2021 MERCEDES-BENZ E-CLASS COUPE light

begin with positive contact
2onyour own
ve hicle /rst. #
Dur
During st
ing st ar
arting assist
ting assist ance:
ance:startthe engine of
th e donor vehicle and run at idle speed. #
Connect the negative term inal of the donor
battery and ear thpoint 3ofyour ow nve hicle
by using the jump lead/charging cable. Begin
with the donor battery /rst. #
Dur
During st
ing st ar
arting assist
ting assist ance:
ance:startthe engine of
yo ur ow nve hicle. #
Dur
During t
ing t he c
he char
harging pr
ging pr ocess:
ocess: startthech arg-
ing process. #
Dur
During st
ing st ar
arting assist
ting assist ance:
ance:letthe engines run
fo r se veral minutes. #
Dur
During st
ing st ar
arting assist
ting assist ance:
ance:before disconnect-
ing the jump lead, switch on an electrical con-
sumer on your ow nve hicle, e.g. there ar win-
dow heater or lighting.
When the starting assistance/charging process is
comple te, per form thefo llowing steps: #
Firs t, re mo vethe jump lead/charging cable
from ear thpoint 3and the negative term inal of
the donor batter y,then from positive con-
ta ct 2 and the positive term inal of the donor
batter y.Begin ea chtime with the contacts on
yo ur ow nve hicle /rst. #
ATer removing the jump lead/charging cable,
close co ver1 of positive contact 2.
Fu rther information can be obtained at a quali/ed
specialist workshop. R
R
eplacing t
eplacing t he 12 V batt
he 12 V batt ery
ery #
Obser vethe no tes on the 12 V battery
(/ page 323).
Mercedes-Benz recommends that you ha vethe
12 V battery replaced at a quali/ed specialist
wo rkshop, e.g. at a Mercedes-Benz Se rvice
Centre.
Obser vethefo llowing no tes if youwa nttoreplace
th e battery yourself:
R Alwaysre place a faulty battery with a battery
which meets the speci/c vehicle requ ire-
ments. The
vehicle is equipped with an AGMtech nol-
ogy bat tery (Absorbent Glass Mat) or a lith-
ium-ion batter y.Fu llve hicle functionality is
only guaranteed with an AGM bat tery or lith-
ium-ion batter y.Fo r saf etyre asons, Mercedes-
Benz recommends that you only use batteries
which ha vebeen tested and appro vedfo ryo ur
ve hicle byMercedes-Benz.
R Carryove r de tach able parts, such as vent
hoses, elbow /ttings or term inal co vers from
th e battery being replaced.
R Make sure that theve nt hose is alw ays con-
nected tothe original opening on the side of
th e batter y.
Fi t any existing or supplied cell caps.
Otherwise, gases or battery acid could
escape.
R Make sure that de tach able parts are recon-
nected in the same way. 328 328
Breakdown assistance

&
W
W ARNI NG
ARNI NGRisk of accident due torepea-
te d pressure drop in the tyres
The wheels, valves or tyres could be damaged.
To o low a tyre pressure can lead tothe tyres
bursting. #
Examine the tyres forfo re ign objects. #
Check whe ther the tyre has a puncture
or theva lve has a leak. #
Ifyo u are unable torectify the damage,
contact a quali/ed specialist workshop. Information on
there commended tyre pressure
fo rth eve hicle's factor y-/tted tyres can be found
on the tyre pressure table on the inside of the fuel
/ller 0ap (/ page 339).
Use a suitable pressure gauge tocheck the tyre
pressure. The outer appearance of a tyre does not
permit any reliable conclusion about the tyre pres-
sure.
Only cor rect tyre pressures when the tyres are
cold. Conditions for cold tyres:
R The vehicle has been par ked with the tyres out
of direct sunlight for at least thre e hours. R
The vehicle has tr avelled less than 1.6 km.
The vehicle's tyres heat up when driving. As the
te mp erature of the tyres increases, so too does
th e tyre pressure.
V V ehicles wit
ehicles wit h a tyr
h a tyre pr
e pressur
essur e monit
e monit or
oring syst
ing syst em:
em:
yo u can also check the tyre pressure using the
on-board computer.
Not
Not es on tr es on tr ailer oper
ailer oper ation
ation
Alw ays in0ate there ar axle tyres tothere com-
mended tyre pressures on the tyre pressure table
fo r increased load. T
T
yr
yr e pr
e pr essur
essur e t
e table
able The tyre pressure
table is on the inside of the fuel
/ller 0ap. If one or more tyre sizes precede a tyre pressure,
th efo llowing tyre pressure information is only
va lid forth ose tyre sizes and their respecti veload
condition.
If th e preceding tyre sizes are complemented by
th e+ symbol, the tyre pressure information
fo llowing sho wsalternative tyre pressures. Fuel
consum ption may then increase slightl y. Wheels and tyres
339 339

-
Athttps://be vo.mercedes-benz.com
- Inthe Mercedes-Benz BeVo App
R Ataqu ali/ed specialist workshop *
N
NO OTE
TE Overheating at high outside tempe r-
atures If an inappropriate coolant is used,
the engine
cooling system is not su1ciently pr otected
against overheating and cor rosion at high out-
side temp eratures. #
Only use coolant appr ovedby Mercedes-
Benz. #
Obser vethe inst ructions in the
Mercedes-Benz Speci/cations for Oper-
ating Fluids 320.1. Ha
ve the coolant regula rly re placed at a quali/ed
specialist workshop.
Proportion of antif reeze concentrate in the engine
cooling system:
R A minimum of 50% (antifreeze pr otection down
to about -37°C) R
A maximum of 55% (antif reeze pr otection
down to-45°C) N
No
ot
tes on windscr
es on windscr een w
een washer
asher 0uid
0uid Obser
vethe no tes on operating 0uids
(/ page 359). &
W
W ARNING
ARNING ‑ Risk of /re and injury due to
windscreen washer concent rate
Wi ndsc reen washer concent rate is highly 0am-
mable. It could ignite if it comes into contact
with hot engine component parts or the
ex haust system. #
Make sure that no windscreen washer
concent rate spills out next tothe /ller
opening. *
N NOOTE
TE Damage totheex terior lighting due
to unsuitable windscreen washer 0uid Unsuitable windscreen
washer 0uids may
damage the plastic sur face of theex terior
lighting. #
Only use windscreen washer 0uids which
are also suitable for use on plastic sur fa-
ces, e.g. MB SummerFit or MB WinterFit. *
N
NOOTE
TE Bloc ked spr aynozzles caused by
mixing windscreen washer 0uids #
Do not mix MB SummerFit and MB Win-
te rFit with other windscreen washer 0u-
ids. Do not use distilled or de-ionised
water. Other-
wise, the /ll le vel sensor may be triggered er rone-
ous ly.
Re commended windscreen washer 0uid:
R abo vefreezing point: e.g. MB SummerFit
R below freezing point: e.g. MB WinterFit
Fo rth e cor rect mixing ratio, referto the informa-
tion on the antifreeze container.
Mix washer 0uid with windscreen washer 0uid all
ye ar round. Te
ch nical data
367
367

Lights
Lights
Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/conseq uences and
uences andM
MSolutions
Solutions
:
Left dipped beam (examp le) *T
he cor responding light source is defecti ve. #
Drive on carefull y. #
Consult a quali/ed specialist workshop immediatel y.
% LED light sources: the display message forth e cor responding light appears only when all the light-emitting diodes
in the light are faulty.
: Malfunction See Owner's
Manual *T
heexterior lighting is malfunctioning. #
Consult a quali/ed specialist workshop.
*V Vehicles wit ehicles wit h a tr
h a trailer hitc
ailer hitc h:
h:a fuse may ha veblown. #
Stop theve hicle in accordance with the tra1c conditions. #
Check the fuses and replace them if necessary (/ page 333).
:
Automatic driving lights
inoperative *T
he light sensor for automatic driving lights is malfunctioning. #
Consult a quali/ed specialist workshop. Displ
aymessages and warning/indicator lamps
377
377

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions
:
Active Light System inoper-
ative *T
he active headlamps are malfunctioning. #
Consult a quali/ed specialist workshop.
:
Switch on headlamps *Y
ou are driving without lo w-beam headlamps. #
Turn the light switch totheL orà position.
:
Switch off lights *Y
ou are leaving theve hicle and the lights are still switched on. #
Turn the light switch totheà position.
:
Intelligent Light System
inoperative *T
he Intelli gent Light System is malfunctioning. The lighting system continues tofunction proper lywithout the functions
of the Intelligent Light System. #
Consult a quali/ed specialist workshop. 378 378
Displ
aymessages and warning/indicator lamps

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions #
Drive carefully on a suitable str etch of road, making slight steering mo vements at a speed abo ve30 km/h. #
Ifth e display message does not disappear, consult a quali/ed specialist workshop immediatel y.Drive care-
full y. !
÷
inoperative See Owner's
Manual *
ABS and ESP ®
are malfunctioning.
Other driving systems and driving sa fety systems (e.g. BAS) may also be malfunctioning.
The brake system will continue tooperate normall y.Braking distance may inc rease in an emer gency braking situation. &
W WARNI NG
ARNI NGRisk of skidding if ABS and ESP ®
are malfunctioning
The wheels may block during braking and ESP ®
does not per form any vehicle stabilization.
The steerability and braking characteristics are heavily impaired and the braking distance may increase. In addi-
tion, other driving saf ety sy stems are swit ched o.. #
Drive on carefull y. #
Have ABS and ESP ®
ch ecked immediately at a quali/ed specialist workshop. ÷
currently unavailable See
Owner's Manual *
ESP ®
is temp orarily una vailable.
Other driving systems and driving saf ety sy stems (e.g. BAS) ma y also be malfunctioning.410 410
Display messages and
warning/indicator lamps

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions &
W
WARNING
ARNING Risk of skidding if ESP is malfunctioning ®
If ESP ®
is malfunctioning, ESP ®
cannot car ryout vehicle stabilisation. In addition, other driving saf ety sys tems are
switched o.. #
Drive careful lyon a suitable st retch of road, making slight steering mo vements at a speed abo ve30 km/h. #
Ifth e display message does not disappear, consult a quali/ed specialist workshop immediatel y.Drive care-
full y. ÷
inoperative See Owner's
Manual *
ESP ®
is malfunctioning.
Other driving systems and driving sa fety systems (e.g. BAS) may also be malfunctioning.
The brake system will continue tooperate normall y.Braking distance may inc rease in an emer gency braking situation. &
W WARNI NG
ARNI NGRisk of skidding if ESP ®
is malfunctioning
If ESP ®
is malfunctioning, ESP ®
cannot carr y outvehicle stabilisation. In addition, other driving saf ety sys tems are
switched o.. #
Drive on careful ly. #
Have ESP ®
ch ecked at a quali/ed specialist workshop. Displ
aymessages and warning/indicator lamps
411
411

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions
5
Engine oil pressure Stop
Switch off engine *T
he oil pressure is too lo w.
* N
N O OTE
TE Engine damage caused bydriving with insu1cient oil pressure #
Avoid driving with insu1cient oil pressure. #
Stop theve hicle immediately in accordance with the tra1c conditions. Do not continue driving. #
Switch o. theve hicle. #
Consult a quali/ed specialist workshop.
5
Engine oil level cannot be
measured *T
he elect rical connection tothe oil le vel sensor has been inter rupted or the oil le vel sensor is faulty. #
Consult a quali/ed speciali stwo rkshop. W W
ar
ar ning and indicat
ning and indicat or lam
or lamps
ps Ov
Ov
er
ervie
vie w of indicat
w of indicat or and w
or and war
ar ning lam
ning lam ps
ps Some systems will per
form a self-test when the
ve hicle is switched on. Some indicator and warn-
ing lamps may brie0y light up or 0ash. This beha v-
iour is non-critical. These indicator and warning lamps indicate a malfunction only if
they light up
or 0as haTer theve hicle has been star ted or dur-
ing a journe y. Display messages and
warning/indicator lamps
427
427