2022 HYUNDAI GENESIS GV70 spare tire

Maintenance
9-32
Tire Rotation
To equalize tread wear, Genesis
Branded Vehicle recommends that
the tires be rotated according to the
maintenance schedule or sooner if
irregular wear develops.
During rotation, check the tires for
correct balance.
When rotating tires, check for
uneven wear and damage. Abnormal
wear is usually caused by incorrect
tire pressure, improper wheel
alignment, out-of-balance wheels,
severe braking or severe cornering.
Look for bumps or bulges in the
tread or side of the tire. Replace
the tire if you find any of these
conditions. Replace the tire if fabric
or cord is visible. After rotation, be
sure to bring the front and rear tire
pressures to specification and check
wheel bolt tightness (proper torque
is 101~116 lbf.ft [14~16 kgf.m]).
OHI078078OHI078078
Disc brake pads should be inspected
for wear whenever tires are rotated.
Information
The outside and inside of the
unsymmetrical tire is distinguishable.
When installing an unsymmetrical
tire, be sure to install the side marked
“outside” face the outside. If the side
marked “inside” is installed on the
outside, it will have a negative effect
on vehicle performance.
WARNING
• Do not use the compact spare
tire for tire rotation.
• Do not mix bias ply and radial ply
tires under any circumstances.
This may cause unusual handling
characteristics that may cause
loss of vehicle control resulting in
an accident.

Maintenance
9-34
Compact spare tire replacement
(if equipped)
A compact spare tire has a shorter
tread life than a regular size tire.
Replace it when you can see the
tread wear indicator bars on the tire.
The replacement compact spare tire
should be the same size and design
tire as the one provided with your
new vehicle and should be mounted
on the same compact spare tire
wheel. The compact spare tire is
not designed to be mounted on a
regular size wheel, and the compact
spare tire wheel is not designed for
mounting a regular size tire.
WARNING
The original tire should be repaired
or replaced as soon as possible to
avoid failure of the spare and loss
of vehicle control resulting in an
accident. The compact spare tire
is for emergency use only. Do not
operate your vehicle over 50 mph
(80 km/h) when using the compact
spare tire.
Wheel Replacement
When replacing the metal wheels
for any reason, make sure the new
wheels are equivalent to the original
factory units in diameter, rim width
and offset.
Tire Traction
Tire traction can be reduced if you
drive on worn tires, tires that are
improperly inflated or on slippery
road surfaces. Tires should be
replaced when tread wear indicators
appear. To reduce the possibility of
losing control, slow down whenever
there is rain, snow or ice on the road.
Tire Maintenance
In addition to proper inflation,
correct wheel alignment helps to
decrease tire wear. If you find a tire
is worn unevenly, have your dealer
check the wheel alignment.
When you have new tires installed,
make sure they are balanced. This
will increase vehicle ride comfort
and tire life. Additionally, a tire
should always be rebalanced if it is
removed from the wheel.

Maintenance
9-36
Tire speed ratings
The chart below lists many of the
different speed ratings currently
being used for passenger vehicle
tires. The speed rating is part of the
tire size designation on the sidewall
of the tire. This symbol corresponds
to that tire’s designed maximum safe
operating speed.
Speed Rating
SymbolMaximum Speed
S 112 mph (180 km/h)
T 118 mph (190 km/h)
H 130 mph (210 km/h)
V 149 mph (240 km/h)
W 168 mph (270 km/h)
Y 186 mph (300 km/h)
3. Checking tire life (TIN : Tire
Identification Number)
Any tires that are over six years old,
based on the manufacturing date,
(including the spare tire) should be
replaced by new ones. You can find
the manufacturing date on the tire
sidewall (possibly on the inside of
the wheel), displaying the DOT Code.
The DOT Code is a series of numbers
on a tire consisting of numbers and
English letters. The manufacturing
date is designated by the last four
digits (characters) of the DOT code.
DOT : XXXX XXXX OOOO
The front part of the DOT shows a
plant code number, tire size and
tread pattern and the last four
numbers indicate week and year
manufactured.
For example:
DOT XXXX XXXX 5221 represents that
the tire was produced in the 52nd
week of 2021.
4. Genesis exclusive tire
Genesis Branded Vehicle
recommends that tires designed
specifically for Genesis vehicles
be used. You may find the marking
“GOE” (Genesis Original Equipment)
embossed on the tire sidewall.
5. Tire ply composition and material
The number of layers or plies of
rubber-coated fabric in the tire. Tire
manufacturers also must indicate the
materials in the tire, which include
steel, nylon, polyester, and others.
The letter “R” means radial ply
construction; the letter “D“ means
diagonal or bias ply construction;
and the letter “B” means belted-bias
ply construction.

I
I -7
G
Genesis Digital Key ........................................................................\
....................5-13
Digital Key (Card Key) ........................................................................\
...........5-20
Digital Key (Smart Phone) ........................................................................\
......5-13
Limitations of the System ........................................................................\
.......5-26
Personalized User Profile and Vehicle Settings ..............................................5-23
Used Vehicle/Digital Key Maintenance ..........................................................5-26
Guide to Genesis Parts ........................................................................\
...................1-3
H
Hazard Warning Flasher ........................................................................\
................8-2
Head-Up Display (HUD) ........................................................................\
.............5-86
Head-Up Display Information........................................................................\
.5-86
Head-Up Display Settings ........................................................................\
.......5-86
Precautions While Using the Head-Up Display ..............................................5-87
High Beam Assist (HBA) ........................................................................\
............5-96
High Beam Assist Malfunction and Limitations .............................................5-97
High Beam Assist Operation ........................................................................\
...5-97
High Beam Assist Settings ........................................................................\
......5-96
Highway Driving Assist (HDA) ........................................................................\
7-109
Highway Driving Assist Malfunction and Limitations .................................7-118
Highway Driving Assist Operation ................................................................7-111
Highway Driving Assist Settings ..................................................................7-110
I
Idle Stop and Go (ISG) ........................................................................\
................6-47
Forced to Restart Engine ........................................................................\
.........6-50
ISG Malfunction........................................................................\
......................6-50
ISG System Off ........................................................................\
......................6-49
ISG System Operation........................................................................\
.............6-47
If the Engine Overheats ........................................................................\
.................8-7
If the Engine Will Not Start ........................................................................\
...........8-3
If You Have a Flat Tire (With Spare Tire) ...........................................................8-13
Changing Tires ........................................................................\
........................8-14
Jack and Tools ........................................................................\
.........................8-13
Jack Label........................................................................\
................................8-19