Page 294 of 506

06
6-53
Launch control on and off (For
Manual transmission)
1. Select N mode with ‘N’ button (N mode indicator will illuminate on
the cluster) or select SPORT+ for the
engine mode in CUSTOM mode.
2. Check that the ESC mode is ESC SPORT mode or ESC OFF. If not, press
ESC OFF button to set the ESC mode
to ESC SPORT mode or ESC OFF.
(Electronic Stability Control (ESC)
does not operate when ESC OFF.)
3. Select 'Performance Options → Launch Control' to set engine RPM from the
Infotainment system screen. After
setting RPM, press 'Activate’.
4. Align the steering wheel straight
5. Depress the clutch pedal.
6. Shift to 1st gear.
7. While depressing the clutch pedal with your left foot, quickly and fully
depress the accelerator pedal with
your right foot. Launch control will
be in the ready state. The message
'Launch Control Ready' will appear on
the cluster. If necessary, adjust engine
rpm with +/- switch on the steering
wheel.
8. A smooth, quick release of the clutch pedal within 8 seconds,
while maintaining full depression
of the accelerator pedal will initiate
launching of the vehicle. The message
'Launch Control Active' will appear on
the cluster.
9. Control will deactivate when the accelerator pedal is released.
Launch control on and off (For Dual
clutch transmission)
1. Select N mode with 'N' button (N-mode indicator lights up on
cluster) or select SPORT+ for the
engine mode in custom mode.
2. Check that the ESC mode is ESC SPORT or ESC OFF. If not, press
button to set the ESC mode to ESC
SPORT or ESC OFF.(Indicator lights on
the cluster)(Vehicle dynamic control
device does not operate when ESC
OFF.)
3. Put the transmission gear on 'D'(driving) or 'M' (manual mode)
position.(driver must shift by yourself
when manual mode is selected.)
4. In Launch Control tab of Navigation's Performance Options, select rpm
and press ‘Activate’ button.(N mode
→ Performance Option → Launch
Control) (button lights on when
activated)
5. Align the steering wheel straight.
6. Press brake pedal to maximum with your left foot.
7. When you press the brake pedal with your left foot and quickly press and
hold accelerator pedal with your right
foot, you are ready for launch control.
When it is ready, the text “Launch
Control Ready” is displayed. RPM
value can be adjusted with +/- switch
on the steering wheel.
8. Release your foot gently off the brake pedal within 8 seconds to launch
the vehicle, keeping accelerator
pedal fully pressed. Launch Control
is activated and the text“ Launch
Control Active” is displayed.
9. Launch control is deactivated when you release accelerator pedal.
CN7 N HMA 6.indd 6-53 2021-09-14 9:42:35
Page 405 of 506

08
8-13
TPMS (Tire Pressure
Monitoring System)
Malfunction Indicator
The TPMS Malfunction Indicator
will illuminate after it blinks for
approximately one minute when there
is a problem with the Tire Pressure
Monitoring System.
Have the system be checked by an
authorized HYUNDAI dealer.
NOTICE
If there is a malfunction with the TPMS,
the Low Tire Pressure Position Telltale
will not be displayed even though the
vehicle has an under-inflated tire.
NOTICE
The TPMS Malfunction Indicator may
illuminate after blinking for one minute
if the vehicle is near electric power
supply cables or radio transmitters
such as police stations, government
and public offices, broadcasting
stations, military installations, airports,
transmitting towers, etc.
Additionally, the TPMS Malfunction
Indicator may illuminate if snow chains
are used or electronic devices such as
computers, chargers, remote starters,
navigation, etc. This may interfere with
normal operation of the TPMS.
Changing a Tire with TPMS
If you have a flat tire, the Low Tire
Pressure and Position telltales will come
on. Have the flat tire be repaired by an
authorized HYUNDAI dealer as soon as
possible or replace the flat tire with the
spare tire.
NOTICE
It is recommended that you do not use a
puncture-repairing agent not approved
by a HYUNDAI dealer to repair and/or
inflate a low pressure tire. Tire sealant
not approved by a HYUNDAI dealer may
damage the tire pressure sensor.
The spare tire (if equipped) does not
come with a tire pressure monitoring
sensor. When the low pressure tire or the
flat tire is replaced with the spare tire,
the Low Tire Pressure Telltale will remain
on. Also, the TPMS Malfunction Indicator
will illuminate after blinking for one
minute if the vehicle is driven at speed
above 22mph (35km/h) for approximately
10 minutes.
Once the original tire equipped with
a tire pressure monitoring sensor is
reinflated to the recommended pressure
and reinstalled on the vehicle, the
Low Tire Pressure Telltale and TPMS
Malfunction Indicator will go off within a
few minutes of driving.
If the indicators do not extinguish after a
few minutes, please visit an authorized
HYUNDAI dealer.
CN7 N HMA 8.indd 8-132021-09-06 4:18:12
Page 468 of 506
09
9-51
Driver’s side fuse panel
Fuse NameFuse Rating Circuit Protected
MEMORY1 10
ADriver/Passenger Power Outside Mirror, Instrument
Cluster, A/C Controller, A/C Control Module
AIR BAG2 10A SRS Control Module
MODULE4 10AFront View Camera, Crash Pad Switch, IBU, Front Console
Switch, E-LSD Controller, ECS Controller
MODULE7 7.5A Rear Seat Warmer Control Module, IAU
START 7.5A PCM/ECM IBU, E/R Junction Block(RLY.5)
CLUSTER 7.5A Instrument Cluster
IBU2 7.5A IBU
A/C1 7.5AE/R Junction Block(RLY.13), A/C Control Module, A/C
Controller, PTC HEATER RLY
TRUNK 10A Trunk Lid Latch
S/HEATER FRT 20AFront Air Ventilation Seat Control Module, Front Seat
Warmer Control Module
P/WINDOW LH 25A
Power Window Main Switch, Passenger Power Window
Switch
MULTIMEDIA 15A Audio, A/V & Navigation Head Unit
CN7 N HMA 9.indd 9-51
2021-09-08 9:30:27
Page 469 of 506

Maintenance9-52
Driver’s side fuse panel
Fuse Name Fuse Rating Circuit Protected
MDPS1 7
.5A MDPS Unit
MODULE6 7.5A IBU
S/HEATER RR 20A Rear Seat Warmer Control Module
SAFETY P/
WINDOW DRV 25A Driver Safety Power Window Module
P/WINDOW RH 25A
Power Window Main Switch, Passenger Power Window
Switch
BRAKE
SWITCH 10A Stop Lamp Switch, IBU
IBU1 15A IBU
MODULE2 10AE/R Junction Block(RLY.2), Power Outside Mirror Switch,
AMP, IBU, Audio, A/V & Navigation Head Unit, IAU
AIR BAG1 15A SRS Control Module, ODS(Occupant Detection System)
MODULE5 10AFront Wirelesscharger, Crash Pad Switch, Electro Chromic
Mirror, A/C Controller, A/C Control Module, Audio, A/V &
Navigation Head Unit, Data Link Connector, AMP, Rear
Seat Warmer Control Module, Front Air Ventilation Seat
Control Module, Front Seat Warmer Control Module, Head
Lamp Leveling Device LH/RH, TGS Indicator
AMP 25A AMP
HEATED
MIRROR 10A
Driver/Passenger Power Outside Mirror, A/C Control
Module, A/C Controller
CN7 N HMA 9.indd 9-52
2021-09-08 9:30:27
Page:
< prev 1-8 9-16 17-24