical key linked opera-
tion (open)OffOnO
Mechanical key linked opera-
tion (close)OffOnO
Wireless remote control linked
operation (open)OffOnO
Wireless remote control linked
operation signal (buzzer)OnOffO
ABC
ABC
ABC