2022 HYUNDAI ELANTRA N clock

08
8-23
WARNING
If your vehicle is equipped with a
rollover sensor, set the Engine Start/
Stop button in the OFF or ACC position
when the vehicle is being towed.
The side impact and curtain air bag
may deploy if the sensor detects the
situation as a rollover.
OCN7N081098LOCN7N081098L
When towing your vehicle in an
emergency without wheel dollies:
1. Set the Engine Start/Stop button in the ACC position.
2. Place the shift lever in N (Neutral).
3. Release the parking brake.
CAUTION
Failure to place the shift lever in N
(Neutral) when being towed with the
front wheels on the ground can cause
internal damage to the transmission.
Emergency Towing
If towing is necessary, have it done by
an authorized HYUNDAI dealer or a
commercial tow truck service.
Removable Towing Hook
OCN7N081006NOCN7N081006N
1. Open the trunk, and remove the towing hook from the tool case.
OCN7N081007NOCN7N081007N
2. Remove the hole cover by pressing the lower part of the cover on the
bumper.
3. Install the towing hook by turning it clockwise into the hole until it is fully
secured.
4. Remove the towing hook and install the cover after use.
CN7 N HMA 8.indd 8-23 2021-09-06  4:18:16

Maintenance9-20
WARNING
Make sure the coolant cap is properly
closed after refilling coolant. Otherwise
the engine could be overheated while
driving.
Engine compartment front viewEngine compartment front view
ODN8089052LODN8089052L
1. Check if the coolant cap label is straight in front.
OCN7N091004 OCN7N091004
2. Make sure that the tiny protrusions inside the coolant cap is securely
interlocked.
WARNING
Never remove the engine
coolant cap or the drain plug
while the engine and radiator
are hot. Hot coolant and steam
may blow out under pressure,
causing serious injury.
Turn the vehicle off and wait until the
engine cools down. Use extreme care
when removing the engine coolant cap.
Wrap a thick towel around it, and turn
it counterclockwise slowly. Step back
while the pressure is released from the
cooling system. When you are sure all
the pressure has been released, using
a thick towel, and continue turning
counterclockwise to remove it.
Information
The coolant level is influenced by the
engine temperature. Before checking or
refilling the coolant, turn the engine off.
CN7 N HMA 9.indd 9-20 2021-09-08  9:30:16

09
9-59
Headlamp, Position Lamp,
Turn Signal Lamp and Daytime
Running Light Bulb Replacement
OCN7N091028NOCN7N091028N
(1) Headlamp (Low)
(2) Headlamp (High)
(3) Position lamp / Daytime running lamp (DRL)
(4) Turn signal lamp
(5) Side marker
Headlamp/Daytime running light (DRL) /
Position lamp (LED type)
If the LED lamp does not operate, have
the s
ystem inspected by an authorized
HYUNDAI dealer.
The LED lamps cannot be replaced as
a single unit because it is an integrated
unit. The LED lamps has to be replaced
with the unit.
A skilled technician should check or
repair the LED lamp, for it may damage
related parts of the vehicle.
OCN7080043OCN7080043
Turn signal lamp
1. Open the hood.
2.

Disconnect the negative battery
cable.
3. Remove the socket from the assembly by turning the
socketcounterclockwise until the
tabs on the socket align with the slots
onthe assembly.
4. Remove the bulb from the socket by pressing it in and rotating
itcounterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the socket.
5. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
6. Install the socket in the assembly by aligning the tabs on the socket with
the slots in the assembly.
7. Push the socket into the assembly and turn the socket clockwise.
Lamps
If the LED lamp does not operate, have
the v
ehicle checked by an authorized
HYUNDAI dealer.
CN7 N HMA 9.indd 9-59 2021-09-08  9:30:28

09
9-61
Turn signal lamp (Outer lamp) (Bulb
type)
1. Open the trunk lid.
OCN7080045OCN7080045
2. Remove the service cover by pulling out the service cover.
OCN7080046OCN7080046
3. Loosen the assembly retaining nuts.
OCN7080047OCN7080047
4. Remove the rear combination light assembly from the body of the
vehicle.
OCN7N091034LOCN7N091034L[1] : Turn signal lamp
5. Remove the socket from the assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on the
assembly.
6. Remove the bulb from the socket by pressing it in and rotating it
counterclockwise until the tabs on the
bulb align with the slots in the socket.
Pull the bulb out of the socket.
7. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
8. Install the socket in the assembly by aligning the tabs on the socket with
the slots in the assembly. Push the
socket into the assembly and turn the
socket clockwise.
CN7 N HMA 9.indd 9-61 2021-09-08  9:30:29

Maintenance9-62
Reverse lamp (Inner lamp) (Bulb
type)
1. Disconnect the connector and then remove the nuts by turning the nuts
counter clockwise.
2. Take the light assembly out.
OCN7080053OCN7080053
3. Remove the socket from the assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on the
assembly.
4. Remove the bulb by pulling it out.
5. Insert a new bulb by inserting it into the socket.
6. Install the light assembly to the trunk.
7. Reinstall the trunk lid cover by pushing in the screw.
Fog lamp (if equipped)
If the lamp does not operate, have
the v
ehicle checked by an authorized
HYUNDAI dealer.
High Mounted Stop Lamp
Replacement
OCN7N091031NOCN7N091031N
OAD075042OAD075042[A] : High mounted stop lamp
1. Open the trunk.
2. Remove the socket by turning it counterclockwise until the tabs on the
socket align with the slots.
3. Remove the bulb from the socket by pressing it in and rotating it
counterclockwise until the tabs on the
bulb align with the slots in the socket.
Pull the bulb out of the socket.
4. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
5. Install the socket in the assembly by aligning the tabs on the socket with
the slots in the assembly.
Push the socket into the assembly and
turn the socket clockwise.
CN7 N HMA 9.indd 9-62 2021-09-08  9:30:31

I
I-7
Interior Features ........................................................................\
......................... 5-108
Clock ........................................................................\
...................................... 5-112
Coat Hook ........................................................................\
.............................. 5-113
Cup Holder ........................................................................\
............................. 5-108
Power Outlet ........................................................................\
........................... 5-109
Sunvisor ........................................................................\
.................................. 5-109
Wireless Cellular Phone Charging System ..................................................... 5-110
Interior Lights ........................................................................\
.............................. 5-72
Front Lamps ........................................................................\
............................. 5-72
Interior Lamp AUTO Cut ........................................................................\
......... 5-72
Luggage Compartment Lamp ........................................................................\
... 5-74
Rear Lamp ........................................................................\
................................ 5-73
Vanity Mirror Lamp ........................................................................\
................. 5-74
Welcome System ........................................................................\
...................... 5-75
Interior Overview (I)........................................................................\
...................... 2-4
Interior Overview (II) ........................................................................\
.................... 2-5
Introduction ...........................................................\
................................................ 1-2
J
Jump Starting ........................................................................\
................................. 8-4
L
Lane Following Assist (LFA) ........................................................................\
..... 7-54
Lane Following Assist Malfunction and Limitations ....................................... 7-57
Lane Following Assist Operation ..................................................................... 7-55
Lane Following Assist Settings ........................................................................\
7-54
Lane Keeping Assist (LKA) ........................................................................\
....... 7-14
Lane Keeping Assist Malfunction and Limitations .......................................... 7-18
Lane Keeping Assist Operation ........................................................................\
7-16
Lane Keeping Assist Settings ........................................................................\
.. 7-14
LCD Display ........................................................................\
................................ 4-25
LCD Display Control ........................................................................\
............... 4-25
Trip Computer ........................................................................\
.......................... 4-37
User Settings Mode ........................................................................\
.................. 4-31
View Modes ........................................................................\
.............................. 4-26
Light Bulbs ........................................................................\
.................................. 9-58
Headlamp, Position Lamp, Turn Signal Lamp and Daytime Running
Light Bulb Replacement ........................................................................\
......... 9-59
CN7 N HMA Index.indd I-72021-09-08  11:16:48