131
To refit, carry out these operations in reverse
o r d e r.Check that the housing cover is positioned
correctly on its support before clipping it
on.
Number plate lamps
(W5W)
F Insert a thin screwdriver into one of the exterior holes of the transparent lens.
F
P
ush it outwards to unclip it and remove it.
F
R
emove the faulty bulb and change it.
For reassembly, carry out these operations in
reverse order.
Changing a fuse
Access to tooling Changing a fuseBefore changing a fuse:
F
T he cause of the failure must be identified
and rectified.
F
A
ll devices consuming electricity must be
switched off.
F
T
he vehicle must be immobilised with the
ignition off.
F
I
dentify the faulty fuse using the existing
allocation tables and diagrams.
To remove or fit a fuse, it is essential to:
F
U
se the special pliers to extract the fuse
from its housing and check the condition of
its filament.
F
A
lways replace the failed fuse with a fuse
of the same rating (same colour); using a
different rating could cause faults (risk of
f i r e).
If the fuse fails again soon after
replacement, have the vehicle's electrical
system checked by a CITROËN dealer or
a qualified workshop.
The replacement of a fuse not shown in
the allocation tables below may cause
a serious malfunction of your vehicle.
Contact a CITROËN dealer or a qualified
workshop.
The extraction tweezers are fitted to the back
of the dashboard fusebox cover.
F
U
nclip the cover by pulling at the top right,
then left.
F
D
isengage the cover fully and turn it over.
F
P
ull out the pliers.
8
In the event of a breakdown
