2021 TOYOTA LAND CRUISER jack

5497-2. Steps to take in an emergency
LC200_OM_OM60T03U_(U)
7
When trouble arises
Insert the jack handle extension
into the lowering screw.Lower
Raise
Place a rag under the jack
handle extension to protect the
back door.
Lower the spare tire completely
to the ground.
Pull out the spare tire and
remove the holding bracket.
Remove the spare wheel cover.
3
1
2
4
5
6

5517-2. Steps to take in an emergency
LC200_OM_OM60T03U_(U)
7
When trouble arises
Assembling the jack handle.
Remove the jack handle, jack extension bar and jack handle bar
from the tool box and assemb le by following these steps.
Loosen the bolt and the screw
using either the jack handle end
or a screwdriver.
Assemble the jack handle
extension bar and the jack han-
dle bar and tighten the bolts.
Check that the bolts are firmly
tightened.
Assemble the jack handle
extension bar and the jack han-
dle and tighten the screw.
Check that the screw is firmly
tightened.
3

5527-2. Steps to take in an emergency
LC200_OM_OM60T03U_(U)
Position the jack at the jack
points as shown.Front
Under the chassis frame side
rail
Rear
Under the rear axle housing
Raise the vehicle until the tire is
slightly raised off the ground.
Remove all the wheel nuts and
the tire.
When resting the tire on the
ground, place the tire so that the
wheel design faces up to avoid
scratching the wheel surface.
4
1
2
5
6

5557-2. Steps to take in an emergency
LC200_OM_OM60T03U_(U)
7
When trouble arises
Reinstall the wheel ornament.
Remove the center wheel orna-
ment from the flat tire by pushing
from the reverse side, and rein-
stall it.
Lay down the tire with the valve
stem facing up, and install the
spare wheel cover.
5
WARNING
■Stowing the flat tire
Failure to follow steps listed under stowing the tire may result in damage
to the spare tire carrier and loss of the tire, which could res ult in death or
serious injury.
Stowing the flat/spare tire, jack and tools
1

5567-2. Steps to take in an emergency
LC200_OM_OM60T03U_(U)
Install the holding bracket,
inserting the claw into the wheel
lug nut hole. Turn the jack han-
dle extension clockwise to take
up slack in the chain.
Then, check to ensure the claw is
in the wheel lug nut hole and the
holding bracket is centered in the
wheel hub.
Holding bracket
Claw
Raise the tire.
While raising, pull the tire
towards the rear of the vehicle,
taking care that the tire goes up
without catching on any sur-
rounding part, to prevent it from
flying forward during a collision or
sudden braking.
After the tire goes half way up,
check that the suspended chain
is able to enter the tire hole, for
proper storage.
Tightening torque:
33.2 ft•lbf (45 N•m, 4.6 kgf•m)
Confirm that the tire is not loose
after tightening: Push and pull the tire
Try rotating
Visually check to ensure the
tire is not hung on surrounding
parts.
If looseness or misassembly ex ists, repeat step and step .
Repeat step , any time the tire is lowered or disturbed.
incorrect
correct
2
1
2
3
4
1
2
34
54

5577-2. Steps to take in an emergency
LC200_OM_OM60T03U_(U)
7
When trouble arises
Stow the tools and jack securely.
■After completing the tire change
The tire pressure warni ng system must be reset. ( P. 483)
WARNING
■After using the tools and jack
Before driving, make sure all t he tools and jack are securely i n place in
their storage locatio n to reduce the possibility of personal in jury during a
collision or su dden braking.
■Replacing a flat tire for ve hicles with power back door
In cases such as when replacing tires, make sure to turn off the power
back door main switch ( P. 128). Failure to do so may cause the back
door to operate unintentionally if the power back door switch i s acciden-
tally touched, resulting in hands and fingers being caught and injured.
NOTICE
■When stowing the flat tire
Ensure that there is no object caught between the tire and the vehicle
underbody.
■When replacing the tires
When removing or fitting the wheels, tires or the tire pressure warning
valve and transmitter, contact your Toyota dealer as the tire p ressure
warning valve and transmitter may be damaged if not handled cor rectly.
■To avoid damage to the tire pressure warning valves and transmi t-
ters
When a tire is repaired with liqui d sealants, the tire pressure warning
valve and transmitter may not operate properly. If a liquid sea lant is
used, contact your Toyota dealer or other qualified service shop as soon
as possible. Make sure to replac e the tire pressure warning valve and
transmitter when replacing the tire. ( P. 4 8 3 )
6

621Alphabetical index
LC200_OM_OM60T03U_(U)
HeatersFront automatic air
conditioning system ............ 394
Outside rear view mirrors...... 400
Seat heaters ......................... 411
High mounted stoplight Replacing .............................. 516
Hill-start assist control............ 377
Hood ......................................... 468
Hooks Cargo hooks ......................... 425
Coat hooks............................ 442
Retaining hooks (floor mat) ............................. 28
Horn .......................................... 161
I/M test ...................................... 465
Identification Engine................................... 573
Vehicle .................................. 573
Ignition switch (engine switch) ...................... 211
Ignition switch light (engine switch light) ............. 414
Illuminated entry system ........ 416
Immobilizer system ................... 85
Indicators ................................... 92 Initialization
Items to initialize ................... 606
Maintenance ......................... 460
Power windows..................... 171
Tire pressure warning
system .......... ...................... 484
Inside door handle light .......... 414
Inside rear view mirror ............ 163
Instrument panel light control ...................................... 98
Interior lights ........................... 414
Switch ................................... 415
Intuitive parking assist ........... 292
Jack Vehicle-equipped
jack ..................................... 545
Jack handle .............................. 545
Jam protection function Moon roof ............................. 174
Power back door opener and closer........................... 131
Power windows..................... 170
I
J
*: Refer to the “NAVIGATION SYSTEM OWNER’S MANUAL”.