3-3
3
technique described in this manual on level
ground. Avoid crossing the side of a steep hill if
possible.
Always use proper procedures if you stall or roll
backwards when climbing a hill. To avoid stall-
ing, use the proper gear and maintain a steady
speed when climbing a hill. If you stall or roll
backwards, follow the special procedure for
braking described in this manual. Dismount on
the uphill side or to a side if pointed straight up-
hill. Turn the ATV around and remount, following
the procedure described in this manual.
Always check for obstacles before operating in
a new area.
Never attempt to operate over large obstacles,
such as large rocks or fallen trees. Always follow
proper procedures when operating over obsta-
cles as described in this manual.
Always be careful when skidding or sliding.
Learn to safely control skidding or sliding by
practicing at low speeds and on level, smooth
terrain. On extremely slippery surfaces, such as
ice, go slowly and be very cautious in order to
reduce the chance of skidding or sliding out of
control.
Never operate an ATV in fast flowing water or in
water deeper than that recommended in this
manual. Remember that wet brakes may have
reduced stopping ability. Test your brakes after
leaving water. If necessary, apply them several
times to let friction dry out the linings.
Always use the size and type of tires specified in
this manual.
Always maintain proper tire pressure as de-
scribed in this manual.
Never exceed the stated load capacity for an
ATV. Cargo should be properly distributed and
securely attached. Reduce speed and follow in-
structions in this manual for carrying cargo or
pulling a trailer. Allow greater distance for brak-
ing.
Do not operate your ATV during darkness un-
less it is equipped with a properly functioning
headlight. Off-road riding is inherently danger-
ous and additionally, off-road trails do not have
streetlights to guide you.
Never maintain an ATV without proper knowl-
edge. Contact an authorized ATV dealer to in-
form you on basic ATV maintenance. Certain
maintenance can only be carried out by certified
staff.
UBKD60E0.book Page 3 Wednesday, November 18, 2020 8:39 AM
11-3
11
Drivetrain:Primary reduction ratio:2.652 (61/23)
Secondary reduction ratio:
2.714 (38/14)
Final drive: Chain
Clutch type: Wet, multiple-disc
Transmission type:
5-speed
Gear ratio: 1st:
2.500 (35/14)
2nd: 2.000 (30/15)
3rd: 1.632 (31/19)
4th:
1.333 (28/21)
5th: 1.095 (23/21)Front tire:Size:
AT21 x 7R10
Manufacturer/model: MAXXIS/MS21Rear tire:Size:
AT20 x 10R9
Manufacturer/model: MAXXIS/MS22
Tire air pressure (measured on cold tires):Vehicle load:0.0–100.0 kg (0–220 lb)
Recommended:
Front: 35.0 kPa (0.350 kgf/cm², 5.0 psi)
Rear:
35.0 kPa (0.350 kgf/cm², 5.0 psi)
Minimum: Front:
32.0 kPa (0.320 kgf/cm², 4.6 psi)
Rear: 32.0 kPa (0.320 kgf/cm², 4.6 psi)Front wheel:Rim size:
10 X 5.5ATRear wheel:Rim size:9 X 8.0ATFront brake:Type:Hydraulic disc brakeRear brake:Type:
Hydraulic disc brakeBrake fluid:Specified brake fluid:DOT 4Front suspension:Type:Double wishbone
UBKD60E0.book Page 3 Wednesday, November 18, 2020 8:39 AM
