2022 HYUNDAI GENESIS G70 fuse

Maintenance
9-58
Rear fuse box panel
Fuse Name Fuse Rating Circuit Protected
DCU2 15A Dosing Control Module
DCU3 15A Dosing Control Module
REAR WIPER 15A Wipre RR Relay, Rear Wiper Motor
ECS 15A ECS Unit
POWER TRUNK 30A Power Trunk Module, Power Tailgate Unit
DCU1 15A Dosing Control Module
FUEL PUMP 20A Fuel Pump Relay
HEAT MIRROR 10A A/C Switch, Driver/Passenger Power Outside Mirror
AMP2 25A AMP
REAR S/HEAT 20A Rear Seat Warmer Control Module
AMP1 30A[W/O ISG] Fuse - F9
[With ISG] Low DC-DC Converter (AMP)
IG1 15A PCB Block (IG1 Relay)
ACC 30A ICU Junction Block (Fuse - F32, F40, F54)
B+1 40AICU Junction Block
(IPS5, IPS6, IPS7, IPS8, IPS9, IPS10, Fuse - F20, 30F)
B+2 40A ICU Junction Block (IPS1, IPS2, Fuse - F15, F39)
REAR HEATED 30A Rear Heated Relay

09
9-59
Trunk fuse panel (Battery junction
block)
OIK090034
Inside the fuse/relay box cover, you can
find the fuse/relay label describing fuse/
relay names and ratings.
Information
Not all fuse panel descriptions in this
manual may be applicable to your vehicle;
the information is accurate at the time of
printing. When you inspect the fuse panel
in your vehicle, refer to the fuse panel
label.

Maintenance
9-60
Battery box fuse panel
Fuse Name Fuse Rating Circuit Protected
B+1 100ARear Sub Junction Block
(ACC Relay, Fuse - F7, F12, F13, F16, F17)
B+2 100ARear Sub Junction Block
(DCU Relay, Fuse - F3, F5, F4, F11, F15)
START 40AE/R Junction Block (Fuse - F3),
PCB Block (Fuse - F3, F9)
AMS 10A Battery Sensor

09
9-61
Consult an authorized retailer of
Genesis Branded products to replace
most vehicle light bulbs. It is difficult
to replace vehicle light bulbs because
other parts of the vehicle must be
removed before you can get to the bulb.
This is especially true for removing the
headlamp assembly to get to the bulb(s).
Removing/installing the headlamp
assembly can result in damage to the
vehicle.
WARNING

[Prior to working on a light, depress
the foot brake, shift to P (Park), apply
the parking brake, press the Engine
Start/Stop button to the OFF position
and take the key with you when
leaving the vehicle to avoid sudden
movement of the vehicle and to
prevent possible electric shock.

[Be aware the bulbs may be hot and
may burn your fingers.
NOTICE
Be sure to replace the burned-out bulb
with one of the same wattage rating.
Otherwise, it may cause damage to the
fuse or electrical wiring system.
NOTICE
To prevent damage, do not clean the
headlamp lens with chemical solvents
or strong detergents.
Information
The headlamp and tail lamp lenses could
appear frosty if the vehicle is washed after
driving or the vehicle is driven at night in
wet weather. This condition is caused by
temperature difference between the lamp
inside and outside and, it does not indicate
a problem with your vehicle. When
moisture condenses in the lamp, it will be
removed after driving with the headlamp
on. The removable level may differ
depending on lamp size, lamp position
and environmental condition. However, if
moisture is not removed, have the vehicle
inspected by an authorized retailer of
Genesis Branded products.
Information

[A normally functioning lamp may
flicker momentarily to stabilize the
vehicle’s electrical control system.
However, if the lamp goes out after
flickering momentarily, or continues to
flicker, have the system checked by an
authorized retailer of Genesis Branded
products.

[The parking lamp may not turn on
when the parking lamp switch is turned
on, but the parking lamp and headlamp
switch may turn on when the headlamp
switch is turned on. This may be caused
by network failure or vehicle electrical
control system malfunction. If this
occurs, have the system checked by an
authorized retailer of Genesis Branded
products.
Information
The headlamp aiming should be adjusted
after an accident or after the headlamp
assembly is reinstalled at an authorized
retailer of Genesis Branded products.
LIGHT BULBS