Page 176 of 787

174
uuTailgate uOpening/Closing the Power Tailgate*
Controls
Opening/Closing the Power Tailgate*
The power tailgate can be operated by  pressing the power tailgate button on the 
remote transmitter, pressing the power tail gate button in the driver’s side control 
panel, pressing the button on the tailgate, or by raising and lowering your foot 
under the center of the rear bumper for hands free access (if equipped).
The power tailgate can be opened/c losed when the transmission is in 
(P.
1Opening/Closing the Power Tailgate*
NOTICE
Do not push or pull on the power tailgate when it is 
being automatically  opened or closed.
Forcibly opening or closing  the power tailgate while 
in operation can deform the tailgate frame.
When operating the power tailgate, make sure there 
is enough space around your ve hicle. People near the 
tailgate may be se riously hurt if the tailgate hits or 
closes on their heads. Be  especially cautious if 
children are around.
The power tailgate may not  open or close under the 
following conditions:
•You start the engine while the tailgate is 
automatically openi ng or closing.
•The vehicle is parked on a steep hill.
•The vehicle is swayed in a strong wind.
•The tailgate or the roof is  covered with snow or ice.
3WARNING
Opening or closing a power tailgate while 
any part of a passenger is in the tailgate’s 
operating path can cause serious injury.
Make sure all passengers or objects are 
clear of the tailgate operating range 
before opening or closing the tailgate.
* Not available on all models
21 US ODYSSEY-31THR6310.book  174 ページ  2020年6月17日 水曜日 午後2時46分 
     
        
        Page 190 of 787

uuSliding Doors uOpening/Closing the Power Sliding Doors*
188
Controls
■Outer handles
Pull up on the outer handle toward you. The 
sliding door starts opening or closing.
When the power sliding door is locked, pulling 
the outer handle unlocks all the doors and 
tailgate while the remote is in your possession.
The power sliding door handle you pull 
operates the door automatically.
While a power sliding door is in operation, if 
you pull its handle, the beeper sounds and the 
operation stops.
Pull the same handle ag ain, the power sliding 
door reverses direction.
■Door Handles1 Opening/Closing the Power Sliding Doors*
The beeper will sound and  the power sliding door will 
not open if you pull the  inner or outer handle under 
the following conditions:
•The power mode is in ON.•The transmission is not in ( P.
•The brake pedal is released.
•The parking brake is released.
If you leave the power sliding door half open on a 
steep hill with the  engine off, the door starts to slide 
down toward the hill bottom after 30 minutes. While 
the door slides down, the beeper sounds.
Outer Handle
* Not available on all models
21 US ODYSSEY-31THR6310.book  188 ページ  2020年6月17日 水曜日 午後2時46分 
     
        
        Page 201 of 787
Continued199
uuOperating the Switches Around the Steering Wheel uENGINE START/STOP Button
Controls
If you leave the vehicle for 30 to  60 minutes with the transmission in (P and the 
power mode in ACCESSORY, the vehicle automa tically goes into the mode similar to 
VEHICLE OFF (LOCK) to avoid draining the battery.
When in this mode:
The steering wheel does not lock. 
You cannot lock or unlock doors with th e remote transmitter or the smart entry 
system.
Press the  ENGINE START/STOP button to switch the mode to VEHICLE OFF (LOCK).
■Automatic Power Off1ENGINE START/STOP Button
If the power mode does not  change from VEHICLE 
OFF to ACCESSORY, press the  ENGINE START/STOP 
button while moving the st eering wheel left and 
right. The steering wheel  will unlock, allowing the 
mode to change.
Do not leave the power mode in ACCESSORY or ON 
when you get out.
Canadian models
Canadian models
21 US ODYSSEY-31THR6310.book  199 ページ  2020年6月17日 水曜日 午後2時46分 
     
        
        Page 204 of 787

202
uuOperating the Switches Around the Steering Wheel uLight Switches
Controls
Light Switches
Rotating the light switch turns the lights on 
and off, regardless of the power mode 
setting.
■High beams
Push the lever forward until you hear a click.
■Low beams
When in high beams, pull the lever back to 
return to low beams.
■Flashing the high beams
Pull the lever back, and release it.
■Lights off
Turn the lever to  OFF either when:
• The transmission is in 
(P.
• The parking brake is applied.
To turn the lights on again, turn the lever to 
OFF  to cancel the lights  off mode. Even if you 
do not cancel the lights off mode, the lights 
come on automatically when:
• The transmission is taken out of 
(P and the 
parking brake is released.
• The vehicle starts to move.
■Manual Operation1Light Switches
If you leave the power mode in VEHICLE OFF with the 
lights on, a chime sounds when the driver’s door is 
opened.
When the lights are on, the  lights on indicator in the 
instrument pane l will be on.
2 Lights On Indicator  P. 98
Do not leave the lights on when the engine is off 
because it will  cause the battery to discharge.
If you sense that the le vel of the headlights is 
abnormal, have the vehicl e inspected by a dealer.
High Beams
Flashing the high beams Low Beams
Models without default AUTO position 
switch
Models with default AUTO position 
switch
High Beams
Flashing the high beams Low Beams
Turns on parking, side marker, 
tail, and rear license plate lights
Turns on headlights, parking, 
side marker, tail, and rear license 
plate lights
Models with default AUTO position switch
21 US ODYSSEY-31THR6310.book  202 ページ  2020年6月17日 水曜日 午後2時46分 
     
        
        Page 214 of 787

212
uuOperating the Switches Around the Steering Wheel uWipers and Washers
Controls
The rear wiper and washer can be used when 
the power mode is in ON.
■Wiper switch (OFF, INT, ON)
Change the wiper switch  setting according to 
the amount of rain.
■Washer ( )
Sprays while you rotate  the switch to this 
position.
Hold it to activate the wiper and to spray the 
washer. Once released, the washer spray will 
stop and the rear wiper will return to its 
selected switch setting after a few sweeps.
■Operating in reverse
When you put the transmission into 
(R with the windshield wiper activated, the rear 
wiper operates automatically as fo llows even if its switch is off.
*1: Models with manual intermittent operation
*2: Models with automati c intermittent operation
■Rear Wiper/Washer
ON: Continuous wipe
Washer OFF
INT : Intermittent
Front Wiper PositionRear Wiper Operation
INT*1 (Intermittent)
AUTO*2 (Intermittent) Intermittent
LO
 (Low speed wipe)
HI  (High speed wipe)Continuous
21 US ODYSSEY-31THR6310.book  212 ページ  2020年6月17日 水曜日 午後2時46分 
     
        
        Page 218 of 787

216
uuOperating the Switches Around the Steering Wheel uDriving Position Memory System*
Controls
Driving Position Memory System*
You can store two driver’s seat positions (except for power lumbar) and outside 
mirror positions with the driv ing position memory system.
When you unlock and open the driver’s door with a remote, the seat and outside 
mirrors adjust automatically to  one of the two preset positions.
When you enter the vehicle, the driver in formation interface briefly shows you which 
remote transmitter you used  to unlock the vehicle.
• DRIVER 1  transmitter is linked  to memory button 1.
• DRIVER 2  transmitter is linked  to memory button 2.
The driver’s seat moves rearward depending 
on the set seating position once you
•Stop the vehicle.
• Put the transmission in 
(P.
• Set the power mode to VEHICLE OFF.
• Then open the driver’s door.
Once the power mode is in the ACCESSORY 
position, the driver’s seat moves to the 
DRIVER 1  or 2 preset position.
1Driving Position Memory System*
Using the audio/informati on screen, you can disable 
the automatic seat and d oor mirrors adjustment 
function.
2 Customized Features  P. 465
The driver’s seat easy exit feature:
•Will move rearward to allow you to more easily exit 
the vehicle.
•Can be turned on or off. 2Customized Features  P. 465
System Operation
The system will not operate if:
•The vehicle speed is above 2 mph (3 km/h).
•Either memory button is pressed while the seat is in 
motion.
•The seat position is adju sted while in operation.
•The memory 1 or 2 position  is set fully to the rear.
DRIVER 1
DRIVER 2
* Not available on all models
21 US ODYSSEY-31THR6310.book  216 ページ  2020年6月17日 水曜日 午後2時46分 
     
        
        Page 219 of 787

217
uuOperating the Switches Around the Steering Wheel uDriving Position Memory System*
Controls
1. Set the power mode to ON. Adjust the 
driver’s seat and the door mirrors to the 
desired position.
2. Press the  SET button.
u You will hear the beep, and the memory 
button indicator light will blink.
3. Press and hold memory button 
(1 or (2 
within five seconds of pressing the  SET 
button.
u Once the seat and the outside mirrors 
position has been memorized, the 
indicator light on the button you pressed 
stays on.
1. Put the transmission into 
(P.
2. Apply the parking brake.
3. Press a memory button (
(1 or (2).
u You will hear the beeper, and the 
indicator light will blink.
The seat and the door mirrors will 
automatically move to the memorized 
position. When it has finished moving, you 
will hear the beep, and the indicator light 
stays on.
■Storing a Position in Memory1 Storing a Position in Memory
After you press the  SET button, the storing operation 
will be canceled when:
•You do not press the memory button within five 
seconds.
•You readjust the seat and door mirrors position 
before the double-beep.
•You set the power mode to any position except 
ON.
Memory 
Button 1
Memory 
Button 2
SET Button
■Recalling the Stored Position1 Recalling the Stored Position
The seat and the door mirrors  will stop moving if you:
•Press the SET button or memory button (1 or (2.
•Adjust the seat position or door mirrors.•Put the transmission into a position other than (P.
Memory 
Button 1
Memory 
Button 2
SET Button
21 US ODYSSEY-31THR6310.book  217 ページ  2020年6月17日 水曜日 午後2時46分 
     
        
        Page 221 of 787

219
Controls
Mirrors
Interior Rearview Mirror
Adjust the angle of the rearview mirror when you are sitting in the correct driving 
position.
Flip the tab to switch the position.
The night position will help to reduce the glare 
from headlights behind you when driving 
after dark.
When you are driving after dark, the 
automatic dimming rearview mirror and 
power door mirrors
* reduces the glare from 
headlights behind you. Press the auto button 
to turn this functi on on and off. When 
activated, the auto  indicator comes on.
■Rearview Mirror with Day and Night Positions*
1Mirrors
Keep the inside and out side mirrors clean and 
adjusted for best visibility.
Adjust the mirrors before you start driving. 2 Front Seats P. 222
Tab
Daytime 
Position Night Position
■Automatic Dimming Rearview Mirror* and Power Door 
Mirrors*
1 Automatic Dimming Rearview Mirror* and Power Door Mirrors*
The auto dimming function cancels when the 
transmission is in (R.
Sensor
Auto Button
* Not available on all models
21 US ODYSSEY-31THR6310.book  219 ページ  2020年6月17日 水曜日 午後2時46分