2021 HYUNDAI I20 oil

10-10
Maintenance
Follow Normal Maintenance Schedule if the vehicle is usually operated where none of
the following conditions apply.
If any of the following conditions apply, you must follow the Maintenance Under
Severe Usage Conditions.
• Repeated driving short distance of less than 8 km (5 miles) in normal temperature
or less than 16 km(10 miles) in freezing temperature
• Extensive engine idling or low speed driving for long distances
• Driving on rough, dusty, muddy, unpaved, graveled or salt-spread roads
• Driving in areas using salt or other corrosive materials or in very cold weather
• Driving in the condition of inflowing sand or dust into engine
• Driving in heavy traffic area
• Driving on uphill, downhill, or mountain road repeatedly
• Using for towing or camping, and driving with loading on the roof
• Driving as a patrol car, taxi, other commercial use of vehicle towing
• Frequently driving under high speed or rapid acceleration
• Frequently driving in stop-and-go condition
• Engine oil usage which is not recommended (Mineral type, Semi-synthetic, Lower
grade spec, etc.)
If your vehicle is operated under the above conditions, you should inspect, replace
or refill more frequently than the following Normal Maintenance Schedule. After the
periods or distance shown in the chart, continue to follow the prescribed maintenance
intervals.
SCHEDULED MAINTENANCE SERVICE

10-12
Maintenance
MAINTENANCE
INTERVALS
MAINTENANCE ITEMNumber of months or driving distance, whichever comes first
Kmsx1,000
1.51020304050607080
Months
2 1224364860728496
Years
- 12345678
ENGINE BAY
Engine oil & filter *
1 *2 *3
I RRRRRRRR
Drive beltAt first, Inspect 90,000km or 72 months after that,
Inspect every 30,000km or 24 month
Air cleaner filter 1.0 T-GDI C C R C R C R C C
S
martstream G1.2
CCCRCCRCC
Battery condition & specific gravity IIIIIIIII
Spark Plugs *
10
1.0 T-GDI Replace at every 70,000 kmsSmartstream G1.2
Replace at every 150,000 kms
Valve clearance *
4
Inspect at every 90,000 kms or 108 months
Vaccum Hose - - - I - - I - I
Idler / damper pulley/Adj. Bolt Inspect when replacing the drive belt or timing belt/chain
Brake/Clutch fluid Replace @ every 40,000 kms or 3 years
Engine Coolant (topup & specify gravity) *
5
Inspect at every service;
Replace first at 100,000 Km or 60 months ; then at every 30,000 Km or 24 months
Manual transaxle fluid *
6
------ I --
Dual Clutch transaxle fluid (if equipped)*
6
------ I --
MT system actuator fluid (if equipped) *
6
-R-R R-R
Intelligent Var. transaxle fluid (if equipped)*
6
-- -- I ---
I : Inspect and if necessary adjust,top-up, clean or replaceC : Clean and Replace if necessary R : Replace
NORMAL MAINTENANCE SCHEDULE - PETROL ENGINE (CONT.)

10-16
Maintenance
MAINTENANCE UNDER SEVERE USAGE CONDITIONS - PETROL ENGINEThe following items must be serviced more frequently on cars mainly used under severe driving conditions.
Refer to the chart below for the appropriate maintenance intervals.I : Inspect and if necessary, adjust, correct, clean or replace R:Replace or change
Maintenance itemMaintenance
operationMaintenance intervalsDriving
condition
Engine oil and engine oil filter R1.0 T-GDi every 5,000km (3,000miles) or 6 months
A, B, C, D, E, F,
G, H, I, J , K, L
Smartstream
G1.2every 7,500km (5,000miles) or 6 months
Air cleaner filter R Replace more frequently depending on the condition C, E
Spark plugs R Replace more frequently depending on the condition B, H
Manual transmission fluid
(Intelligent manual transmission fluid)
(if equipped)R Every 120,000 km (80,000 miles)C, D, E, F, G,
H, I, J
Dual clutch transmission fluid
(if equipped)R Every 120,000 km (80,000miles)C, D, E, F, G,
H, I, J
Steering gear rack, linkage and boots I Inspect more frequently depending on the condition C, D, E, F, G

10-17
10
Maintenance itemMaintenance
operationMaintenance intervalsDriving
condition
Front suspension ball joints I Inspect more frequently depending on the condition C, D, E, F, G
Disc brakes and pads, calipers and rotors I Inspect more frequently depending on the condition C, D, E, G, H
Drum brakes and linings I Inspect more frequently depending on the condition C, D, E, G, H
Parking brake I Inspect more frequently depending on the condition C, D, G, H
Driveshaft and boots I Inspect more frequently depending on the conditionC, D, E, F, G,
H, I, J
Climate control air filter R Replace more frequently depending on the condition C, ESevere driving conditionsA : Repeated short distance driving
B : Extensive idling
C : Driving in dusty, rough roads
D : Driving in areas using salt or other corrosive materials or in very
cold weather
E : Driving in the condition of inflowing sand or dust into engineF : Driving in heavy traffic area
G : Driving in mountainous areas
H : Towing a trailer
I : Driving for patrol car, taxi, commercial car or vehicle towing
J : Driving with high speed and rapid accelation
K : Frequently driving in stop-and-go condition
L : Engine oil usage which is not recommended (Mineral type, Semi-
synthetic, Lower grade spec, etc.)

10-18
Maintenance
MAINTENANCE
INTERVALS
MAINTENANCE ITEMNumber of months or driving distance, whichever comes first
Kmsx1,000
1.51020304050607080
Months
2 1224364860728496
Years
- 12345678
ENGINE BAY
Engine oil & filter *
1 *2 *3
I RRRRRRRR
Drive beltAt first, inspect every 80,000km (50,000miles) or 48months :
after that, inspect every 20,000km (12,500miles) or 12months
Air cleaner filter - C R C R C R C
Battery condition & specific gravityIIIIIIIII
Valve clearance*
4
Inspect at every 90,000 kms or 108 months
Hoses (Vaccum/ EGR / VGT/ WGT) -IIIIIIII
Idler / damper pulley/Adj. Bolt Inspect when replacing the drive belt or timing belt/chain
Brake/Clutch fluid Inspect @ Every service ; Replace @ every 45,000 km or 3 years
Engine Coolant (topup & specify gravity) *
5
Inspect at every service;
Replace first at 120,000 Km or 120 months ; then at every 30,000 Km or 24 months
Manual transaxle fluid *
6
------ I - I
Dual Transmission fluid (if equipped) *
6
No Check ; No Service reqd.
NORMAL MAINTENANCE SCHEDULE - DIESEL ENGINE
C : Clean and Replace if necessary I : Inspect and if necessary adjust,top-up, clean or replace
R : Replace

10-22
Maintenance
Maintenance itemMaintenance
operationMaintenance intervals Driving condition
Engine oil and engine oil filter R Every 5,000 km (3,000 miles) or 6 monthsA, B, C, D, E,
F, G, H, I, J, K, L
Air cleaner filter R Replace more frequently depending on the condition C, E
Manual transmission fluid R Every 120,000 km (80,000 miles)C, D, E, F,
G, H, I, J, K
Steering gear rack, linkage and boots I Inspect more frequently depending on the condition C, D, E, F, G
Front suspension ball joints I Inspect more frequently depending on the condition C, D, E, F, G
Disc brakes and pads, calipers and rotors I Inspect more frequently depending on the condition C, D, E, G, H
Intelligent variable transmission fluid
(if equipped)R Every 100,000 km (60,000 miles)A, C, D, E, F,
G, H, I, K,JMAINTENANCE UNDER SEVERE USAGE CONDITIONS - DIESEL ENGINEThe following items must be serviced more frequently on cars mainly used under severe driving conditions.
Refer to the chart below for the appropriate maintenance intervals.I : Inspect and if necessary, adjust, correct, clean or replace R : Replace or change

10-24
Maintenance
Engine oil and filter
The engine oil and filter should be
changed at the intervals specified in
the maintenance schedule. If the car
is being driven in severe conditions,
more frequent oil and filter changes are
required.
Drive belts
Inspect all drive belts for evidence
of cuts, cracks, excessive wear or oil
saturation and replace if necessary.
Drive belts should be checked
periodically for proper tension and
adjusted as necessary.
NOTICE
When you are inspecting the belt, place
the ignition switch in the LOCK/OFF or
ACC position.
Fuel filter
A clogged filter can limit the speed
at which the vehicle may be driven,
damage the emission system and cause
multiple issues such as hard starting.
If an excessive amount of foreign
matter accumulates in the fuel tank, the
filter may require replacement more
frequently.
After installing a new filter, run the
engine for several minutes, and check
for leaks at the connections.
We recommend that the fuel filter be
replaced by an authoized HYUNDAI
dealer.
Fuel lines, fuel hoses and
connections
Check the fuel lines, fuel hoses and
connections for leakage and damage.
We recommend that the fuel lines, fuel
hoses and connections be replaced by
an authoized HYUNDAI dealer.
WARNING
Diesel Engine
Never manipulate or modify the
injection system while running the
diesel engine or within 30 seconds
after turning OFF the diesel engine. The
high-pressure pump, high-pressure
pipes, rail, and injectors are still subject
to high pressure immediately after
stopping the diesel engine.
When the fuel leakage vents out, it
may cause serious body injury. Any
people, who are implanted with the
artificial cardiac pacemaker, should
remain away from the ECU or the
wiring harness by at least 30 cm,
while running the diesel engine. The
high currents of the electronic engine
control system produce a considerable
amount of magnetic fields.
Vapor hose and fuel filler cap
The vapor hose and fuel filler cap should
be inspected at those intervals specified
in the maintenance schedule. Make sure
that a new vapor hose or fuel filler cap is
correctly replaced.
EXPLANATION OF SCHEDULED MAINTENANCE ITEMS

10-28
Maintenance
ENGINE OIL
Checking the engine oil level
(Petrol Engine )
OBI3090003OBI3090003
„„Petrol Engine (1.0 T-GDi)Petrol Engine (1.0 T-GDi)
OBC3090009OBC3090009
„„Petrol Engine (Smartstream G1.2)Petrol Engine (Smartstream G1.2)
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach
normal operating temperature.
3. Turn the engine off and wait for a few
minutes (about 15 minutes) for the oil
to return to the oil pan.
4. Pull the dipstick out, wipe it clean, and
reinsert it fully.
5. Pull the dipstick out again and check
the level. The level should be between
F (Full) and L (Low).
OBI3090004OBI3090004
„„Petrol Engine (1.0 T-GDi)Petrol Engine (1.0 T-GDi)
OBC3090013OBC3090013
„„Petrol Engine (Smartstream G1.2)Petrol Engine (Smartstream G1.2)
If it is near or at L (Low), add enough
oil to bring the level to F (Full). Do not
overfill.
Use a funnel to help prevent oil from
being spilled on engine components.
Use only the specified engine oil. (Refer
to “Recommended lubricants and
capacities” in chapter 2.)