2021 JEEP WAGONEER child restraint

W$5N,N*
Improper installation of a child restraint to the
LATCH anchorages can lead to failure of the
restraint. The child could be badly injured or
killed. Follow the child restraint manufac-
turer’s directions exactly when installing an
infant or child restraint.
Child restraint anchorages are designed to
withstand only those loads imposed by
correctly-fitted child restraints. Under no
circumstances are they to be used for adult
seat belts, harnesses, or for attaching other
items or equipment to the vehicle.
WARNING!
Improper installation or failure to properly
secure a child restraint can lead to failure of
the restraint. The child could be badly injured
or killed.
Follow the child restraint manufacturer’s
directions exactly when installing an infant or
child restraint.
6

22_WS_OM_EN_USC_t.book Page 311

W$5N,N*
Improper installation or failure to properly
secure a child restraint can lead to failure of
the restraint. The child could be badly injured
or killed.
WARNING!6

22_WS_OM_EN_USC_t.book Page 313

OoFkeG UeSeat
VteS 5.
7. )LQaOO\ SXOO XS oQ aQ\ e[FeVV ZebbLQg to tLgKteQ tKe OaS SoUtLoQ aUoXQG tKe FKLOG
UeVtUaLQt ZKLOe \oX SXVK tKe FKLOG UeVtUaLQt
UeaUZaUG aQG GoZQZaUG LQto tKe YeKLFOe Veat.
8. ,I tKe FKLOG UeVtUaLQt KaV a toS tetKeU VtUaS aQG tKe VeatLQg SoVLtLoQ KaV a toS tetKeU
aQFKoUage FoQQeFt tKe tetKeU VtUaS to tKe
aQFKoUage aQG tLgKteQ tKe tetKeU VtUaS. See
Úpage 314 for directions to attach a tether
anchor.
9. Test that the child restraint is installed tightly by pulling back and forth on the child seat at
the belt path. It should not move more than
1 inch (25.4 mmyfLQDQ\GLUHFWLRQ.
Any seat belt system will loosen with time, so check
the belt occasionally, and pull it tight if necessary.
Installing Child Restraints Using The Top
Tether Anchorage
1. Look behind the seating position where you plan to install the child restraint to find the
tether anchorage. You may need to move the
seat forward to provide better access to the
tether anchorage. If there is no top tether
anchorage for that seating position, move the
child restraint to another position in the
vehicle if one is available.

2. Route the tether strap to provide the most direct path for the strap between the anchor
and the child seat. If your vehicle is equipped
with adjustable rear head restraints, raise the
head restraint, and where possible, route the
tether strap under the head restraint and
between the two posts. If not possible, lower
the head restraint and pass the tether strap
around the outboard side of the head restraint.

Third Row Top Tether Strap Anchorage (Located On Seatbackyf

WARNING!
Do not attach a tether strap for a rear-facing car
seat to any location in front of the car seat,
including the seat frame or a tether anchorage.
Only attach the tether strap of a rear-facing car
seat to the tether anchorage that is approved for
that seating position, located behind the top of
the vehicle seat. See Ú page 307 for the
location of approved tether anchorages in your
vehicle.

W$5N,N*
An incorrectly anchored tether strap could
lead to increased head motion and possible
injury to the child. Use only the anchorage
position directly behind the child seat to
secure a child restraint top tether strap.
If your vehicle is equipped with a split rear
seat, make sure the tether strap does not slip
into the opening between the seatbacks as
you remove slack in the strap.
WARNING!
Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build-up
may cause serious injury or death.
It is extremely dangerous to ride in a cargo
area, inside or outside of a vehicle. In a colli-
sion, people riding in these areas are more
likely to be seriously injured or killed.
Do not allow people to ride in any area of your
vehicle that is not equipped with seats and
seat belts.
Be sure everyone in your vehicle is in a seat
and using a seat belt properly.
6

22_WS_OM_EN_USC_t.book Page 315