Page 271 of 486
6-15
06
2 $ & 7 8
Manual transmission operation
7 K H P D Q X D O W U D Q V P L V V L R Q K D V I R U-
ward gears. The transmission is fully
synchronized in all forward gears so
shifting to either a higher or a lower
gear is easily accomplished
WARNING
Before leaving the driver’s seat,
always make sure the shift lever is
in 1st gear when the vehicle is
parked on a uphill and in R
(Reverse) on a downhill, set the
parking brake, and place the igni-
W L R Q V Z L W F K L Q W K H / 2 & . 2 ) ) S R V L-
tion. Unexpected vehicle move-
ment may occur if these
precautions are not followed.To shift to R (Reverse), make sure
the vehicle has completely stopped,
and then move the shift lever to neu-
tral before moving into R (Reverse).
When you’ve come to a complete
V W R S D Q G L W
Page 287 of 486
6-31
06
Parking
To park your vehicle, always come to
a complete stop and continue to
depress the brake pedal.
Page 290 of 486
6-34
Whilst driving
Rear drum brakes
Your rear drum brakes do not have
wear indicators. Therefore, have the
rear brake linings inspected if you
hear a rear brake rubbing noise. Also
have your rear brakes inspected each
time you change or rotate your tyres
and when you have the front brakes
replaced.
Parking brake
2 $ & 7 8
Always set the parking brake before
O H D Y L Q J W K H Y H K L F O H W R D S S O \
Firmly depress the brake pedal.
3 X O O X S W K H S D U N L Q J E U D N H O H Y H U D V I D U
as possible.
WARNING
To reduce the risk of SERIOUS
INJURY or DEATH, do not operate
the parking brake whilst the vehi-
cle is moving except in an emer-
gency situation. It could damage
the brake system and lead to an
accident.
2 $ & 7 8
7 R U H O H D V H
Firmly depress the brake pedal.
Slightly pull up the parking brake
lever.
Whilst pressing the release button
O R Z H U W K H S D U N L Q J E U D N H
If the parking brake does not release
or does not release all the way, we
recommend that the system be
checked by a HYUNDAI authorised
repairer.
WARNING
Whenever leaving the vehicle or
parking, always come to a com-
plete stop and continue to depress
the brake pedal.
Move the shift lever into the 1st
gear (for Manual transmission
vehicle) or N (Neutral, for
Automated Manual Transmission
vehicle) position, then apply the
parking brake, and place the igni-
W L R Q V Z L W F K L Q W K H / 2 & . 2 ) ) S R V L-
tion.
Page 291 of 486
6-35
06
Parking brake warning light
& K H F N W K H 3 D U N L Q J % U D N H
Warning Light by placing
the ignition switch to the
ON position (do not start
the engine).
This light will be illuminated when the
parking brake is applied with the igni-
tion switch in the START or ON posi-
tion.
% H I R U H G U L Y L Q J E H V X U H W K H S D U N L Q J
E U D N H L V U H O H D V H G D Q G W K H % U D N H
Warning Light is OFF.
, I W K H 3 D U N L Q J % U D N H : D U Q L Q J / L J K W
remains on after the parking brake is
released whilst the engine is running,
there may be a malfunction in the
brake system. Immediate attention is
necessary.
If at all possible, cease driving the
vehicle immediately. If that is not pos-
sible, use extreme caution whilst
operating the vehicle and only con-
tinue to drive the vehicle until you can
reach a safe location.
Anti-lock Brake System (ABS)
WARNING
$ Q $ Q W L / R F N % U D N L Q J 6 \ V W H P
(ABS) or an Electronic Stability
Control (ESC) system will not pre-
vent accidents due to improper or
dangerous driving manoeuvres.
Even though vehicle control is
improved during emergency brak-
ing, always maintain a safe dis-
tance between you and objects
ahead of you. Vehicle speeds
should always be reduced during
extreme road conditions. The brak-
ing distance for vehicles equipped
with ABS or ESC may be longer
than for those without these sys-
tems in the following road condi-
tions.
Drive your vehicle at reduced
speeds during the following condi-
tions:
Page 300 of 486
6-44
Whilst driving
The ISG system is to reduce the fuel
consumption by automatically shut-
ting down the engine, when the vehi-
cle is at a standstill (i.e. red stop light,
V W R S V L J Q D Q G W U D I I L F M D P
The engine is automatically started
upon satisfying the starting condi-
tions.
The ISG system is always active,
when the engine is running.
i Information
When the engine is automatically
started by the IS * system, some warn-
ing lights (i.e. ABS, ESC, ESC 2FF,
EPS, and parking brake warning light)
may illuminate for a few seconds due
to the low battery voltage. +owever, it
does not indicate a malfunction with
the IS * system.
To activate the ISG system
Prerequisite for activation
The ISG system operates in the fol-
lowing situations.
‡ 7 K H G U L Y H U‹ V V H D W E H O W L V I D V W H Q H G
Page 349 of 486
6-93
06
Chain Installation
When installing tyre chains, follow the
manufacturer’s instructions and
mount them as tightly possible. Drive
V O R Z O \ O H V V W K D Q P S K N P K
with chains installed. If you hear the
chains contacting the body or chas-
sis, stop and tighten them. If they still
make contact, slow down until the
noise stops. Remove the tyre chains
as soon as you begin driving on
cleared roads.
When mounting snow chains, park
the vehicle on level ground away from
traffic. Turn on the vehicle Hazard
Warning Flasher and place a triangu-
lar emergency warning device behind
the vehicle (if available). Always
S O D F H W K H Y H K L F O H L Q 3 3 D U N D S S O \
the parking brake and turn off the
engine before installing snow chains.
NOTICE
When using tyre chains:
Page 350 of 486
6-94
Whilst driving
To prevent locks from freezing
To prevent the locks from being fro-
zen, spray approved de-icing fluid or
glycerin into key holes. When a lock
opening is already covered with ice,
spray approved de-icing fluid over the
ice to remove it. When an internal
part of a lock freezes, try to thaw it
with a heated key. Carefully use the
K H D W H G N H \ W R D Y R L G D Q L Q M X U \
Use approved window washer anti-
freeze solution in system
To prevent the window washer from
being frozen, add authorized window
washer anti-freeze solution, as speci-
fied on the window washer container.
Window washer anti-freeze solution
is available from a HYUNDAI autho-
rised repairer, and most vehicle
accessory outlets. Do not use engine
coolant or other types of anti-freeze
solution to prevent any damage to the
vehicle paint.
Do not let your parking brake
freeze
Under some conditions your parking
brake can freeze in the engaged posi-
tion.
This is most likely to happen when
there is an accumulation of snow or
ice around or near the rear brakes or
if the brakes are wet. When there is
the risk that your parking brake may
freeze, temporarily apply it with the
V K L I W O H Y H U L Q 1 I R U $ X W R P D W H G 0 D Q X D O
Transmission) or in first or reverse
gear (for manual transmission). Also,
block the rear wheels in advance, so
the vehicle may not roll. Then, release
the parking brake.Do not let ice and snow
accumulate underneath
Under some conditions, snow and ice
can build up under the fenders and
interfere with the steering. When driv-
ing in such conditions during the
severe winter, you should check
underneath the vehicle on a regular
basis, to ensure that the front wheels
and the steering components is
unblocked.
Carry emergency equipment
In accordance with weather condi-
tions, you should carry appropriate
emergency equipment, whilst driving.
Some of the items you may want to
carry include tyre chains, tow straps
or chains, flashlight, emergency
I O D U H V V D Q G V K R Y H O M X P S H U F D E O H V
window scraper, gloves, ground cloth,
coveralls, blanket, etc.
Do not place objects or materials
in the engine compartment
3 X W W L Q J R E M H F W V R U P D W H U L D O V L Q W K H
engine compartment may cause an
engine failure or combustion,
because they may block the engine
cooling. Such damage will not be
covered by the manufacturer’s war-
ranty.
Page 359 of 486
7-7
07
i , Q I R U P D W L R Q
3 E
An inappropriately disposed
battery can be harmful to the
environment and human
health. Dispose of the battery
according to your local law(s)
or regulations.
Jump starting procedure
1. Position the vehicles close enough
that the jumper cables will reach,
but do not allow the vehicles to
touch.
2. Avoid fans or any moving parts in
the engine compartment at all
times, even when the vehicles are
turned off.
3. Turn off all electrical devices such
as radios, lights, air conditioning,
etc. Put the vehicles in N (Neutral,
for Automated manual transmis-
sion vehicle) or neutral (for Manual
transmission vehicle), and set the
parking brakes. Turn both vehicles
OFF.
OAC3079002TU
4. Connect the jumper cables in the
exact sequence shown in the illus-
tration. First connect one jumper
cable to the red, positive (+) jump-
er terminal of your vehicle (1).
5. Connect the other end of the jump-
er cable to the red, positive (+) bat-
tery/jumper terminal of the assist-
ing vehicle (2).
6. Connect the second jumper cable
to the black, negative (-) battery/
chassis ground of the assisting
vehicle (3).
7. Connect the other end of the sec-
ond jumper cable to the black, neg-
ative (-) chassis ground of your
vehicle (4).
Do not allow the jumper cables to
contact anything except the correct
battery or jumper terminals or the
correct ground. Do not lean over
the battery when making connec-
tions.
