Page 2 of 64
RAV4 HV 2021
This Quick Reference Guide is a summary of basic vehicle
operations. It contains brief descriptions of fundamental
operations so you can locate and use the vehicle’s main
equipment quickly and easily.
The Quick Reference Guide is not intended as a substitute for
the Owner’s Manual located in your vehicle’s glove box. We
strongly encourage you to review the Owner’s Manual and
supplementary manuals so you will have a better understanding
of your vehicle’s capabilities and limitations.
Your dealership and the entire staff of Toyota Motor North
<0022004e00460053004a00440042000d0003002a004f0044000f00030058004a005400490003005a005000560003004e0042004f005a0003005a00460042005300540003005000470003005400420055004a0054006d00460045000300450053004a005700
4a004f00480003004a004f0003005a0050005600530003>
new RAV4 HV.
A word about safe vehicle operations
This Quick Reference Guide is not a full description of RAV4 HV operations.
Every RAV4 HV owner should review the Owner’s Manual that accompanies
this vehicle.
Pay special attention to the boxed
information highlighted in color throughout
the Owner’s Manual. Each box contains safe operating instructions to help you
avoid injury or equipment malfunction.
All information in this Quick Reference Guide is current at the time of printing.
Toyota reserves the right to make changes at any time without notice.
Page 20 of 64
18
FEATURES & OPERATIONS
Right turn
Lane change
*
Lane change*
Left turn
Lights & turn signals
Daytime Running Light system (DRL) Automatically turns on under certain
conditions to make vehicle more visible to other drivers. Not for use at night.
Automatic light cut off system Automatically turns lights off after 30 second
delay, or lock switch on the remote is pushed after all doors are locked.
Automatic High Beams (AHB) system Automatically switches between high
and low beams as appropriate to enhance vision at night.
Refer to Toyota Safety Sense™ 2.0 (TSS 2.0) in this guide or the Owner’s Manual
for more details on the Automatic High Beams feature.
* Operating conditions must be met. Refer to the Owner’s Manual for details.
Type AType B
HEADLIGHTS
Parking lights
Low beam (Original position)
High beam (Push)
Automatic High beams*or Auto Headlights
DRL OFFParking lights
DRL ONHeadlights
OFF
High beam flasher
(Pull)
TURN SIGNALS
* Move lever partway and release. The signals will flash three times.
Page 22 of 64
20
FEATURES & OPERATIONS
Moonroof (if equipped)
Recommended open position to
minimize wind noise. Push once to open partway.
Push again to open completely.
SLIDING OPERATION
TILTING OPERATION
Lightly press either side of the moonroof switch while opening/tilting is in progress,
the moonroof stops partway.
Push once to open completely.
Tilt
Close
Open
Close
Clock
1 V T I iMENU” button next to the screen.
4 F M F D U iSetup” or “General” in the touchscreen to access the general setting
screen.
4 F M F D U iClock.”
5 I F O T F M F D U E F T J S F E J U F N T U P C F S F T F U
Refer to the “Navigation and Multimedia System Owner’s Manual” for more details.
* Premium Audio only
Select to change the time zone.
Select to set daylight saving time
ON/OFF/AUTO*.
Select to set to automatic GPS
adjustment of clock.
Select to set the 24 hour time
format on/off.
Page 24 of 64
22
FEATURES & OPERATIONS
Bluetooth® technology allows dialing or receipt of calls without removing your hands
from the steering wheel.
Refer to the Bluetooth
® device pairing in this guide or the Navigation and
Multimedia System Owner’s Manual for additional user instructions.
NOTE: Always use safe driving practices and follow all traffic rules.
Return to previous screen
Volume control
Microphone
Voice command
switch Start and end call
“MODE”
Push to change audio mode.
Push and hold to mute or
pause the audio.
“ ”
Use to search within the
selected audio feature.
Steering wheel switches
& telephone controls (Bluetooth®)
Page 41 of 64
39
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
CHANGING PRE-COLLISION ALERT TIMING
% * 4 " # - * / ( 1 3 & $ 0 - - * 4 * 0 / 4 : 4 5 & . 1 $ 4
FarMiddle
(default)Near
1 S F T T “ ” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ PCS” and then press “.” The setting
screen is displayed.
1 S F T T “
” switches and select “Sensitivity” and then press “” to select the
desired setting. Each time it is pressed, the response to the PCS alert timing
changes as shown above.
1ress “
” to go back to the menu.
Note: PCS is enabled each time the vehicle is turned on. The system can be
disabled/enabled and the alert timing of the system can be changed. (Alert
timing only, brake operation remains the same.)
Press “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ PCS” and then press “.” The setting
screen is displayed.
1 S F T T “
” and select “PCS on/off” and then press “” to select the desired
setting.
1 S F T T “
” to go back to the menu.
Note: The system is enabled each time the vehicle is turned on.
Refer to the Toyota Owner’s Manual for additional information on PCS operation,
settings adjustments, limitations, and precautions before attempting to use it.
Page 56 of 64
54
SAFETY & EMERGENCY FEATURES
Tire Pressure Monitoring (warning) System (TPMS)
The tire pressure warning system can be selected on “” of the Multi-Information
% J T Q M B Z . * %
System reset initialization
Press “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
Press “
” switches and select the “ 7 F I J D M F 4 F U U J O H T
w U I F O Q V T I i.”
Press “
” switches and select “TPWS” and then push “.”
Press “
” switches and select “Set Pressure” then push and hold “” until
the warning light blinks three times.
The tire pressure detected by the tire pressure warning system can be displayed
P O U I F N V M U J J O G P S N B U J P O E J T Q M B Z . * %
Refer to the load label on the door jamb or the Owner’s Manual for tire inflation
specifications.
If the tire pressure indicator flashes for 1 minute and then remains on, take the
vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not been
initialized recently, setting the tire pressures to factory specifications should
turn off the light.
