OTHER KEY FEATURES
Refer to the inside front cover for more information on QR codes .www .youtube .com/KiaFeatureVideos
HomeLink® Support Video
QR CODE
REMINDERS:
•
A ladder may be needed to access the garage door opener
•A second person may be needed to help
•Some of the steps are time sensitive
OTHER KEY
FEATURES
•If the indicator C flashes rapidly in red continuously, but if the garage door opener does not operate, please continue to follow Rolling Code Programming steps below
QUICK TIP
•Erasing programmed but tons will delete all trained transmitters
QUICK TIP
A HomeLink® button
B HomeLink® button
C Indicator light
D HomeLink® button
E Glare detection sensor
F Automatic dimming ON
G Automatic dimming OFF
Auto-Dimming Rearview Mirror
Designed to help reduce glare from a vehicle’s headlights located in the rear and also connect up to three electronic transmitters in one location . Press the on/off button F to turn the auto-dimming function on or off .
How to Sync Transmitter
1 . Press and release A , B or D button
–If the indicator C flashes slowly in red, go to Step 3 (Programming)
–If the indicator C is continuously turned ON or flashes rapidly in red several times, go to Step 2 (Erasing)
2 . Press and hold the button you wish to erase the program for approximately 15-25 seconds until the LED flashes slowly in Red
3 . Hold the Garage Door Opener Original Transmitter near the HomeLink Mirror
4 .
Press and hold the desired button (A , B or D ) and the Original Transmitter button until the indicator C is turned on continuously or flashes rapidly in red . This indicates the programming is completed
To complete programming of a Rolling Code garage door opener:
1 . Firmly press and release the “Learn,” “Smart,” or “Program” button of the garage door opener while the indicator C flashes slowly in red . Once the button is pressed, you have approximately 30 seconds to initiate the next step
2 . Return to the vehicle and firmly press and hold the HomeLink button for two seconds and release . Repeat this up to three times to complete the programming . Do not press the HomeLink button rapidly . At this point, programming is complete and your device should operate
Operating HomeLink®: Press one of the programmed HomeLink® buttons .
Erasing programmed buttons: Press and hold the left A and center D buttons simultaneously for approximately 20 seconds, until the indicator light begins to flash, and then release both buttons within 30 seconds .
HomeLink® with Auto-Dimming Rearview Mirror*†3
For more information, go to HomeLink .com or call (800) 355-3515 .
See section 4 in the Owner’s Manual for more information .
REMINDER: Mirror indicator light will illuminate when automatic dimming is on .
ABCDEFG
†LEGAL DISCL AIMERS ON BACK INSIDE COVER*IF EQUIPPED60TELLURIDE FEATURES & FUNCTIONS GUIDE
