Page 13 of 464
: $ 5 1 , 1 *
$ Q \ P R G L I L F D W L R Q V R U D O W H U D W L R Q V W R W K L V Y H K L F O H F R X O G V H U L R X V O \ D I I H F W L W V
U R D G Z R U W K L Q H V V D Q G V D I H W \ D Q G P D \ O H D G W R D F R O O L V L R Q U H V X O W L Q J L Q V H U L-
ous injury or death.
Red Warning Lights
Air Bag Warning Light
Úpage 122
Brake Warning Light Úpage 122
Battery Charge Warning Light Úpage 123
Door Open Warning Light
Úpage 123
Electric Power Steering (EPSyf ) D X O W : D U Q L Q J Light
Ú page 123
Electronic Throttle Control (ETCyf : D U Q L Q J / L J K t Úpage 123
Engine Coolant Temperature Warning Light Úpage 124
Hood Open Warning Light Úpage 124
Oil Pressure Warning Light Úpage 124
Oil Temperature Warning Light Úpage 124
Seat Belt Reminder Warning Light Úpage 123
Red Warning Lights
1
21_JL_OM_EN_USC_t.book Page 11
Page 147 of 464
WARNING!
Never use the PARK position on an auto-
matic transmission as a substitute for the
parking brake. Always apply the parking
brake fully when parked to guard against
vehicle movement and possible injury or
damage.
When exiting the vehicle, always remove
the key fob from the ignition and lock your
vehicle.
WARNING! (Continuedyf
WARN ,N *
vehicle unattended without having the park -
ing brake fully applied. The parking brake
should always be applied when the driver is
not in the vehicle, especially on an incline.
CAUTION!
Never drive with your foot resting on the
clutch pedal, or attempt to hold the vehicle
on a hill with the clutch pedal partially
engaged, as this will cause abnormal wear
on the clutch.
Do not drive with your hand resting on the
gear selector as the force exerted, even if
slight, could lead over time to premature
wear of the gearbox internal components.
4
21_JL_OM_EN_USC_t.book Page 145
Page 344 of 464
: $ 5 1 , 1 *
$ Q L P S U R S H U O \ D W W D F K H G G D P D J H G I R O G H G R U
V W D F N H G I O R R U P D W R U G D P D J H G I O R R U P D W I D V-
teners may cause your floor mat to interfere
with the accelerator, brake, or clutch pedals
and cause a loss of vehicle control. To pre -
vent SERIOUS INJURY or DEATH:
ALWAYS securely attach your floor mat
using the floor mat fasteners. DO NOT
install your floor mat upside down or turn
your floor mat over. Lightly pull to confirm
mat is secured using the floor mat
fasteners on a regular basis.
ALWAYS REMOVE THE EXISTING FLOOR
MAT FROM THE VEHICLE before
installing any other floor mat. NEVER install
or stack an additional floor mat on top of an
existing floor mat.
ONLY install floor mats designed to fit your
vehicle. NEVER install a floor mat that
cannot be properly attached and secured to
your vehicle. If a floor mat needs to be
replaced, only use a FCA approved floor
mat for the specific make, model, and year
of your vehicle.
WARNING! (ContinuedyfWARN ,N * (Continuedyf
Page 433 of 464
TEC \b \f SPECIFICATIONS
VE \b \fE IDENTIFICATION NUMBER
The Vehicle Identification Number (VINyf L V I R X Q G
on the left front corner of the A-pillar, visible
from outside of the vehicle through the
windshield.
Vehicle Identification Number
NOTE:
It is illegal to remove or alter the VIN plate.
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic
brake systems. If either of the two hydraulic
systems loses normal capability, the remaining
system will still function. However, there will be some loss of overall braking effectiveness. You
may notice increased pedal travel during
application, greater pedal force required to slow
or stop, and potential activation of the Brake
Warning Light.
In the event power assist is lost for any reason
(i.e., repeated brake applications with the
engine offyf W K H E U D N H V Z L O O V W L O O I X Q F W L R Q
However, the effort required to brake the
vehicle will be much greater than that required
with the power system operating.
W \b \f AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to
ensure that the wheel is properly mounted to
the vehicle. Any time a wheel has been removed
and reinstalled on the vehicle, the lug nuts/
bolts should be torqued using a properly
calibrated torque wrench using a six sided (hexyf
deep wall socket.
TORQUE SPECIFICATIONS
**Use only authorized dealer recommended lug nuts/
bolts and clean or remove any dirt or oil before tightening.
Inspect the wheel mounting surface prior to
mounting the tire and remove any corrosion or
loose particles.
Spare Tire Torque Specifications
**Use only authorized dealer recommended lug nuts/
bolts and clean or remove any dirt or oil before tightening.
Lug Nut/Bolt
Torque **Lug Nut/
Bolt Size Lug Nut/Bolt
Socket Size
130 Ft-Lbs (176 N·myf M14 x 1.50 22 mm
Lug Nut/Bolt Torque **Lug Nut/
Bolt Size Lug Nut/Bolt
Socket Size
59 Ft-Lbs (80 N·myf M14 x 1.50 22 mm
9
21_JL_OM_EN_USC_t.book Page 431
