2022 HYUNDAI ELANTRA N Engine compartment

Maintenance9-48
Instrument Panel Fuse
Replacement
OCN7N091011NOCN7N091011N
1. Turn the vehicle off.
2. Turn all other switches OFF.
3. Open the fuse panel cover.
4. Refer to the label on the inside of the fuse panel cover to locate the
suspected fuse location.
OCN7080018OCN7080018
5. Pull the suspected fuse straight out. Use the removal tool provided in the
engine compartment fuse panel.
6. Check the removed fuse; replace it if it is blown. Spare fuses are provided in
the engine compartment fuse panel.
7. Push in a new fuse of the same rating, and make sure it fits tightly in
the clips. If it fits loosely, consult an
authorized HYUNDAI dealer.
In an emergency, if you do not have a
spare fuse, use a fuse of the same rating
from a circuit you may not need for
operating the vehicle.
If the head lamp, turn signal lamp, tail
lamp, interior lamp doesn’t work and
the bulbs are undamaged, consult an
authorized HYUNDAI dealer.
CN7 N HMA 9.indd 9-48 2021-09-08  9:30:24

09
9-49
Engine Compartment Panel Fuse
Replacement
Blade type fuseBlade type fuse
OCN7080021OCN7080021
Cartridge type fuseCartridge type fuse
OCN7080022OCN7080022
1. Turn the engine off.
2. Turn all other switches OFF.
3. Remove the fuse panel cover by pressing the tap and pulling up.
4. Check the removed fuse; replace it if it is blown. To remove or insert the
fuse, use the fuse puller in the engine
compartment fuse panel.
5. Push in a new fuse of the same rating, and make sure it fits tightly in
the clips. If it fits loosely, consult an
authorized HYUNDAI dealer.
NOTICE
After checking the fuse panel in the
engine compartment, securely install
the fuse panel cover. You may hear a
clicking sound if the cover is securely
latched. If it is not securely latched,
electrical failure may occur from water
contact.
Multi fuse (Main fuse)
OCN7080020OCN7080020
If the multi fuse is blown, it must be
removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the fuse panel cover by pressing the tab and pulling it up.
4. Remove the nuts shown in the picture above.
5. Replace the fuse with a new one of the same rating.
6. Reinstall in the reverse order of removal.
Information
If the multi fuse is blown, consult an
authorized HYUNDAI dealer.
CN7 N HMA 9.indd 9-49 2021-09-08  9:30:25

Maintenance9-54
OCN7N091013N
Engine compartment fuse panel
ODN8089017ODN8089017
Inside the fuse/relay box cover, you can
find the fuse/relay label describing fuse/
relay names and ratings.
Information
Not all fuse panel descriptions in this
manual may be applicable to your vehicle;
the information is accurate at the time of
printing. When you inspect the fuse panel
in your vehicle, refer to the fuse panel
label.
CN7 N HMA 9.indd 9-54 2021-09-08  9:30:27

09
9-55
Engine compartment fuse panel
Type Fuse NameFuse Rating Circuit Protected
MIDI
FUSE
-3 ALT
180A[G4FM/G4FG/G4NA] Alternator, (Fuse - F33, F34,
F35, F37)
[G4FP] Alternator, (Fuse - F33, F34, F35, F37)
MDPS1 100A MDPS Unit
MIDI
FUSE-2 COOLING
FAN2 80A [G4FP] Cooling Fan Controller
EOP 60A Electronic Oil Pump
RR HTD 50A Rear Glass Heated
MIDI
FUSE-1 B+5
60APCB Block (Engine Control Relay, Fuse - F1, F2,
F3, F4, F6)
B+1 60A ICU Junction Block (IPS2/IPS5/IPS6/IPS7/IPS14)
B+2 60AICU Junction Block (IPS1/IPS4/IPS8/IPS9/IPS10/
IPS13)
B+3 50AICU Junction Block (Fuse - F13, F14, F22, F23,
F32,F40, F41, Long Term Load Latch Relay)
BLOWER 40A BLOWER Motor, Multipurpose Check Connector
IG1 40A E/R Junction Block (RLY.4/6), Ignition Switch
IG2 40A E/R Junction Block (RLY.3/5), Ignition Switch
DCT1 60A TCU
PTC
HEATER 50A PTC HEATER
CN7 N HMA 9.indd 9-55
2021-09-08  9:30:27

Maintenance9-56
Engine compartment fuse panel
Type Fuse Name Fuse Rating Circuit Protected
FUSE POWER
OUTLET2 20
A Front Power Outlet
POWER
OUTLET3 20A Cigarette Lighter
VACUUM PUMP1 20A VACUUM PUMP, ESC
VACUUM PUMP2 10A Electronic Vacuum Pump
ECS 15A ECS Unit
E-LSD 20A LSD Control Module
E-CVVT3 20A ECM
E-CVVT2 20A ECM
E-CVVT1 40A E/R Junction Block (RLY.14)
DCT2 10A [G4FP] TCM
B+4 40AICU Junction Block (Fuse - F2, F25, F26, F34,
F43, F35 (IAU), F44, Power Window Relay)
AMS 10A Battery Sensor
TCU1 10A [M/T] Ignition Lock & Clutch Switch
FUEL PUMP 20A FUEL PUMP Motor
ABS1 40A ABS Control Module, ESP Control Module
ABS2 30AABS Control Module, ESP Control Module,
Multipurpose Check Connector
POWER
OUTLET1 40A E/R Junction Block (RLY.2)
WIPER 25A Wiper Motor
CN7 N HMA 9.indd 9-56
2021-09-08  9:30:27

09
9-57
Engine compartment fuse panel (PCB block) (Smartstream 2.5 GDI)
Type Fuse NameFuse Rating Circuit Protected
FUSE E
CS (15A)
15A ECS Unit
A/C 10A [G4FM] A/C Compressor
HORN 15A Horn, Horn Switch
IGN COIL 20A[G4FM/G4NA/G4FP] Ignition Coil #1~#4
[G4FG] Ignition Coil #1~#4
ECU3 10A PCM/ECM, [MT] IGN LOCK CLUTCH SW
SENSOR3 10A E/R Junction Block (RLY.8)
ECU2 15A PCM/ECM
SENSOR2 10A[G4FM] Oil Control Valve (Intake/Exhaust),
Variable Intake Solenoid Valve, Purge Control
Solenoid Valve, E/R Junction Block (RLY.1/11),
A/C Relay
[G4FG] Oil Control Valve (Intake/Exhaust),
Variable Intake Solenoid Valve, Purge Control
Solenoid Valve, E/R Junction Block (RLY.1/11)
[G4NA] Oil Control Valve (Intake/Exhaust),
Variable Intake Solenoid Valve, Purge Control
Solenoid Valve, Oil Pump Solenoid Valve, E/R
Junction Block (RLY.1/11)
[G4FP] Oil Control Valve (Intake/Exhaust),
Variable Intake Solenoid Valve, Purge Control
Solenoid Valve, RCV Control Solenoid Valve,
Cooling Fan Controller
[Theta 2 T-GDI] Oil Control Valve(Exhaust),
Electronic Water Pump, RCV, Cooling Fan, Purge
Control Solenoid Valve, A/C Comp RLY, Oil Level
Sensor, Canister Closing Valve, Active Exhaust
Valve
SENSOR1 15A Oxygen Sensor (UP/DOWN)
ABS3 10AABS Control Module, ESP Control Module,
Multipurpose Check Connector
ECU1 20A PCM/ECM
CN7 N HMA 9.indd 9-57
2021-09-08  9:30:28

Maintenance9-66
High-pressure washing
• When using high-pressure washers, mak
e sure to maintain sufficient
distance from the vehicle.
Insufficient clearance or excessive
pressure can lead to component
damage or water penetration.
• Do not spray the camera, sensors or its surrounding area directly with a
high pressure washer. Shock applied
from high pressure water may cause
the device to not operate normally.
• Do not bring the nozzle tip close to boots (rubber or plastic covers) or
connectors as they may be damaged
if they come into contact with high
pressure water.
WARNING
After washing the vehicle, test the
brakes while driving slowly to see
if they have been affected by water
before getting on the road. If braking
performance is impaired, dry the
brakes by applying them lightly while
maintaining a slow forward speed.
NOTICE
• Do not use strong soap, chemical
detergents or hot water, and do not
wash the vehicle in direct sunlight
or when the body of the vehicle is
warm.
• Be careful when washing the side
windows of your vehicle.
• Especially, with high-pressure water,
water may leak through the windows
and wet the interior.
• To prevent damage to the plastic
parts, do not clean with chemical
solvents or strong detergents.
NOTICE
OCN7N091016NOCN7N091016N
• Water washing in the engine
compartment including high
pressure water washing may cause
the failure of electrical circuits
located in the engine compartment.
• Never allow water or other liquids
to come in contact with electrical/
electronic components inside the
vehicle as this may damage them.
NOTICE
Matte paint finish vehicle (if equipped)
Automatic car wash which uses rotating
brushes should not be used as this can
damage the surface of your vehicle. A
steam cleaner which washes the vehicle
surface at high temperature may result
the oil to adhere and leave stains that is
difficult to remove.
Use a soft cloth (for example, microfiber
towel or sponge) when washing your
vehicle and dry with a microfiber towel.
When you hand wash your vehicle, you
should not use a cleaner that finishes
with wax. If the vehicle surface is too
dirty (sand, dirt, dust, contaminant,
etc.), clean the surface with water
before washing the car.
CN7 N HMA 9.indd 9-66 2021-09-08  9:30:32

IndexI-4
D
Declaration of conformity........................................................................\
............ 7-78
Dimensions .............................................................\
............................................... 2-8
Drive Mode Integrated Control System ............................................................... 6-44
Drive Mode ........................................................................\
.............................. 6-44
N Mode ........................................................................\
..................................... 6-46
NGS (N Grin Shift) ........................................................................\
.................. 6-48
Vehicle Characteristic ........................................................................\
............... 6-49
Driver Attention Warning (DAW) ...................................................................... 7-43
Driver Attention Warning Malfunction and Limitations .................................. 7-47
Driver Attention Warning Operation ................................................................ 7-45
Driver Attention Warning Settings .................................................................. 7-43
Dual Clutch Transmission ........................................................................\
........... 6-18
Dual Clutch Transmission Operation ............................................................... 6-18
Good Driving Practices ........................................................................\
............ 6-27
LCD Display for Transmission Temperature and Warning Message ............... 6-20
Paddle Shifter (Manual Shift Mode) ............................................................... 6-26
Parking ........................................................................\
..................................... 6-26
E
Electronic Control Suspension (ECS) ................................................................. 6-40
Electronic Limited Slip Differential .................................................................... 6-41
Warning messages ........................................................................\
.................... 6-42
Emission Control System ........................................................................\
............ 9-73
Engine Compartment ........................................................................\
............. 2-7, 9-3
Engine Coolant ........................................................................\
............................ 9-19
Changing Engine Coolant ........................................................................\
........ 9-22
Checking the Engine Coolant Level ................................................................. 9-19
Engine Number ........................................................................\
............................ 2-15
Engine Oil ........................................................................\
.................................... 9-16
Checking the Engine Oil and Filter .................................................................. 9-17
Checking the Engine Oil Level ........................................................................\
9-16
Engine Specification ........................................................................\
...................... 2-8
Engine Start/Stop Button ........................................................................\
.............. 6-5
Explanation of Scheduled Maintenance Items .................................................... 9-14
Drive Axle Shafts and Boots ........................................................................\
.... 9-15
Dual clutch transmission fluid ........................................................................\
. 9-15
CN7 N HMA Index.indd I-4 2021-09-08  11:16:48