2021 KIA STINGER lights

23ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPERATING INFORMATION AND SAFETY WARNINGS.*IF EQUIPPED†LEG AL DISCL AIMERS ON BACK INSIDE COVER
STEERING WHEEL CONTROLS
STEERING WHEEL CONTROLS
P
R
N
D
AUTO
HOLD
DRIVE MODE
OFF
OFF
P
(GT steering wheel illustration shown)
(GT steering wheel illustration shown)
REMINDER: If the steering wheel becomes too warm, turn the system off. The heated steering wheel may cause burns even at low temperatures, especially if used for long periods of time.
REMINDER: To prevent discharge from the battery, do not adjust when the engine is OFF.
Manual Tilt/Telescoping Steering Wheel*† 26
To adjust the Steering Wheel manually, push the lock-release lever D down and adjust to the desired angle B and distance C.
When finished, pull the lock-release lever D up to lock Steering
Wheel in place.
A
D
E
C
B
§ It may be helpful to pull/push the bottom of the Steering Wheel towards/away from you to adjust desired distance prior to adjusting the angle
QUICK TIP
Do not adjust the steering wheel while driving as this may cause you to lose control of the vehicle. See section 4 in the Owner’s Manual for more information.
Do not adjust the steering wheel while driving as this may cause you to lose control of the vehicle. See section 4 in the Owner’s Manual for more information.
See section 4 in the Owner’s Manual for more information.
Adjust the steering wheel angle B and position C with the
switch A on the steering column. Move the steering wheel so it
points towards your chest, not toward your face. Make sure
you can see the instrument panel warning lights and gauges.
After adjusting, push the steering wheel both up and down
to be certain it is locked in position. Always adust the
position of the steering wheel before driving.
Heated Steering Wheel*
While the Engine Start /Stop button is in the ON
position, press E to turn the steering wheel heater
ON. The button indicator will illuminate.
The steering wheel heater will turn off automatically
in 30 minutes, or when the button is pressed again
to deactivate.
Power Tilt/Telescoping Steering Wheel*† 26

47
Smart Power Liftgate*† 18 (Continued)
REMINDERS:
§
Smart Power Liftgate may be damaged if attempting to open or close manually
§ If going through a car wash, remind the attendant to keep the vehicle in Neutral (N) and keep the engine running. Also, disable the Smart Power Liftgate lid control using the button inside the glove compartment, turn off the auto rain-sensing wipers and fold in the mirrors
§ When not in use, keep the Liftgate Lid Control button in the OFF position
§ Ensure all obstacles are out of the way of the Liftgate lid when operating the Smart Power Liftgate
A
KIA KEY FOB VIDEO
To view a video on your mobile device, snap this QR Code or visit the listed website. Refer to inside cover for more information.
www.youtube.com/KiaFeatureVideos
QR CODE
See section 4 in the Owner’s Manual for more information.
§ The Liftgate must be unlocked before it can be opened by the Liftgate Release button
§ The Liftgate unlocks automatically and then can be opened manually when the Smart Key is within close proximity to the back of the vehicle
QUICK TIPS
Opening with no-touch activation:
When the Smart Key fob is on your person and you are within close proximity
of the back of the vehicle, the hazard lights will blink and a chime will sound for
about 3 seconds as an alert that the Smart Power Liftgate is about to open.
Then the alert system will blink and chime two additional times before opening
the Smart Power Liftgate.
The Smart Power Liftgate feature is OFF by default.
To enable the Smart Power Liftgate, go to User
Settings in the LCD Instrument Cluster modes.
Smart Key:
Using the Smart Key fob to automatically to open
the Smart Power Liftgate*, press and hold the
Smart Key Liftgate button A. Press again and
hold to close.
OTHER KEY FE AT URE S
OTHER KEY FEATURES
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPERATING INFORMATION AND SAFETY WARNINGS.*IF EQUIPPED†LEG AL DISCL AIMERS ON BACK INSIDE COVER

48
OTHER KEY FEATURES
OTHER KEY FE AT URE S
AABC
REMINDER: When room lamp lens is pressed ON it will remain ON, even when the map lamp switch is in the OFF position.
Automatic Turn Off Function
The interior lights automatically turn off approximately 20 seconds after the Engine Start /Stop button is
turned OFF.
Map/Room Lamp Operation
Map Lamps – These lights produce spot beams for convenient use as map lamps or as personal lamps for
the driver or the front passenger. Press the buttons A to turn the map lamps ON/OFF.
Room button – Press the button B to turn the front and rear lamps ON/OFF.
Door button – When the Door button C is pressed the front and rear lamps will turn ON as follows:
§ When a door is opened or doors are unlocked
with the Smart Key, the lamps will turn ON for
approximately 30 seconds
§ If the Engine Start /Stop button is in the ACC/
OFF position and a door is open, the lamps
will stay ON for approximately 20 minutes
§ If the Engine Start /Stop button is in the ACC/
ON position and a door is open, the lamps will
stay ON
The lamps will turn OFF immediately if the
Engine Start /Stop button is turned ON or all
doors are locked.
Map/Room Lamps
§ When doors are unlocked by the Smart Key, the lamp turns ON for approximately 30 seconds
§ If your vehicle is equipped with the theft alarm system, the interior lights automatically turn off approximately 3 seconds after the system is in armed stage
§ Using interior lights for an extended period of time may cause battery discharge
QUICK TIPS
See section 4 in the Owner’s Manual for more information.
*IF EQUIPPED

50
Auto-Dimming Rearview Mirror
Designed to help reduce glare from a vehicle’s headlights located in the rear and
also connect up to three electronic transmitters in one location. Press the on/off
button F to turn the auto-dimming function on or off.
REMINDER: Mirror indicator light will illuminate when automatic dimming is ON.
How to Sync Transmitter
1. Press and release A, B or D button
– If the indicator C flashes slowly in red, go to Step 3 (Programming)
– If the indicator C is continuously turned ON or flashes rapidly in red
several times, go to Step 2 (Erasing)
2. Press and hold the button you wish to erase the program for
approximately 15-25 seconds until the LED flashes slowly in Red
3. Hold the Garage Door Opener Original Transmitter near the HomeLink Mirror
4.
Press and hold the desired button (A, B or D) and the Original Transmitter button until the indicator C is turned on continuously or flashes rapidly in red. This indicates the programming is completed
To complete programming of a Rolling Code garage door opener:
1. Firmly press and release the “Learn,” “Smart,” or “Program” button of the garage door opener while the
indicator C flashes slowly in red. Once the button is pressed, you have approximately 30 seconds to
initiate the next step
2. Return to the vehicle and firmly press and hold the HomeLink button for two seconds and release. Repeat
this up to three times to complete the programming. Do not press the HomeLink button rapidly. At this
point, programming is complete and your device should operate
Operating HomeLink®: Press one of the programmed
HomeLink® buttons.
Erasing programmed buttons: Press and hold the left A and center D
buttons simultaneously for approximately 20 seconds, until the indicator
light begins to flash, and then release both buttons within 30 seconds.
HomeLink® with Auto-Dimming Rearview Mirror*† 14
For more information, go to HomeLink.com or call (800) 355-3515.
HOMELINK SUPPORT
To view this website on your mobile device, snap this QR Code or visit the listed website. Refer to inside cover for more information.
www.youtube.com/KiaFeatureVideos
QR CODE
§ Erasing programmed buttons will delete all trained transmitters
QUICK TIP
§ If the indicator C flashes rapidly in red continuously, but if the garage door opener does not operate, please continue to follow Rolling Code Programming steps below
QUICK TIP
See section 4 in the Owner’s Manual for more information.
OTHER KEY FEATURES
OTHER KEY FE AT URE S
*IF EQUIPPED†LEG AL DISCL AIMERS ON BACK INSIDE COVER
E
A HomeLink® Channel 1 button
B HomeLink® Channel 2 button
C Status Indicator LED
D HomeLink® Channel 3 button
E Rear light sensor
F Dimming ON/OFF button
G Compass control button
H Compass display
AB
C
D
E
FG
H
REMINDERS:
§ A ladder may be needed to access the garage door opener
§ A second person may be needed to help
§ Some of the steps are time sensitive