2022 HYUNDAI I10 instrument panel

Exterior overview (I)............................................................................................ 2-2
Exterior overview (II) .......................................................................................... 2-3
Interior overview ................................................................................................. 2-4
Instrument panel overview ................................................................................ 2-5
Engine compartment ......................................................................................... 2-7
Dimensions .........................................................................................................2-8
Engine specification ...........................................................................................2-8
Bulb wattage .......................................................................................................2-9
Tyres and wheels............................................................................................... 2-10
Air conditioning system..................................................................................... 2-11
Tyre load and speed capacity ........................................................................... 2-11
Gross vehicle weight ......................................................................................... 2-11
Luggage volume ................................................................................................ 2-11
Recommended lubricants and capacities .......................................................2-12
Recommended SAE viscosity number .........................................................2-13
Vehicle identification number (VIN) .................................................................2-14
Vehicle certification label ..................................................................................2-14
Tyre specification and pressure label ...............................................................2-15
Engine number ..................................................................................................2-15
Air conditioner compressor label .................................................................... 2-16
Fuel label ........................................................................................................... 2-16
Declaration of conformity ................................................................................. 2-17
2. Vehicle information
2

2-5
02
INSTRUMENT PANEL OVERVIEW
The actual shape may differ from the illustration.
OAC3019004R
1. Light control/Turn signals ..................................................................................... 5-36
2. Wipers and Washers ............................................................................................ 5-46
3. Instrument cluster ................................................................................................... 4-2
4. Horn ...................................................................................................................... 5-22
5. Steering wheel audio controls*............................................................................. 5-91
6. Cruise controls* .................................................................................................... 6-83
Manual Speed Limit Assist system switch* ........................................................... 6-69
7. Driver’s air bag ..................................................................................................... 3-42
8. Infotainment system* ............................................................................................ 5-91
+D]DUGZDUQLQJ

3-42
Safety system
Where are the air bags?
Driver’s and passenger’s air
bags (if equipped)
OAC3039036R
„Driver’s front air bag
„Passenger's front air bag
OAC3039037R
Your vehicle is equipped with a Sup-
plemental Restraint System (SRS)
and lap/shoulder belts at both the
driver and passenger seating posi-
tions.
The SRS consists of air bags which
are located in the center of the steer-
ing wheel and the passenger’s side
front panel pad above the glove box.
The air bags are labelled with the let-
ters “AIR BAG” embossed on the pad
covers.
The purpose of the SRS is to provide
the vehicle’s driver and front passen-
gers with additional protection than
that offered by the seat belt system
alone in case of a frontal impact of
sufficient severity.
WARNING
To reduce the risk of serious injury
or death from an inflating front air
bags, take the following precau-
tions:
‡Seat belts must be worn at all
times to help keep occupants
positioned properly.
‡Move your seat as far back as
possible from front air bags,
whilst still maintaining control of
the vehicle.
‡Never lean against the door or
centre console.
‡Do not allow the front passenger
to place their feet or legs on the
dashboard.
‡No objects (such as crash pad
cover, mobile phone holder, cup
holder, perfume or stickers)
should be placed over or near
the air bag modules on the steer-
ing wheel, instrument panel,
windscreen glass, and the front
passenger’s panel above the
glove box. Such objects could
cause harm if the vehicle is in a
crash severe enough to cause
the air bags to deploy.
‡Do not attach any objects on
front windscreen and inside mir-
ror.
‡Hold the steering wheel at the 9
o’clock and 3 o’clock positions,
to minimise the risk of injuries to
your hands and arms.

3-48
Safety system
SRS warning light
The SRS (Supplement Restraint
System) air bag warning light on the
instrument panel displays the air bag
symbol depicted in the illustration.
The system checks the air bag elec-
trical system for malfunctions. The
light indicates that there is a potential
problem with your air bag system,
which could include your side and/or
curtain air bags used for rollover pro-
tection (if equipped with rollover sen-
sor).
WARNING
If your SRS malfunctions, the air
bag may not inflate properly dur-
ing an accident increasing the risk
of serious injury or death.
If any of the following conditions
occur, your SRS is malfunction-
ing:
‡The light does not turn on for
approximately six seconds when
the ignition switch is in the ON
position.
‡The light stays on after illuminat-
ing for approximately six sec-
onds.
‡The light comes on whilst the
vehicle is in motion.
‡The light blinks when the engine
is running.
We recommend that a HYUNDAI
authorised repairer inspect the
SRS as soon as possible if any of
these conditions occur.During a frontal collision, sensors will
detect the vehicle’s deceleration. If
the rate of deceleration is high
enough, the control unit will inflate the
front air bags, at the time and with the
force needed.
The front air bags help protect the
driver and front passenger by
responding to frontal impacts in which
seat belts alone cannot provide ade-
quate restraint. When needed, the
side air bags help provide protection
in the event of a side impact or roll-
over by supporting the side upper
body area.
‡Air bags are activated (able to
inflate if necessary) only when the
ignition switch is in the ON position.
‡Air bags inflate in the event of cer-
tain frontal or side collisions to help
protect the occupants from serious
physical injury.
‡Generally, air bags are designed to
inflate based upon the severity of a
collision it’s direction etc. These
two factors determine whether the
sensors produce an electronic
deployment/inflation signal.
‡The front air bags will completely
inflate and deflate in an instant. It is
virtually impossible for you to see
the air bags inflate during an acci-
dent. It is much more likely that you
will simply see the deflated air bags
hanging out of their storage com-
partments after the collision.

3-57
03
SRS Care
The SRS is virtually maintenance-
free and there are no parts you can
safely service by yourself. If the SRS
air bag warning light does not illumi-
nate when the ignition switch is in the
ON position, or continuously remains
on, we recommend that the system
be immediately inspected by a
HYUNDAI authorised repairer.
We recommend any work on the SRS
system, such as removing, installing,
repairing, or any work on the steering
wheel, the front passenger’s panel,
front seats and roof rails be per-
formed by a HYUNDAI authorised
repairer. Improper handling of the
SRS system may result in serious
personal injury.
WARNING
To reduce the risk of serious injury
or death take the following precau-
tions:
‡Do not attempt to modify or dis-
connect the SRS components or
wiring, including the addition of
any kind of badges to the pad
covers or modifications to the
body structure.
‡Do not place objects over or near
the air bag modules on the steer-
ing wheel, instrument panel, and
the front passenger’s panel
above the glove box.
‡Clean the air bag pad covers with
a soft cloth moistened with plain
water. Solvents or cleaners could
adversely affect the air bag cov-
ers and proper deployment of
the system.
‡We recommend that inflated air
bags be replaced by a HYUNDAI
authorised repairer.
‡If components of the air bag sys-
tem must be discarded, or if the
vehicle must be scrapped, cer-
tain safety precautions must be
observed. Consult a HYUNDAI
authorised repairer for the nec-
essary information. Failure to
follow these precautions could
increase the risk of personal
injury.

5-21
05
Tilt steering / Telescope
steering
WARNING
Never adjust the steering wheel
whilst driving. You may lose steer-
ing control and cause severe per-
sonal injury, death or accidents.
i Information
After adjustment, sometimes the lock-
release lever may not lock the steering
wheel.
It is not a malfunction. 7his occurs
when two gears are not engaged cor-
rectly. In this case, adjust the steering
wheel again and then lock the steering
wheel.
OAC3059009R
To change the steering wheel angle
and height:
1. Pull down the lock-release lever
(1).
$GMXVW WKH VWHHULQJ ZKHHO WR WKH
desired angle (2) and height (3, if
equipped). Move the steering
wheel, so it points toward your
chest, not toward your face. Make
sure you can see the instrument
panel warning lights and gauges.
3. Pull up the lock-release lever to
lock the steering wheel in place.
Push the steering wheel both up and
down to be certain it is locked in posi-
tion.
CAUTION
Whilst adjusting the steering wheel
height, please do not push or pull
it hard since the fixture can be
damaged.

5-37
05
OHCR046344
Position light position ()
The position light, license plate light
and instrument panel light are turned
ON.
OHCR046345
+eadlight position ()
The headlight, position light, license
plate light and instrument panel light
are turned ON.
i Information
7he ignition switch must be in the 21
position to turn on the headlight.
High beam operation
OHCR046346
To turn on the high beam headlight,
push the lever away from you.
The high beam indicator will light
when the headlight high beams are
switched on.
To turn off the high beam headlight,
pull the lever towards you. The low
beams will turn on.
WARNING
Do not use high beam when there
are other vehicles approaching
you. Using high beam could
obstruct the other driver’s vision.
OHCR046349
To flash the high beam headlight, pull
the lever towards you, then release
the lever. The high beams will remain
ON as long as you hold the lever
towards you.

5-56
Convenient features
OAC3059103R
Instrument panel vents
The instrument panel vent air flow
FDQ EH GLUHFWHG XSGRZQ RU OHIWULJKW
XVLQJWKHYHQWDGMXVWPHQWOHYHU
7R FORVH WKH YHQW DGMXVWPHQW OHYHU
rotate it to the outer side till the end.
To open the vent, rotate it to the inner
side.
Temperature control
OAI3059119
The temperature will increase by
turning the knob to the right.
The temperature will decrease by
turning the knob to the left.
Air intake control
OAI3059106
The air intake control button is used
to select either Fresh mode (outside
air) or Recirculation mode (cabin air).
Recirculation mode
When Recirculation
mode is selected, air
from the passenger
compartment will be
recirculated through the
system and heated or
cooled according to the
function selected.
Fresh mode
When Fresh mode is
selected, air enters the
vehicle from outside and
is heated or cooled
according to the function
selected.