2022 HONDA CIVIC lock

157
uuLocking and Unlocking the Doors uKey
Controls
The built-in key can be used to unlock the
doors when the remote key battery becomes
weak and the power door unlock operation is
disabled.
To remove the built-in key, push the release
button and then pull out the key. To reinstall
the built-in key, push the built-in key into the
remote key until it clicks.
Contains a number that you will need if you
purchase a replacement key.
■Built-in Key
Built-in Key
Release Button
■Key Number Tag1 Key Number Tag
Keep the key number tag separate from the key in a
safe place outside of your vehicle.
If you wish to purchase an additional key, contact a
dealer.
If you lose your key and you cannot start the engine,
contact a dealer.

158
uuLocking and Unlocking the Doors uLow Remote Key Signal Strength
Controls
Low Remote Key Signal Strength
The vehicle transmits radio waves to locate the remote key when locking/unlocking*
the doors and fuel fill door, opening* the trunk, or starting the engine.
In the following cases, locking/unlocking
* the doors, opening* the trunk, or starting
the engine may be inhibited or operation may be unstable:
• Strong radio waves are being tra nsmitted by nearby equipment.
• You are carrying the remote key together with telecommunic ations equipment,
laptop computers, cell phone s, or wireless devices.
• A metallic object is touching or covering the remote key.
1Low Remote Key Signal Strength
Communication between the remote key and the
vehicle consumes the remote key's battery.
Battery life is about two years, but this varies
depending on re gularity of use.
The battery is consumed whenever the remote key is
receiving strong radio waves. Avoid placing it near
electrical appliances such as televisions and personal
computers.
* Not available on all models

159
uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
Continued
Controls
Locking/Unlocking the Doors from the Outside
When you carry the remote key, you can lock/
unlock the doors, fuel fill door, and open the
trunk.
You can lock/unlock the doors and fuel fill door
within a radius of about 32 inches (80 cm) of
the outside door handle. You can open the
trunk within about 32 inches (80 cm) radius
from the trunk release button.
■Locking the doors and trunk
Touch the door lock sensor on the front door.u All the doors and trunk lock and the
security system sets.
u Some exterior lights flash once and the
beeper sounds once.
■Using the Keyless Access System*1Locking/Unlocking the Doors from the Outside
If the interior light switch is in the door activated position,
the interior lights come on when you unlock the doors.
No doors opened: The lights fade out after 30 seconds.
Doors relocked: The li ghts go off immediately.
2 Interior Lights P. 207
1Using the Keyless Access System*
If you do not open a door within 30 seconds of
unlocking the vehicle with the keyless access system,
the doors and trunk will automatically relock.
You can lock or unlock doors using the keyless access
system only when the power mode is in VEHICLE OFF.
Door Lock Sensor
* Not available on all models

uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
160
Controls
■Unlocking the doors and trunk
Grab the driver’s door handle:u The driver’s door and fuel fill door
unlock.
u Some exterior lights flash twice and the
beeper sounds twice.
Grab the front passenger’s door handle: u All the doors and trunk unlock.
u Some exterior lights flash twice and the
beeper sounds twice.
Press the trunk release button: u The trunk unlocks and opens.
u Some exterior lights flash twice and the
beeper sounds once.
2 Using the Trunk Release Button* P. 171
1Using the Keyless Access System*
•Do not leave the remote key in the vehicle when
you get out. Carry it with you.
•Even if you are not carr ying the remote key, you
can lock/unlock the doors while someone else with
the remote key is within range.
•The door may be unlocked if the door handle is
covered with water in heavy rain or in a car wash if
the remote key is within range.
•If you grip a front door handle or touch the front
door lock sensor wearing gloves, the door sensor
may be slow to respon d or may not respond by
locking/unlocking the doors.
•After locking the door, you have up to 2 seconds
during which you can pull the door handle to
confirm whether the door is locked. If you need to
unlock the door immediately after locking it, wait
at least 2 seconds befo re gripping the handle,
otherwise the door will not unlock.
•The door might not open if you pull it immediately
after gripping the door handle. Grip the handle
again and confirm that th e door is unlocked before
pulling the handle.
•Even within the 32 inches (80 cm) radius, you may
not be able to lock/unlock the doors with the remote
key if it is above or below the outside handle.
•The remote key may not operate if it is too close to
the door and door glass.
The light flash, beep and door unlock mode settings
can be customized using the audio/information
screen or driver information interface.
2 Settings P. 126
2 Customized Features P. 363
Trunk Release Button
* Not available on all models

Continued161
uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
Controls
■Locking the doors and trunk (Walk
away auto lock ®)
When you walk away fro m the vehicle with all
doors closed while carrying the remote key,
the doors will automatically lock.
The auto lock function activates when all
doors are closed, and the remote key is within
about 5 feet (1.5 m) ra dius of the outside door
handle or trunk release button.
Exit vehicle while carry ing the remote key and
close door(s).
1. While within about 5 feet (1.5 m) radius of
the vehicle.
u The beeper sounds; the auto lock
function will be activated.
2. Carry the remote key beyond about 5 feet
(1.5 m) from the vehicle and remain outside
this range for 2 or more seconds.
u Some exterior lights flash; the beeper
sounds; all doors will then lock.1Locking the doors and trunk (Walk away auto lock ®)
The auto lock function is set to OFF as the factory
default setting. The auto lo ck function can be set to
ON using the audio/inform ation screen or driver
information interface.
If you set the auto lock function to ON using the
audio/information screen or driver information
interface, only the remote transmitter that was used
to unlock the driver’s door prior to the setting change
can activate auto lock.
2 Settings P. 126
2 Customized Features P. 363
After the auto lock function has been activated,
when you stay within the locking/unlocking
operation range, the indicator on the remote key will
continue to flash until the doors are locked.
When you stay beside the vehicle within the
operation range, the doors wi ll automatically lock
approximately 30 seconds after the auto lock
function activating beeper sounds.
When you open a door after the auto lock function
activating beeper sounds, the auto lock function will
be delayed until all doors are closed.
Under the following circumstances, the auto-lock
function will not activate:
•The remote key is inside the vehicle.
u The beeper will not sound.
•The remote key is taken out of its operational range
before all the doors are closed.
u The beeper will sound.
The activation range of
the auto lock function is
about 5 feet (1.5 m)

uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
162
Controls
To temporarily deactivate the function:
1. Set the power mode to OFF.
2. Open the driver’s door.
3. Using the master door lock switch, operate
the lock as follows:
Lock Unlock Lock Unlock.
u The beeper sounds and the function is
deactivated.
To restore the function:
• Set the power mode to ON.
• Lock the vehicle without using the auto lock
function.
• With the remote key on you, move out of
the auto lock function operation range.
• Open any door.1Locking the doors and trunk (Walk away auto lock ®)
The auto lock function does not operate when any of
the following conditions are met.
•The remote key is inside the vehicle.
•A door or the hood is not closed.•The power mode is set to any mode other than
OFF.
•The remote key is not loca ted within a radius of
about 5 feet (1.5 m) from the vehicle when you get
out of the vehicle and close the doors.
Auto lock function operation stop beeper
After the auto lock function has been activated, the
auto lock operation stop beeper sounds for
approximately two seconds in the following cases.
•The remote key is put inside the vehicle through a
window.
•You are located too close to the vehicle.
•The remote key is put inside the trunk.
If the warning beeper sounds, check that you are
carrying the remote key. Then, open/close a door and
confirm the auto lock ac tivation beeper sounds once.

Continued163
uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
Controls
■Locking the doors
Press the lock button.
Once: u Some exterior lights flash, all the doors
and fuel fill door lock , and the security
system sets.
Twice (within five se conds after the first
push): u Some exterior lights flash, the beeper
sounds, and verifies th e security system is
set.
■Unlocking the doors
Press the unlock button.
Once: u Some exterior lights flash twice, and the
driver’s door and fuel fill door unlock.
Twice: u The remaining doors unlock.
■Using the Remote Transmitter1Using the Remote Transmitter
If you do not open a door within 30 seconds of
unlocking the vehicle with the remote transmitter,
the doors will automatically relock.
You can lock or unlock doors using the remote
transmitter only when the power mode is in VEHICLE
OFF.
The remote transmitter us es low-power signals, so
the operating range may vary depending on the
surroundings.
The remote will not lock th e vehicle when a door is
open.
If the distance at which the remote transmitter works
varies, the batter y is probably low.
If the LED does not come on when you press a
button, the battery is dead. 2 Replacing the Remote Battery P. 629
You can customize the door unlock mode setting. 2 Settings P. 126
2 Customized Features P. 363
LED
Unlock Button
Lock Button

uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
164
Controls
If the unlock button of the remote key does not work, use the built-in key instead.
The keyhole is on the back of the door handle. Insert the built-in key into the key cylinder
from below the handle and then turn it.
■Unlocking the Doors Using a Key1Unlocking the Doors Using a Key
When unlocking, the driver’s door unlocks first. Turn
the key a second time within a few seconds to unlock
the remaining doors.
You can customize the door unlock mode setting. 2 Settings P. 126
2 Customized Features P. 363
If the lock button of the remote key does not work,
refer to the following. 2 Locking a Door Without Using a Key P. 165