Page 241 of 344
Oo Fke G Ue Seat
Vte S 5.
7. ) L Qa O O \ S X O O X S o Q a Q \ e [ Fe V V Zebb L Qg to t Lg Kte Q t Ke Oa S So Ut Lo Q a Uo X Q G t Ke F K L O G
Ue Vt Ua L Qt Z K L Oe \o X S X V K t Ke F K L O G Ue Vt Ua L Qt
Uea U Za U G a Q G Go Z Q Za U G L Qto t Ke Ye K L F Oe Veat.
8. , I t Ke F K L O G Ue Vt Ua L Qt Ka V a to S tet Ke U Vt Ua S a Q G t Ke Veat L Qg So V Lt Lo Q Ka V a to S tet Ke U a Q F Ko Uage
Fo Q Qe Ft t Ke tet Ke U Vt Ua S to t Ke a Q F Ko Uage a Q G
t Lg Kte Q t Ke tet Ke U Vt Ua S. See
Ú
page 239 for
directions to attach a tether anchor.
9. Test that the child restraint is installed tightly
by pulling back and forth on the child seat at
the belt path. It should not move more than
1 inch (25.4 mmyf L Q D Q \ G L U H F W L R Q .
Any seat belt system will loosen with time, so check
the belt occasionally, and pull it tight if necessary.
Installing Child Restraints Using The Top
Tether Anchorage:WARNING!
Improper installation or failure to properly
secure a child restraint can lead to failure of
the restraint. The child could be badly injured
or killed.
Follow the child restraint manufacturer’s
directions exactly when installing an infant or
child restraint.
WARNING!
Do not attach a tether strap for a rear-facing car
seat to any location in front of the car seat,
including the seat frame or a tether anchorage.
Only attach the tether strap of a rear-facing car
seat to the tether anchorage that is approved for
that seating position, located behind the top of
the vehicle seat. See Ú page 233 for the
location of approved tether anchorages in
your vehicle.
6
22_MP_OM_EN_USC_t.book Page 239
Page 242 of 344
: $ 5N ,N *
An incorrectly anchored tether strap could
lead to increased head motion and possible
injury to the child. Use only the anchorage
position directly behind the child seat to
secure a child restraint top tether strap.
If your vehicle is equipped with a split rear
seat, make sure the tether strap does not slip
into the opening between the seatbacks as
you remove slack in the strap.
WARNING!
Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build-up
may cause serious injury or death.
It is extremely dangerous to ride in a cargo
area, inside or outside of a vehicle. In a colli-
sion, people riding in these areas are more
likely to be seriously injured or killed.
Do not allow people to ride in any area of your
vehicle that is not equipped with seats and
seat belts.
Be sure everyone in your vehicle is in a seat
and using a seat belt properly.
Page 243 of 344
: $ 5N ,N *
$ Q L P S Uo Se U O \ atta F Ke G Ga Page G Io O Ge G o U
Vta Fke G I Ooo U Pat o U Ga Page G I Ooo U Pat
Ia Vte Qe U V Pa \ Fa X Ve \o X U I Ooo U Pat to L Qte U Ie Ue
Z Lt K t Ke a F Fe Oe Uato U b Uake o U F O Xt F K Se Ga O V a Q G
Fa X Ve a Oo V V o I Ye K L F Oe Fo Qt Uo O. 7o S Ue Ye Qt
SE 5 ,OUS ,N -U 5 < o U 'E $ 7 +
ALWAYS securely attach your floor
mat using the floor mat fasteners.
DO NOT install your floor mat upside
down or turn your floor mat over.
Lightly pull to confirm mat is secured using the
floor mat fasteners on a regular basis.
ALWAYS REMOVE THE EXISTING
FLOOR MAT FROM THE VEHICLE
before installing any other floor mat.
NEVER install or stack an additional
floor mat on top of an existing floor mat.
ONLY install floor mats designed to fit your
vehicle. NEVER install a floor mat that cannot
be properly attached and secured to your
vehicle. If a floor mat needs to be replaced,
only use a FCA approved floor mat for the
specific make, model, and year of your
vehicle.
6
22_MP_OM_EN_USC_t.book Page 241
Page 266 of 344
C $U 7 ,ON
Do not use sling-type equipment when towing.
Vehicle damage may occur.
When securing the vehicle to a flatbed truck,
do not attach to front or rear suspension
components. Damage to your vehicle may
result from improper towing.
Ensure that the Electric Park Brake is
released, and remains released, while being
towed.
Do not use a fascia/bumper mounted
clamp-on tow bar on your vehicle. The fascia/
bumper face bar will be damaged.
Page 284 of 344
: $ 5N ,N *
5 L G L Qg t Ke b Uake V Fa Q Oea G to b Uake Ia L O X Ue a Q G
So V V Lb O \ a Fo O O L V Lo Q. ' U L Y L Qg Z Lt K \o X U Ioot Ue Vt L Qg o U
U L G L Qg o Q t Ke b Uake Se Ga O Fa Q Ue V X Ot L Q ab Qo U Pa O O \
K Lg K b Uake te P Se Uat X Ue V e [ Fe V V L Ye O L Q L Qg Zea U
a Q G So V V Lb Oe b Uake Ga Page.
\o X U I X O O b Uak L Qg Fa Sa F Lt \ L Q a Q e Pe Uge Q F \.
: $ 5N ,N *
Use only the manufacturer recommended
brake fluid Úpage 324. Using the wrong type
of brake fluid can severely damage your brake
system and/or impair its performance. The
proper type of brake fluid for your vehicle is
also identified on the original factory installed
hydraulic master cylinder reservoir.
To avoid contamination from foreign matter or
moisture, use only new brake fluid or fluid that
has been in a tightly closed container. Keep
the master cylinder reservoir cap secured at
all times. Brake fluid in a open container
absorbs moisture from the air resulting in a
lower boiling point. This may cause it to boil
unexpectedly during hard or prolonged
braking, resulting in sudden brake failure.
This could result in a collision.
Overfilling the brake fluid reservoir can result
in spilling brake fluid on hot engine parts,
causing the brake fluid to catch fire. Brake
fluid can also damage painted and vinyl
surfaces, care should be taken to avoid its
contact with these surfaces.
