Page 314 of 416
WARNING!
Carefully follow these tire changing warnings to
help prevent personal injury or damage to your
vehicle:
Always park on a firm, level surface as far from
the edge of the roadway as possible before
raising the vehicle.
Turn on the Hazard Warning Flashers.
Apply the parking brake firmly and set the
transmission in PARK.
Block the wheel diagonally opposite the
wheel to be raised.
Never start or run the engine with the vehicle
on a jack.
Do not let anyone sit in the vehicle when it is
on a jack.
Do not get under the vehicle when it is on a
jack. If you need to get under a raised vehicle,
take it to a service center where it can be
raised on a lift.
WARNING!
Page 324 of 416
: $ 5 1 , 1 *
) D V W V S L Q Q L Q J W L U H V F D Q E H G D Q J H U R X V ) R U F H V
J H Q H U D W H G E \ H [ F H V V L Y H Z K H H O V S H H G V P D \
F D X V H G D P D J H R U H Y H Q I D L O X U H R I W K H D [ O H D Q G
W L U H V $ W L U H F R X O G H [ S O R G H D Q G L Q M X U H V R P H R Q H
' R Q R W V S L Q \ R X U Y H K L F O H
V Z K H H O V I D V W H U
W K D Q P S K N P K \f R U I R U O R Q J H U W K D Q
V H F R Q G V F R Q W L Q X R X V O \ Z L W K R X W V W R S S L Q J Z K H Q
\ R X D U H V W X F N D Q G G R Q R W O H W D Q \ R Q H Q H D U D
V S L Q Q L Q J Z K H H O Q R P D W W H U Z K D W W K H V S H H G
& $ 8 7 , 2 1
Racing the engine or spinning the wheels may
lead to transmission overheating and failure.
Allow the engine to idle with the transmission
in NEUTRAL for at least one minute after every
five rocking-motion cycles. This will minimize
overheating and reduce the risk of transmis-
sion failure during prolonged efforts to free a
stuck vehicle.
Page 326 of 416
& $ 8 7 , 2 1
Towing faster than 30 mph (48 km/hyf R U
farther than 30 miles (48 kmyf Z L W K U H D U
wheels on the ground can cause severe trans-
mission damage. Damage from improper
towing is not covered under the New Vehicle
Limited Warranty.
Page 382 of 416
: $ 5 1 , 1 *
Do not use a tire, wheel size, load rating, or
speed rating other than that specified for your
vehicle. Some combinations of unapproved
tires and wheels may change suspension
dimensions and performance characteristics,
resulting in changes to steering, handling, and
braking of your vehicle. This can cause unpre-
dictable handling and stress to steering and
suspension components. You could lose
control and have a collision resulting in
serious injury or death. Use only the tire and
wheel sizes with load ratings approved for
your vehicle.
Never use a tire with a smaller load index or
capacity, other than what was originally
equipped on your vehicle. Using a tire with a
smaller load index could result in tire over -
loading and failure. You could lose control and
have a collision.
Failure to equip your vehicle with tires having
adequate speed capability can result in
sudden tire failure and loss of vehicle control.
CAUTION!
Replacing original tires with tires of a different
size may result in false speedometer and
odometer readings.
Page 393 of 416
TEC \b \f SPECIFICATIONS
VE \b \fE IDENTIFICATION NUMBER (VIN)
The VIN is found on a label located on the left front
corner of the instrument panel pad, visible from
outside of the vehicle through the windshield.
Windshield VIN Label Location
NOTE:It is illegal to remove or alter the VIN.
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic brake
systems. If either of the two hydraulic systems lose
normal capability, the remaining system will still
function. However, there will be some loss of
overall braking effectiveness. You may notice
increased pedal travel during application, greater
pedal force required to slow or stop, and potential
activation of the Brake Warning Light.
In the event power assist is lost for any reason the
brakes will still function. However, the effort
required to brake the vehicle will be much greater
than that required with the power system
operating.
W \b \f AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to
ensure that the wheel is properly mounted to the
vehicle. Any time a wheel has been removed and
reinstalled on the vehicle, the lug nuts/bolts
should be torqued using a properly calibrated
torque wrench using a six-sided (hexyf G H H S Z D O O
socket.
TORQUE SPECIFICATIONS
**Use only authorized dealer recommended lug
nuts/bolts and clean or remove any dirt or oil
before tightening.
Lug Nut/
Bolt Torque **Lug Nut/
Bolt SizeLug Nut/Bolt
Socket Size
130 Ft-Lb
(176 N·myf M14 x 1.50 22 mm
9
22_WL_OM_EN_USC_t.book Page 391
![JEEP GRAND CHEROKEE TRAILHAWK 2022 Owners Manual : $ 5 1 , 1 *
) D V W V S L Q Q L Q J W L U H V F D Q E H G D Q J H U R X V ) R U F H V
J H Q H U D W H G E \ H [ F H V V L Y H Z K H H O V S H H G V P D \
F D X V H](/manual-img/16/56028/w960_56028-323.png "JEEP GRAND CHEROKEE TRAILHAWK 2022 Owners Manual : $ 5 1 , 1 *
) D V W V S L Q Q L Q J W L U H V F D Q E H G D Q J H U R X V ) R U F H V
J H Q H U D W H G E \ H [ F H V V L Y H Z K H H O V S H H G V P D \
F D X V H")
