If
yo u push the door into the lock tothe /rst
de tent position, the po wer closing function will
automatically pull the door into the loc k. Loc
Loc
king/unloc
king/unloc king t
king the dr
he driv
iver's door wit
er's door wit h t
h the
he
emerg
emerg encykey
ency key %
Ifyo u wish tolock theve hicle entirely using
th e emer gency key,/rst press the button for
locking from the inside while the driver's door
is open. Then proceed tolock the driver's
door using the emer gency key. #
Remo vethe emer gency key (/ page 75). #
Inse rtthe emer gency key as far as it will go
into opening 1inthe co ver. #
Pull and hold the door handle. #
Pull the co ver on the emer gency key as
straight as possible away from theve hicle until
it re leases. #
Release the door handle. #
T To unloc o unloc k:
k:turn the emer gency key anti-cloc k-
wise toposition 1. #
T
To loc
o loc k:
k:turn the emer gency key clockwise to
position 1. #
Carefully press the co ver onto the lock cylin-
der until it engages and is seated /rml y.80
80
Opening and closing
1
Fuel /ller 0ap
2 Brac ketfo r fuel /ller cap
3 Tyre pressure table
4 QR code forre scue card
5 Stationary heater indication
6 Fuel type #
Press on the back area of fuel /ller 0ap 1. #
Turn the fuel /ller cap anti-clockwise and
re mo veit. #
Insert the fuel /ller cap from abo veinto
brac ket2. #
Comple tely insert the pump nozzle into the
ta nk /ller nec k,hook in place and refuel. #
Only /ll the fuel tank until the pump nozzle
switches o..
% V
Vehicles wit
ehicles wit h a diesel engine:
h a diesel engine: whenthe fuel
ta nk is comple tely em pty, top up with at least
5 litres of diesel. #
Replace the cap on the /ller neck and turn
clockwise until it engages audibl y. #
Close fuel /ller 0ap 1. A
A
dBlue
dBlue ®
®
(v
(vehicles wit
ehicles wit h a diesel engine onl
h a diesel engine onl y)
y) N
No
ot
tes on
es on r
re/lling
e/lling A
AdBlue
dBlue ®
®
Ad Blue ®
is a water-soluble 0uid forth e NOx
ex haust gas aTertreatment of diesel engines. In
order forth eex haust gas aTertreatment tofunc-
tion proper ly, only use AdBlue ®
in acco rdance
with ISO 22241. Ad
Blue ®
is ch aracterised bythefo llowing:
R non-t oxic
R colourless and odourless
R non-0ammable
If yo u open theAd Blue ®
tank, small amounts of
ammonia vapour may be released. Only /ll the
Ad Blue ®
tank in well-ventilated areas.
Do not let AdBlue ®
come into contact wi thskin,
ey es or clo thes. Keep AdBlue ®
awa y from chil-
dren.
Do not ingest AdBlue ®
. If AdBlue ®
is swallo wed,
immediately rinse your mouth out thoroughl y.
Drink plenty of water. Seek medical at tention at
once.
Obser vethe no tes on operating 0uids
(/ page 359).
Ad Blue ®
is available here:
R AdBlue ®
can be topped up byfast service at a
quali/ed specialist workshop, e.g. a
Mercedes-Benz Se rvice Centre. Driving and parking
175 175
Opening t
Opening t
he A
he AdBlue
dBlue ®
®
/ller
/ller cap
cap #
Press on the back area of fuel /ller 0ap 1.#
Turn AdBlue ®
/ller cap 2anti-clockwise and
re mo veit.
T
T opping up A
opping up A dBlue
dBlue®
®
Mercedes-Benz recommends topping up AdBlue ®
at a /lling pump. If no AdBlue ®
/lling pump is av
ailable, you can also top up AdBlue ®
using a
canister. #
Screw onthefa stener of AdBlue ®
re/ll canis-
te r4. #
Screw disposable hose 3onto the opening
of Ad Blue ®
re/ll canis ter4 until hand-tight. #
Screw disposable hose 3onto the /ller neck
of theve hicle until hand-tight. #
LiT up and tip AdBlue ®
re/ll canis ter4.
The /lling process stops when theAd Blue ®
ta nk is comple tely full. Ad
Blue ®
re/ll canis ter4 can be remo ved
when it has been only partially em ptied. #
Unscr ewand close disposable hose 3and
Ad Blue ®
re/ll canis ter4 inreve rse order. #
Replace AdBlue ®
/ller cap 2and turn it
clo ckwise until it audibly engages. #
Close fuel /ller 0ap 1. #
Switch on theve hicle for at least 60 seconds.
% Ifth eve hicle could not be star ted as the
Ad Blue ®
tank was em pty, it can take up to
60 seconds forth ere /ll tobe de tected. #
Start theve hicle.
% Avoid storing AdBlue ®
re/ll con tainers perma-
nently in theve hicle. Driving and parking
177
177
%
The equipment with touchpad and controller
is not available in all countries. #
Perform the operation according tothe equip-
ment.
Operating theto uchpad (e xamples):
R Toselect a menu option, swipe and press.
R If handwriting recognition is active, write a
ch aracter on theto uchpad.
R Swipe down or up with two /n gers.
The No ti/cations Cent reis opened or closed.
R Movetwo /n gers apart or toget her on the
map.
The map scale is increased or decreased.
Operating the controller
R Turn 3 anti-clockwise or clockwise.
R Slide 1 leT orright.
R Slide 4 up or down.
R Slide 2 diagonal ly.
R Press 7brie0y or press and hold. Calling up applications using butt
Calling up applications using butt ons ons 1
% button calls up thete lephone
2 z button calls up navigation
3 | button calls up radio or media
4 y button calls up vehicle functions
5 ß button
Press brie0 y:calls up favo urites
Press and hold: adds a favo urite or creates a
new theme #
Alternativel y,tap© ontheto uchscreen. #
Call up the application (/ page 257). F
F
unctions of LIN
unctions of LIN GUA
GUATR
TRONIC
ONIC &
W
WARNING
ARNING Risk of distraction due toinfor-
mation systems and communications
equipment
If yo u operate information systems and com-
munications equipment integ rated in theve hi-
cle when driving, you could be distracted from
th e tra1c situation. This could also cause you
to lose control of theve hicle. #
Only operate this equipment when the
tra1c situation pe rmits. #
Ifyo u cannot be sure of this, stop the
ve hicle in accordance with the tra1c
conditions and operate the equipment
with theve hicle stationar y. Fo
ryo ur ow n sa fety, alw ays obser vethefo llowing
points when operating mobile communications
equipment and especially your voice control sys-
te m:
R Obser vethe legal requ irements forth e coun-
try in which you are driving. 260 260
MBUX multimedia system
*
N
N O
OTE
TE Damage caused bytopping up too
much engine oil To
o much engine oil can damage the engine or
th e catalytic con verter. #
Have excess engine oil remo ved at a
qu ali/ed specialist workshop. %
Depending on driving st yle, theve hicle con-
sumes up to0.8 litre of oil per 1000 km. The
oil consum ption may be higher than this when
th eve hicle is new or if you frequently drive at
high engine speeds. #
Turn cap 1anti-clockwise and remo veit. #
Top up the engine oil. #
Replace cap 1and turn it clockwise until it
engages. #
Check the oil le vel again (/ page 305). Chec
Chec
king t
king t he coolant lev
he coolant lev el
el &
W
WARNING
ARNING Risk of burns from hot compo-
nent parts in the engine compartment
Cer tain component parts in the engine com-
partment can be very hot, e.g. the engine, the
cooler and parts of theex haust system. #
Allow the engine tocool down and only
to uch component parts described in the
fo llowing. &
W
WARNING
ARNING Risk of scalding from hot cool-
ant
If yo u open the cap, you could be scalded. #
Let the mo tor cool down before opening
th e cap. #
When opening the cap, wear pr otective
glo ves and saf ety glasses. #
Open the cap slo wlytorelease pressure. Maintenance and care
307
307
#
Park theve hicle on a le vel sur face. #
Check the coolant temp erature display in the
inst rument clus ter.
The coolant temp erature must be below 70°C. #
Slowly turn cap 1anti-clockwise torelease
ove rpressure. #
Continue turning cap 1anti-clockwise and
re mo veit. The coolant le
vel is cor rect in thefo llowing cases:
R Ifth e engine is cold, the coolant is up to
mar ker bar 2.
R Ifth e engine is warm,th e coolant is up to
1.5 cm overth e mar ker bar 2. #
If necessar y,top up with coolant that has
been appr ovedfo r Mercedes-Benz.
% Further information on coolant (/ page 366) T
T
opping up t
opping up t he windscr
he windscreen w
een washer syst
asher syst em
em &
W
WARNING
ARNING Risk of burns from hot compo-
nent parts in the engine compartment
Cer tain component parts in the engine com-
partment can be very hot, e.g. the engine, the
cooler and parts of theex haust system. #
Allow the engine tocool down and only
to uch component parts described in the
fo llowing. &
W
WARNING
ARNING ‑ Risk of /re and injury due to
windscreen washer concent rate
Wi ndsc reen washer concent rate is highly 0am-
mable. It could ignite if it comes into contact
with hot engine component parts or the
ex haust system. #
Make sure that no windscreen washer
concent rate spills out next tothe /ller
opening. 308 308
Maintenance and care
F
F
itting and r
itting and r emo
emoving t
ving t heto
he towing eye
wing eye #
Press the mark on co ver1 inwa rds and
re mo ve. #
Screw intheto wing eye clockwise as far as it
will go and tighten.
V
V ehicles wit
ehicles wit h a tr
h a trailer hitc
ailer hitc h:
h:vehicles with a trailer
hitch do not ha veare ar brac ketfo rth eto wing
ey e. Fasten theto w bar tothe trailer hitch. #
Make sure that co ver1 engages in the
bumper when youre mo vetheto wing eye.
* N
NO OTE
TE Damage totheve hicle due toincor-
re ct use of theto wing eye or trailer hitch When a
towing eye or trailer hitch is used to
re co ver a vehicle, theve hicle may be damaged
in the process. #
Only use theto wing eye or trailer hitch to
to w awa y or tow start theve hicle. #
Do not use theto wing eye or trailer hitch
to to wtheve hicle during reco very. T
T
o
o w
w -st
-st ar
arting t
ting t he v
he vehicle
ehicle V
V
ehicles wit
ehicles wit h aut
h automatic tr
omatic tr ansmission
ansmission
* NO
NOTE
TEDamage tothe automatic transmis-
sion due to tow-starting The au
tomatic transmission may be damaged
in the process of tow- starting vehicles with
automatic transmission. #
Vehicles with automatic transmission
must not be tow- star ted. #
Vehicles with an automatic transmission must
not be tow- star ted. Electr
Electr
ical fuses
ical fuses N
No
ot
tes on electr
es on electr ical fuses
ical fuses &
W
WARNING
ARNING Risk of accident and inju rydue
to ove rloaded lines
If yo u manipulate or bridge a faulty fuse or if
yo ure place it with a fuse with a higher amper-
age, the electric line could be overloaded.
This could result in a /re. #
Alwaysre place faulty fuses with speci-
/ed new fuses containing the cor rect
amperage. Breakdown assistance
333
333
#
Turn clips 2on co ver1 aqu arter-turn to
anti-clockwise. #
Pull co ver1 upwards in the direction of the
ar ro w. #
Remo veany existing moisture from the fuse
box using a dry clo th. #
Loosen scr ews4 and remo vefuse box lid 3
from theto p.
Closing
Closing #
Check whe ther the seal is positioned cor rectly
in cap 3. #
Insert lid 3into the brac ket at there ar of the
fuse box. #
Fold down lid 3ofthe fuse box and tighten
scr ews4. #
Insert co ver1 on bo thsides. #
Turn clips 2on co ver1 aqu arter-turn
clockwise. #
Close the bonnet. Opening and closing t
Opening and closing t
he fuse bo
he fuse box in t
x in the coc
he coc kpit
kpit R
Obser vethe no tes on elect rical fuses
(/ page 333).
The fuse box is on the driver's side on the side of
th e cockpit under a co ver. #
Toopen and close it, consult a Mercedes-Benz
Service Centre. Opening and closing t
Opening and closing t
he fuse bo
he fuse box in t
x in the fr
he front
ont
passeng
passeng er f
er foo
ootw
twell
ell Obser
vethe no tes on elect rical fuses
(/ page 333). Breakdown assistance
335
335