6
(Continuedyf
Center Seat LATCH
Two-Door Models:
Four-Door Models:
Do not install child restraints with rigid lower
attachments in the center seating position. Only
install this type of child restraint in the outboard
seating positions. Child restraints with flexible,
webbing mounted lower attachments can be
installed in any rear seating position.Always follow the directions of the child
restraint manufacturer when installing your
child restraint. Not all child restraint systems
will be installed as described here.
To Install A LATCH-Compatible Child
Restraint
If the selected seating position has a
Switchable Automatic Locking Retractor (ALRyf
seat belt, stow the seat belt, following the
instructions below. See Ú
page 336 to check
what type of seat belt each seating position has.
1. Loosen the adjusters on the lower straps and on the tether strap of the child seat so
that you can more easily attach the hooks
or connectors to the vehicle anchorages.
2. Place the child seat between the lower anchorages for that seating position. If the
second row seat can be reclined, you may
recline the seat and/or raise the head
restraint (if adjustableyf W R J H W D E H W W H U I L W , I
the rear seat can be moved forward and
rearward in the vehicle, you may wish to move it to its rear-most position to make
room for the child seat. You may also move
the front seat forward to allow more room
for the child seat.
3. Attach the lower hooks or connectors of the child restraint to the lower anchorages in
the selected seating position.
4. If the child restraint has a tether strap, connect it to the top tether anchorage. See
Úpage 339 for directions to attach a tether
anchor.
5. Tighten all of the straps as you push the child restraint rearward and downward into
the seat. Remove slack in the straps
according to the child restraint
manufacturer’s instructions.
6. Test that the child restraint is installed tightly by pulling back and forth on the child
seat at the belt path. It should not move
more than 1 inch (25.4 mmyf L Q D Q \
direction.
How To Stow An Unused Switchable-ALR
(ALRyf 6 H D W % H O W :
When using the LATCH attaching system to
install a child restraint, stow all ALR seat belts
that are not being used by other occupants or
WARNING!
This vehicle does not have a center seating
position. Do not use the center lower LATCH
anchorages to install a child seat in the cen -
ter of the back seat.
WARNING!
Never use the same lower anchorage to
attach more than one child restraint. If you
are installing LATCH-compatible child
restraints next to each other, you must use
the seat belt for the center position. You can
then use either the LATCH anchors or the
vehicle’s seat belt for installing child seats in
the outboard positions.
Please see Ú page 335 for typical installa -
tion instructions.
WARNING! (Continuedyf
