2021 KIA STINGER buttons

*IF EQUIPPED ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.35
AUTOSYNCOFFCLIMATE
A/C
REAR
FRONT
Climate Control Auto Function
Press AUTO A to select full auto operation. In AUTO mode
the driver and front passenger have full control of their own
temperature zones. The mode, fan speed, air intake and air
conditioning will activate and adjust accordingly to achieve
the temperature settings for each zone.
To set temperatures:
§ Tu r n A to set the driver’s zone temperature
§ Tu r n K to set the front passenger’s zone temperature
REMINDERS:
§ Continuous use of the climate control system in the recirculated air position may allow humidity to increase inside the vehicle which may fog the glass and obscure visibility
§ When in AUTO mode, Air Flow Mode and Fan Speed do not display on the Climate Control Display
§
Warm or cold outside air may flow in through vents if Recirculated Air button is not pressed ON (LED lit)
Defrost Outside Windshield
1. Set fan speed to the highest position H
2. Set temperature to hot A
3. Press the front defrost button B
Defog Inside Windshield
1. Set Fan Speed to highest position
2. Set Temperature to highest position
3. Press the front defrost button B
Face-Level F lo o r- L evel
Bi-Level Floor/Defrost-Level
Air Flow Modes
To select air flow modes, press the Mode Select
button I:
Dual-Zone Climate Control
Pressing the SYNC button K synchronizes both climate
control zones (driver and passenger) to the driver’s
temperature control.
A AUTO (Automatic) Climate Control
button
B Front Windshield Defrost button
C Rear Window Defrost button
D Air Conditioning button
E Recirculated Air button
F Fresh Air button
G System OFF button
H Fan Speed Control buttons
I Mode Select button
J Climate Control System button
K SYNC (Synchronize All Zones)
Temperature Control button
Automatic Climate Control System
Front Climate Control
Auto Defogging System
Auto defogging is designed to reduce the
fogging up of the inside of the windshield by
automatically sensing the moisture of the inside
of the windshield. The system will automatically
change to defrost mode when needed.
Auto Defogging is set ON by default. To cancel
Auto Defogging, press the Front Defrost button
for three seconds, when the ignition is in
on (ADS OFF icon will illuminate). To turn Auto
Defogging on again, press the Front Defrost
button for three seconds.
AK
B
G
CD
H
E
I
F
J
AUTO DEFOGGING SYSTEM (ADS) VIDEO
To view a video on your mobile device, snap this QR Code or visit the listed website. Refer to inside cover for more information.
www.youtube.com/KiaFeatureVideos
QR CODE
See section 4 in the Owner’s Manual for more information.
CENTER PANEL
CENTER PANEL

44
Front Seat Headrest Adjustment† 11
To raise headrest: Pull headrest up.
To lower headrest: Press the lock button A, then press the
headrest down.
REMINDERS:
§ Button may be hard to see if headrest is in its lowest position.
§
Do not operate the vehicle with the headrests removed. Headrests can provide critical neck and head support in an accident.
A
Driver Position Memory System*
The integrated system stores into memory the position of
the driver’s seat, outside rearview mirrors, steering wheel
positions and seat cushion extension*. To store positions
into memory, first place the gear shift into P (Park) while the
Engine Start /Stop button is in the ON position. Then:
1.
Adjust the driver’s seat, outside rearview mirrors, settings
and steering wheel positions
2.
Press the SET button B on the control panel. System will
beep once
3.
Press one of the memory buttons 1 or 2 C within 4 seconds.
The system will beep twice when memory has been stored
(Located on driver’s door control panel)
REMINDER: Do not operate the vehicle with the headrests removed. Headrests can provide critical neck and head support in an accident.
See section 3 in the Owner’s Manual for more information.
B
C
S E AT I N G
SE ATING
Refer to section 3 in the Owner’s Manual for more information.
§ For easy adjustments, hold a headrest post with one hand while using the other hand to pull the headrest from underneath
QUICK TIP
*IF EQUIPPED†LEG AL DISCL AIMERS ON BACK INSIDE COVER

48
OTHER KEY FEATURES
OTHER KEY FE AT URE S
AABC
REMINDER: When room lamp lens is pressed ON it will remain ON, even when the map lamp switch is in the OFF position.
Automatic Turn Off Function
The interior lights automatically turn off approximately 20 seconds after the Engine Start /Stop button is
turned OFF.
Map/Room Lamp Operation
Map Lamps – These lights produce spot beams for convenient use as map lamps or as personal lamps for
the driver or the front passenger. Press the buttons A to turn the map lamps ON/OFF.
Room button – Press the button B to turn the front and rear lamps ON/OFF.
Door button – When the Door button C is pressed the front and rear lamps will turn ON as follows:
§ When a door is opened or doors are unlocked
with the Smart Key, the lamps will turn ON for
approximately 30 seconds
§ If the Engine Start /Stop button is in the ACC/
OFF position and a door is open, the lamps
will stay ON for approximately 20 minutes
§ If the Engine Start /Stop button is in the ACC/
ON position and a door is open, the lamps will
stay ON
The lamps will turn OFF immediately if the
Engine Start /Stop button is turned ON or all
doors are locked.
Map/Room Lamps
§ When doors are unlocked by the Smart Key, the lamp turns ON for approximately 30 seconds
§ If your vehicle is equipped with the theft alarm system, the interior lights automatically turn off approximately 3 seconds after the system is in armed stage
§ Using interior lights for an extended period of time may cause battery discharge
QUICK TIPS
See section 4 in the Owner’s Manual for more information.
*IF EQUIPPED

50
Auto-Dimming Rearview Mirror
Designed to help reduce glare from a vehicle’s headlights located in the rear and
also connect up to three electronic transmitters in one location. Press the on/off
button F to turn the auto-dimming function on or off.
REMINDER: Mirror indicator light will illuminate when automatic dimming is ON.
How to Sync Transmitter
1. Press and release A, B or D button
– If the indicator C flashes slowly in red, go to Step 3 (Programming)
– If the indicator C is continuously turned ON or flashes rapidly in red
several times, go to Step 2 (Erasing)
2. Press and hold the button you wish to erase the program for
approximately 15-25 seconds until the LED flashes slowly in Red
3. Hold the Garage Door Opener Original Transmitter near the HomeLink Mirror
4.
Press and hold the desired button (A, B or D) and the Original Transmitter button until the indicator C is turned on continuously or flashes rapidly in red. This indicates the programming is completed
To complete programming of a Rolling Code garage door opener:
1. Firmly press and release the “Learn,” “Smart,” or “Program” button of the garage door opener while the
indicator C flashes slowly in red. Once the button is pressed, you have approximately 30 seconds to
initiate the next step
2. Return to the vehicle and firmly press and hold the HomeLink button for two seconds and release. Repeat
this up to three times to complete the programming. Do not press the HomeLink button rapidly. At this
point, programming is complete and your device should operate
Operating HomeLink®: Press one of the programmed
HomeLink® buttons.
Erasing programmed buttons: Press and hold the left A and center D
buttons simultaneously for approximately 20 seconds, until the indicator
light begins to flash, and then release both buttons within 30 seconds.
HomeLink® with Auto-Dimming Rearview Mirror*† 14
For more information, go to HomeLink.com or call (800) 355-3515.
HOMELINK SUPPORT
To view this website on your mobile device, snap this QR Code or visit the listed website. Refer to inside cover for more information.
www.youtube.com/KiaFeatureVideos
QR CODE
§ Erasing programmed buttons will delete all trained transmitters
QUICK TIP
§ If the indicator C flashes rapidly in red continuously, but if the garage door opener does not operate, please continue to follow Rolling Code Programming steps below
QUICK TIP
See section 4 in the Owner’s Manual for more information.
OTHER KEY FEATURES
OTHER KEY FE AT URE S
*IF EQUIPPED†LEG AL DISCL AIMERS ON BACK INSIDE COVER
E
A HomeLink® Channel 1 button
B HomeLink® Channel 2 button
C Status Indicator LED
D HomeLink® Channel 3 button
E Rear light sensor
F Dimming ON/OFF button
G Compass control button
H Compass display
AB
C
D
E
FG
H
REMINDERS:
§ A ladder may be needed to access the garage door opener
§ A second person may be needed to help
§ Some of the steps are time sensitive