2021 SUZUKI JIMNY front bumper

OK BLOWN
81A283
A WARNING
Always replace a blown fuse with a fuse of the correct amperage. Never use a substitute such as aluminum foil or wire to replace a blown fuse. If you replace a fuse and the new one blows in a short period of time, you may have a major electrical problem. Have your vehicle inspected immedi­ately by a SUZUKI dealer.
Headlight aiming
Since special procedures are required, ask a SUZUKI dealer for this job.
INSPECTION AND MAINTENANCE
Headlight Washer Fluid
78RB07046
Check that there is washer fluid in the tank. Refill it if necessary.
NOTICE
In winter season, be sure to remove snow or ice on the nozzle at the front bumper before operating headlight washer. To avoid the frozen damage to the nozzle of the headlight washer, be sure to use the specific washer fluid.
6-46

Front fog light (if equipped)
1) Start the engine. Turn the steering
wheel to the opposite side of the b~6 light to be replaced to repla_ce the easily. Then turn off the engine.
2) Remove the clips (1) and screw (2) at
the bottom of bumper. d For removing the clip, use a _flat-blade screwdriver as shown in the ,11ustrat1on.
78RB07033
3) Open the end of the cover inside the fender.
52R70140
4) Disconnect the coupler (3) ~Y1t~~~~:~ the lock release. Turn the u . (4) counterclockwise and remove ,t.
INSPECTION AND MAINTENANCE
Daytime running light (if equipped)
Models without front fog light
78RB07034
6-50

INSPECTION AND MAINTENANCE
Models with front fog light
78RB07035
1) To approach the daytime running light, open the end of the cover inside the front fender. Refer to the procedure for the bulb replacement of the "Front Fog Light" in this section.
6-51
78RB07049
2) Disconnect the coupler by pushing the lock release. Turn the bulb holder coun­terclockwise and remove ii.
NOTE: Depending on the vehicle's specification, the daytime running light is located under the front fog light, but the replace method is same as the above.
Rear combination light
78RB07036
1) Remove the nuts (1) and pull the rear combination light from the rear bumper by pushing the hooks (A).

Washing by a high-pressure cleaner
NOTICE
If you use a high-pressure cleaner, keep away the nozzle from your vehi­cle sufficiently. Bringing the nozzle to your vehicle too close or pointing the nozzle to the opening of front grill or bumper etc. can cause damage and mal­function of the vehicle body and parts. Pointing the nozzle to the weather­strip of door glasses, doors and the sunroof (if equipped) can allow water to enter the cabin.
Waxing
After washing the vehicle, waxing and pol­ishing are recommended to further protect and beautify the paint.
Only use waxes and polishes of good quality. When using waxes and polishes, observe the precautions specified by the manufacturers.
APPEARANCE CARE
8-6

SPECIFICATION
Specifications
NOTE: Specifications are subject to change without notice.
MIT: Manual transmission NT: Automatic transmission
ITEM: Dimensions UNIT: mm (in.)
Overall length 3625 (142.7) (Front bumper to spare tyre) 3645 (143.5) (Front bumper to spare wheel half cover)
Overall width 1645 (64.8)
Overall height 1720 (67.7)
Wheelbase 2250 (88.6)
Track I Front 1395 (54.9)
I Rear 1405 (55.3)
Ground clearance 210 (8.2)
9-3