2022 HYUNDAI I10 lock
[x] Cancel search: lockPage 264 of 486
6-8
Whilst driving
Key ignition switch positions
Switch
PositionAction Notice
/ 2 & .The ignition key can be removed
in the LOCK position.The steering wheel locks to pro-
tect the vehicle from theft.
(if equipped)
ACCElectrical accessories are
usable.The steering wheel unlocks.
If difficulty is experienced turning
the ignition switch to the ACC
position, turn the key whilst turn-
ing the steering wheel right and
left to release tension.
ONThis is the normal key position
when the engine has started.
All features and accessories are
usable.
The warning lights can be
checked when you turn the igni-
tion switch from ACC to ON.Do not leave the ignition switch
in the ON position when the
engine is not running to prevent
the battery from discharging.
STARTTo start the engine, turn the igni-
tion switch to the START posi-
tion. The switch returns to the
ON position when you let go of
the key.The engine will crank until you
release the key.
Page 291 of 486
6-35
06
Parking brake warning light
& K H F N W K H 3 D U N L Q J % U D N H
Warning Light by placing
the ignition switch to the
ON position (do not start
the engine).
This light will be illuminated when the
parking brake is applied with the igni-
tion switch in the START or ON posi-
tion.
% H I R U H G U L Y L Q J E H V X U H W K H S D U N L Q J
E U D N H L V U H O H D V H G D Q G W K H % U D N H
Warning Light is OFF.
, I W K H 3 D U N L Q J % U D N H : D U Q L Q J / L J K W
remains on after the parking brake is
released whilst the engine is running,
there may be a malfunction in the
brake system. Immediate attention is
necessary.
If at all possible, cease driving the
vehicle immediately. If that is not pos-
sible, use extreme caution whilst
operating the vehicle and only con-
tinue to drive the vehicle until you can
reach a safe location.
Anti-lock Brake System (ABS)
WARNING
$ Q $ Q W L / R F N % U D N L Q J 6 \ V W H P
(ABS) or an Electronic Stability
Control (ESC) system will not pre-
vent accidents due to improper or
dangerous driving manoeuvres.
Even though vehicle control is
improved during emergency brak-
ing, always maintain a safe dis-
tance between you and objects
ahead of you. Vehicle speeds
should always be reduced during
extreme road conditions. The brak-
ing distance for vehicles equipped
with ABS or ESC may be longer
than for those without these sys-
tems in the following road condi-
tions.
Drive your vehicle at reduced
speeds during the following condi-
tions:
Page 292 of 486
6-36
Whilst driving
Using ABS
To obtain the maximum benefit from
\ R X U $ % 6 L Q D Q H P H U J H Q F \ V L W X D W L R Q
do not attempt to modulate your
brake pressure and do not try to
pump your brakes. Depress your
brake pedal as hard as possible.
When you apply your brakes under
conditions which may lock the wheels,
you may hear sounds from the
brakes, or feel a corresponding sen-
sation in the brake pedal. This is nor-
P D O D Q G L W P H D Q V \ R X U $ % 6 L V D F W L Y H
$ % 6 G R H V Q R W U H G X F H W K H W L P H R U G L V-
tance it takes to stop the vehicle.
Always maintain a safe distance from
the vehicle in front of you.
$ % 6 Z L O O Q R W S U H Y H Q W D V N L G W K D W U H V X O W V
from sudden changes in direction,
such as trying to take a corner too
fast or making a sudden lane change.
Always drive at a safe speed for the
road and weather conditions.
$ % 6 F D Q Q R W S U H Y H Q W D O R V V R I V W D E L O L-
ty. Always steer moderately when
braking hard. Severe or sharp steer-
ing wheel movement can still cause
your vehicle to veer into oncoming
traffic or off the road.
On loose or uneven road surfaces,
operation of the anti-lock brake sys-
tem may result in a longer stopping
distance than for vehicles equipped
with a conventional brake system.
7 K H $ % 6 Z D U Q L Q J O L J K W
) will stay
on for several seconds after the igni-
tion switch is in the ON position.
' X U L Q J W K D W W L P H W K H $ % 6 Z L O O J R
through self-diagnosis and the light
will go off if everything is normal. If
the light stays on, you may have a
S U R E O H P Z L W K \ R X U $ % 6 : H U H F R P-
mend that you contact a HYUNDAI
authorised repairer as soon as pos-
sible.
WARNING
If the ABS warning light () is on
and stays on, you may have a
problem with the ABS. Your power
brakes will work normally. To
reduce the risk of serious injury or
death, we recommend that you
contact a HYUNDAI authorised
repairer as soon as possible.
NOTICE
When you drive on a road having
poor traction, such as an icy road,
and apply your brakes continuous-
ly, the ABS will be active continu-
ously and the ABS warning light
(
) may illuminate. Pull your
vehicle over to a safe place and
turn the engine off.
Restart the engine. If the ABS
warning light is off, then your ABS
system is normal.
Otherwise, you may have a prob-
lem with your ABS system. We rec-
ommend that you contact a
HYUNDAI authorised repairer as
soon as possible.
i Information
When you jump start your vehicle
because of a drained battery, the ABS
warning light (
) may turn on at the
same time. 7his happens because of the
low battery voltage. It does not mean
your ABS is malfunctioning. +ave the
battery recharged before driving the
vehicle.
Page 295 of 486
6-39
06
‡ 6 W D W H
2 $ & 7 8
3 U H V V D Q G K R O G W K H ( 6 & 2 ) ) E X W W R Q
continuously for more than 3 sec-
onds. The ESC OFF indicator light
and/or message “Traction control and
ESC disabled” illuminates and a
warning chime sounds. In this state,
both the traction control function of
ESC (engine management) and the
brake control function of ESC (brak-
ing management) are disabled.
If the ignition switch is placed in the
LOCK/OFF position when ESC is off,
ESC remains off. Upon restarting the
vehicle, the ESC will automatically
turn on again.
Indicator lights
„ ESC indicator light (blinks)
„ ESC OFF indicator light (comes on)
2 7 '
2 7 '
When the ignition switch is in the ON
position, the ESC indicator light illu-
minates, then goes off if the ESC sys-
tem is operating normally.
The ESC indicator light blinks when-
ever the ESC is operating.
If the ESC indicator light stays on,
your vehicle may have a malfunction
with the ESC system. When this
warning light illuminates we recom-
mend that the vehicle be checked by
a HYUNDAI authorised repairer as
soon as possible.
The ESC OFF indicator light comes
on when the ESC is turned off with
the button.
WARNING
When the ESC is blinking, this
indicates the ESC is active:
Drive slowly and NEVER attempt
to accelerate. NEVER turn the ESC
off whilst the ESC indicator light is
blinking or you may lose control of
the vehicle resulting in an acci-
dent.
Page 310 of 486
6-54
Whilst driving
Warning message and warning
light
2 $ & 7 8
Critical forward safety functions are
limited. Camera obscured
When the camera is blocked with dirt,
snow, or debris, FCA system may not
detect other vehicles.
If this occurs, a warning message will
appear on the LCD display.
The system will operate normally
when such dirt, snow or debris is
removed.
FCA may not properly operate in an
area (e.g. open terrain) where any
R E M H F W V R U Y H K L F O H V D U H Q R W G H W H F W H G
after turning on the engine.
Also, even though a warning mes-
sage does not appear on the LCD
display, FCA may not properly oper-
ate.
WARNING
FCA system may not activate
according to road conditions,
inclement weather, driving condi-
tions or traffic conditions.
System malfunction
2 $ & 7 8
Check forward safety systems
Page 350 of 486
6-94
Whilst driving
To prevent locks from freezing
To prevent the locks from being fro-
zen, spray approved de-icing fluid or
glycerin into key holes. When a lock
opening is already covered with ice,
spray approved de-icing fluid over the
ice to remove it. When an internal
part of a lock freezes, try to thaw it
with a heated key. Carefully use the
K H D W H G N H \ W R D Y R L G D Q L Q M X U \
Use approved window washer anti-
freeze solution in system
To prevent the window washer from
being frozen, add authorized window
washer anti-freeze solution, as speci-
fied on the window washer container.
Window washer anti-freeze solution
is available from a HYUNDAI autho-
rised repairer, and most vehicle
accessory outlets. Do not use engine
coolant or other types of anti-freeze
solution to prevent any damage to the
vehicle paint.
Do not let your parking brake
freeze
Under some conditions your parking
brake can freeze in the engaged posi-
tion.
This is most likely to happen when
there is an accumulation of snow or
ice around or near the rear brakes or
if the brakes are wet. When there is
the risk that your parking brake may
freeze, temporarily apply it with the
V K L I W O H Y H U L Q 1 I R U $ X W R P D W H G 0 D Q X D O
Transmission) or in first or reverse
gear (for manual transmission). Also,
block the rear wheels in advance, so
the vehicle may not roll. Then, release
the parking brake.Do not let ice and snow
accumulate underneath
Under some conditions, snow and ice
can build up under the fenders and
interfere with the steering. When driv-
ing in such conditions during the
severe winter, you should check
underneath the vehicle on a regular
basis, to ensure that the front wheels
and the steering components is
unblocked.
Carry emergency equipment
In accordance with weather condi-
tions, you should carry appropriate
emergency equipment, whilst driving.
Some of the items you may want to
carry include tyre chains, tow straps
or chains, flashlight, emergency
I O D U H V V D Q G V K R Y H O M X P S H U F D E O H V
window scraper, gloves, ground cloth,
coveralls, blanket, etc.
Do not place objects or materials
in the engine compartment
3 X W W L Q J R E M H F W V R U P D W H U L D O V L Q W K H
engine compartment may cause an
engine failure or combustion,
because they may block the engine
cooling. Such damage will not be
covered by the manufacturer’s war-
ranty.
Page 370 of 486
7-18
Emergency situations
WARNING
& K D Q J L Q J D W \ U H F D Q E H G D Q J H U R X V
) R O O R Z W K H L Q V W U X F W L R Q V L Q W K L V V H F-
W L R Q Z K H Q F K D Q J L Q J D W \ U H W R
U H G X F H W K H U L V N R I V H U L R X V L Q M X U \ R U
G H D W K
CAUTION
% H F D U H I X O D V \ R X X V H W K H M D F N K D Q-
G O H W R V W D \ F O H D U R I W K H I O D W H Q G 7 K H
I O D W H Q G K D V V K D U S H G J H V W K D W F R X O G
F D X V H F X W V
- D F N D Q G W R R O V
OAC3079028TU
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
(4) Towing hook
The jack, jack handle, wheel lug nut
wrench, and towing hook are stored
in the luggage compartment under
the luggage box cover.
OAC3079004TU
The jack is provided for emergency
tyre changing only.
Turn the winged hold down bolt coun-
terclockwise to remove the spare
tyre.
Store the spare tyre in the same com-
partment by turning the winged hold
down bolt clockwise.
To prevent the spare tyre and tools
from “rattling”, store them in their
proper location.
OAC3079005TU
If it is hard to loosen the tyre hold-
down wing bolt by hand, you can
loosen it easily using the jack handle.
1. Put the jack handle (1) inside of the
tyre hold-down wing bolt.
2. Turn the tyre hold-down wing bolt
counterclockwise with the jack
handle.
IF YOU HAVE A FLAT TYRE ãWITH SPARE TYRE IF EQUIPPEDä
Page 372 of 486
7-20
Emergency situations
OAC3079008TU
7. Place the jack at the designated
jacking position under the frame
closest to the tyre you are chang-
ing. The jacking positions are
plates welded to the frame with two
notches. Never jack any other
position or part of the vehicle.
Doing so may damage the side
seal molding or other parts of the
vehicle.
OAC3079009TU
8. Insert the jack handle into the jack
and turn it clockwise, raising the
vehicle until the tyre clears the
ground. Make sure the vehicle is
stable on the jack.9. Loosen the lug nuts with the wheel
lug nut wrench and remove them
with your fingers. Remove the
wheel from the studs and lay it flat
on the ground out of the way.
Remove any dirt or debris from the
studs, mounting surfaces, and
wheel.
10. Install the spare tyre onto the
studs of the hub.
11 . Tighten the lug nuts with your fin-
gers onto the studs with the small-
er end of the lug nuts closest to
the wheel.
12. Lower the vehicle to the ground
by turning the jack handle coun-
terclockwise.
OAC3079027TU
13. Use the wheel lug nut wrench to
tighten the lug nuts in the order
shown. Double-check each lug
nut until they are tight. After
changing tyres, we recommend
that a HYUNDAI authorised
repairer tighten the lug nuts to
their proper torque as soon as
possible. 7 K H Z K H H O O X J Q X W
V K R X O G E H W L J K W H Q H G W R a
N J I P a O E I I W