2022 HYUNDAI I10 reset
[x] Cancel search: resetPage 156 of 486
5-28
Convenient features
To reset the power windows
If the power windows do not operate
normally, the automatic power win-
dow system must be reset as follows:
1. Place the ignition switch to the ON
position.
2. Close the window and continue
pulling up on the power window
switch for at least one second.
If the power windows do not operate
properly after resetting, it is recom-
mended that the system be checked
by a HYUNDAI authorised repairer.
WARNING
The automatic reverse feature
doesn’t activate whilst resetting
power window system. Make sure
body parts or other objects are
safely out of the way before clos-
ing the windows to avoid injuries
or vehicle damage.
Automatic reverse (if equipped)
OLF044032
If a window senses any obstacle
whilst it is closing automatically, it will
V W R S D Q G O R Z H U D S S U R [ L P D W H O \ F P
L Q F K H V W R D O O R Z W K H R E M H F W W R E H
cleared.
If the window detects the resistance
whilst the power window switch is
pulled up continuously, the window
will stop upward movement then
O R Z H U D S S U R [ L P D W H O \ F P L Q F K
If the power window switch is pulled
up continuously again within 5 sec-
onds after the window is lowered by
the automatic window reverse fea-
ture, the automatic window reverse
will not operate.
i Information
7he automatic reverse feature is only
active when the “Auto 8p” feature is
used by fully pulling up the switch to
the second detent.
WARNING
Make sure body parts or other
objects are safely out of the way
before closing the windows to
avoid injuries or vehicle damage.
Objects less than 4 mm (0.16 inch)
in diameter caught between the
window glass and the upper win-
dow channel may not be detected
by the automatic reverse window
and the window will not stop and
reverse direction.
NOTICE
Do not install any accessories on
the windows. The automatic reverse
feature may not operate.
Page 194 of 486
5-66
Convenient features
Temperature control
OAI3059111I
The temperature will increase by
turning the knob to the right.
The temperature will decrease by
turning the knob to the left.
The temperature will increase or
decrease by 0.5°C (1°F) for each
incremental location. When set to the
lowest temperature setting, the air
conditioning will operate continuously.
7emperature conversion
If the battery has been discharged or
disconnected, the temperature mode
display will reset to Centigrade.
To change the temperature unit from
°C to °F or °F to °C :
- Automatic climate control system
Press the AUTO button for 3 sec-
onds whilst pressing the OFF but-
ton.
- Instrument cluster
Go to User Settings o Other
Features o Temperature Unit.
The temperature unit on both the
cluster LCD display and the climate
control screen will change.
Air intake control
OAI3059106I
This is used to select the outside
(fresh) air position or recirculated air
position.
To change the air intake control posi-
tion, push the control button.
Recirculated air position
With the recirculated air
position selected, air
from the passenger
compartment will be
drawn through the heat-
ing system and heated
or cooled according to
the function selected.
2utside (fresh) air position
With the outside (fresh)
air position selected, air
enters the vehicle from
outside and is heated or
cooled according to the
function selected.
Page 237 of 486
5-109
05
6 D Y L Q J U D G L R V W D W L R Q V
You can save your favorite radio sta-
tions and listen to them by selecting
them from the preset list.
Saving the current radio station
Whilst listening to the radio, press
and hold the desired number button
on the control panel.
‡ The radio station you are listening
to will be added to the selected
number.
‡ To save the next page of the preset
list, press the [ ) $ 9] button.
NOTICE
Page 258 of 486
6
Forward collision-avoidance assist (FCA) ...................................................... 6-49
System setting and activation ..................................................................... 6-49
FCA warning message and brake control .................................................... 6-51
FCA sensor (front view camera) ...................................................................6-53
System malfunction ..................................................................................... 6-54
Limitations of the system............................................................................. 6-56
Lane keeping assist (LKA)
................................................................................ 6-61
LKA operation ............................................................................................... 6-62
LKA system function change ....................................................................... 6-63
Warning light and message ......................................................................... 6-65
Limitations of the system..............................................................................6-67
Manual speed limit assist (MSLA)
................................................................... 6-69
Speed limit assist operation ........................................................................ 6-69
Intelligent speed limit warning (ISLW)
........................................................ 6-72
System setting and activation ...................................................................... 6-73
Display ............................................................................................................ 6-73
Limitations of the system ............................................................................. 6-76
Driver attention warning (DAW)
...................................................................... 6-78
System setting and operation ...................................................................... 6-78
Resetting the system ................................................................................... 6-80
System standby ............................................................................................ 6-80
System malfunction ..................................................................................... 6-80
Leading vehicle departure alert .................................................................. 6-82
Cruise control
................................................................................................... 6-83
Cruise Control operation ............................................................................. 6-83
Page 325 of 486
6-69
06
Speed limit assist operation
You can set the speed limit when you
do not want to drive over a specific
speed.
If you drive over the preset speed
limit, the warning system operates
(set speed limit will blink and chime
will sound) until the vehicle speed
returns within the speed limit.
i Information
Whilst speed limit control is in opera-
tion, the cruise control system cannot
be activated.
Speed limit control switch
2 $ ,
& K D Q J H V P R G H E H W Z H H Q
cruise control system and
speed limit control system.
System off
Speed Limit ControlCruise Control
5 ( 6 5 H V X P H V R U L Q F U H D V H V V S H H G
limit control speed.
6 ( 7 6 H W V R U G H F U H D V H V V S H H G O L P L W
control speed.
& D Q F H O & D Q F H O V V H W V S H H G O L P L W
To set speed limit
2 $ ,
3 U H V V W K H button to turn the
system on. The speed limit (
or
) indicator on the instrument
cluster will illuminate.
2 $ ,
3 X V K W K H W R J J O H V Z L W F K G R Z Q 6 ( 7
and release it.
MANUAL SPEED LIMIT ASSIST ãMSLAä ãIF EQUIPPEDä
Page 336 of 486
6-80
Whilst driving
Resetting the system
Page 343 of 486
6-87
06
i Information
Each of the above actions will cancel
Cruise Control operation (the SE 7
indicator light in the instrument clus-
ter will go off), but only pressing the
CR 8ISE/
button will turn the
system off. If you wish to resume
Cruise Control operation, push the
toggle switch up (RES ) located on
your steering wheel.
the system was turned off using the
CR 8ISE/
button.
To resume preset Cruising
speed
2 $ ,
3 X V K W K H W R J J O H V Z L W F K X S 5 ( 6 , I
W K H Y H K L F O H V S H H G L V R Y H U P S K
km/h), the vehicle will resume the
preset speed.
To turn Cruise Control off
2 $ ,
Page 353 of 486
Hazard warning flasher ...................................................................................... 7-3
In case of an emergency whilst driving ............................................................ 7-3
If the engine stalls whilst driving .................................................................... 7-3
If the engine stalls at a crossroad or crossing ............................................... 7-3
If you have a flat tyre whilst driving ............................................................... 7-4
If the engine will not start .................................................................................. 7-5
If the engine doesn’t turn over or turns over slowly ..................................... 7-5
If the engine turns over normally but doesn’t start ...................................... 7-5
Jump starting ...................................................................................................... 7-6
If the engine overheats ...................................................................................... 7-9
Tyre Pressure Monitoring System (TPMS) ........................................................7-10
TPMS reset procedure .....................................................................................7-11
Tyre pressure monitoring system .................................................................. 7-12
Low tyre pressure telltale ............................................................................... 7-14
Low tyre pressure position telltale and tyre pressure telltale ..................... 7-14
TPMS (Tyre Pressure Monitoring System) malfunction indicator ............... 7-15
Changing a tyre with TPMS ...........................................................................7-16
If you have a flat tyre (with spare tyre) .............................................................7-18
Jack and tools ................................................................................................7-18
Changing tyres................................................................................................7-19
Jack label ....................................................................................................... 7-23
EC Declaration of conformity for Jack......................................................... 7-24
If you have a flat tyre (with tyre mobility kit) .................................................. 7-25
Introduction ................................................................................................... 7-25
Notes on the safe use of the tyre Mobility Kit ............................................. 7-26
Components of the Tyre Mobility Kit ............................................................7-27
Using the Tyre Mobility Kit ............................................................................ 7-28
Distributing the sealant ................................................................................. 7-30
Checking the tyre inflation pressure ............................................................ 7-30
7. Emergency situations
7