Page 164 of 486
5-36
Convenient features
Exterior lights
Lighting control
OAC3059022TU
To operate the lights, turn the knob at
the end of the control lever to one of
the following positions:
(1) OFF (O) position
(2) AUTO light position (if equipped)
(3) Position light position
(4) Headlight position
OAC3059024TU
A 8 7 2 light position (if equipped)
When the light switch is in the AUTO
position, the position light and head-
light will be turned ON or OFF auto-
matically depending on the amount of
light outside the vehicle.
Even with the AUTO light feature in
operation, it is recommended to man-
ually turn ON the lights when driving
at night or in a fog, or when you enter
dark areas, such as tunnels and park-
ing facilities.
NOTICE
Page 166 of 486
5-38
Convenient features
High Beam Assist system
(if equipped)
OAC3059025TU
High Beam Assist is a system that
D X W R P D W L F D O O \ D G M X V W V W K H K H D G O L J K W
range (switches between high beam
and low beam) according to the
brightness of other vehicles and road
conditions.
System setting
The driver can activate the HBA by
placing the ignition switch to the ON
position and by selecting: ‘User
Settings Lights HBA (High Beam
$ V V L V W
Page 169 of 486
5-41
05
Turn signals and lane change
signals
OHCR046350
To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).
The lever will return to the OFF posi-
tion when released or when the turn
is completed.
If an indicator stays on and does not
flash or if it flashes abnormally, one of
the turn signal bulbs may be burned
out and will require replacement.
2ne-touch turn signal function
To activate a one-touch turn signal
function, move the turn signal lever
slightly and then release it. The lane
change signals will blink 3, 5 or 7
times.
You can activate or deactivate the
One Touch Turn Signal function or
choose the number of blinks (3, 5, or
7) from the User Settings Mode on
the LCD display. ) R U P R U H G H W D L O V
refer to “LCD Display Modes” in
chapter 4.
Front fog light (if equipped)
OHCR046362
Fog lights are used to provide
improved visibility when visibility is
poor due to fog, rain or snow, etc.
1. Turn on the park light.
2. Move the light switch (1) to the
front fog light position.
3. To turn off the front fog light, turn
the light switch to the front fog light
position again or turn off the
Parking (Position) light
NOTICE
When in operation, the fog lights
consume large amounts of vehicle
electrical power. Only use the fog
lights when visibility is poor.
Page 170 of 486
5-42
Convenient features
Rear fog light (if equipped)
OAC3059026TU
Vehicle with front fog light
To turn on the rear fog light:
Position the light switch in the Position
light position, turn the light switch to
the front fog light position, and then
turn the light switch (1) to the rear fog
light position.
OAC3059027TU
Vehicle without front fog light
To turn on the rear fog light:
Position the light switch in the head-
light position, and then turn the light
switch (1) to the rear fog light posi-
tion.
To turn the rear fog lights off, do one
of the following:
Page 171 of 486
5-43
05
NOTICE
If the driver exits the vehicle
through another door besides the
driver door, the battery saver func-
tion does not operate and the
headlight delay function does not
W X U Q 2 ) ) D X W R P D W L F D O O \
This may cause the battery to dis-
charge. To avoid battery dis-
F K D U J H W X U Q 2 ) ) W K H K H D G O L J K W V
manually from the headlight switch
before exiting the vehicle.
Daytime running light (DRL)
(if equipped)
The Daytime Running Lights (DRL)
can make it easier for others to see
the front of your vehicle during the
day, especially after dawn and before
sunset.
The DRL system will turn the dedi-
cated light OFF when:
1. The parking brake is applied.
2. The engine is turned off.
Headlight levelling device
OAC3059028R
7 R D G M X V W W K H K H D G O L J K W E H D P O H Y H O
according to the number of the pas-
sengers and loading weight in the
luggage area, turn the beam levelling
switch.
The higher the number on the switch
position, the lower the headlight
beam level. Always keep the head-
light beam at the proper levelling
position, or headlights may dazzle
other road users.
/ L V W H G E H O R Z D U H H [ D P S O H V R I D S S U R-
priate switch settings for varying
loads. For loading conditions other
W K D Q W K R V H O L V W H G D G M X V W W K H V Z L W F K
position to the most similar situation.
Loading conditionSwitch position
Driver only0
Driver + Front pas-
senger0
Full passengers
(including driver)1
Full passengers
(including driver) +
0 D [ L P X P S H U P L V V L E O H
loading2
' U L Y H U 0 D [ L P X P
permissible loading 3
Page 173 of 486
5-45
05
Front Room Lights
OAC3059029TU
: The front or rear room lights
come on when the front or
rear doors are opened if the
engine is running or not. When
doors are unlocked by the
remote key or smart key, the
front and rear lights come on
I R U D S S U R [ L P D W H O \ V H F R Q G V
as long as any door is not
opened. The front and rear
room lights go out gradually
D I W H U D S S U R [ L P D W H O \ V H F-
onds if the door is closed.
However, if the ignition switch
is in the ON position or all
doors are locked, the front and
rear lights will turn off. If a door
is opened with the ignition
switch in the ACC position or
the OFF position, the front and
rear lights stay on for about 20
minutes.
: With the Front Room Light in
this position, the front and rear
room lights remain on at all
times.
: With the Front Room Light in
this position the front and rear
room lights remain off at all
times.
Luggage compartment light
OAC3059063TU
The luggage compartment light comes
on when the tailgate is opened.
NOTICE
The luggage compartment comes
on as long as the tailgate lid is
open. To prevent unnecessary
charging system drain, close the
tailgate lid securely after using the
tailgate.
Glove box light (if equipped)
OAC3059030R
7 K H J O R Y H E R [ O L J K W F R P H V R Q Z K H Q
W K H J O R Y H E R [ L V R S H Q H G
The parking lights or headlights must
E H 2 1 I R U W K H J O R Y H E R [ O L J K W W R I X Q F-
tion.
Page 264 of 486
6-8
Whilst driving
Key ignition switch positions
Switch
PositionAction Notice
/ 2 & .The ignition key can be removed
in the LOCK position.The steering wheel locks to pro-
tect the vehicle from theft.
(if equipped)
ACCElectrical accessories are
usable.The steering wheel unlocks.
If difficulty is experienced turning
the ignition switch to the ACC
position, turn the key whilst turn-
ing the steering wheel right and
left to release tension.
ONThis is the normal key position
when the engine has started.
All features and accessories are
usable.
The warning lights can be
checked when you turn the igni-
tion switch from ACC to ON.Do not leave the ignition switch
in the ON position when the
engine is not running to prevent
the battery from discharging.
STARTTo start the engine, turn the igni-
tion switch to the START posi-
tion. The switch returns to the
ON position when you let go of
the key.The engine will crank until you
release the key.
Page 294 of 486
6-38
Whilst driving
ESC operation
ESC 2 1 condition
When the ignition switch is in the ON
position, the ESC and the ESC OFF
indicator lights illuminate for approxi-
mately three seconds. After both
lights go off, the ESC is enabled.
When operating
When the ESC is in opera-
tion, the ESC indicator
O L J K W E O L Q N V
