Page 429 of 632
Continued427
uuWhen Driving uStarting the Engine
Driving
You can remotely start the engine using the button on the smart entry remote.
■To start the engine
When started remotely, the engine automati cally shuts off after 10 minutes of idling
and/or the brake pedal and ENGINE START/STOP button have not been pressed
simultaneously.
To extend the run time for another 10 minutes during the first run, press the
button, then press an d hold the button.
u Some exterior lights flash six times if a 10-minute extension request was
transmitted successfully.
■Remote Engine Start with Vehicle Feedback*1 Remote Engine Start with Vehicle Feedback*
The remote engine start may violate local laws.
Before using the remote e ngine start, check your
local laws.
If there are buildings an d obstacles between your
vehicle and the remote, th e range will be reduced.
The range may be less when the vehicle is running.
This distance may vary by external electrical
interference.
The engine may not start by the remote engine start
if:
•You have disabled a remo te engine start setting
using the audio/information screen.
•The power mode is not in VEHICLE OFF.
•The transmission is in a position other than ( P.•The hood is open, or any door or the trunk is
unlocked.
3WARNING
Carbon monoxide ga s is toxic and can
rapidly accumulate in closed or even partly
enclosed areas.
Breathing it can cause unconsciousness and
even kill you.
Never use the remote engine starter with
the vehicle parked in a garage or other
areas with limited ventilation.
Press the button, th en press and hold
the button.
Some exterior lights flash once.
Go within the range,
and try again.
LED: Blinks when any button is pressed.
Some exterior lights flash six
times if the engine started. Exterior lights will not flash
if the engine does not start.
* Not available on all models
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book 427 ページ ２０２０年８月２５日 火曜日 午後２時６分
Page 538 of 632
536
Maintenance
Replacing Light Bulbs
Headlight Bulbs
When replacing, use the following bulbs.1.Push the tab to remove the coupler.
2. Rotate the old bulb counter-clockwise to
remove.
3. Insert a new bulb into the headlight
assembly and turn it clockwise.
4. Insert the coupler into the connector of the
bulb.
High beam headlight:60 W (HB3 for halogen bulb type)*
High beam headlight:LED type*
Low beam headlight:55 W (H11 for halogen bulb type)*
Low beam headlight:LED type*
■High Beam Headlights
1Headlight Bulbs
NOTICE
Halogen bulbs get very hot when lit.
Oil, perspiration, or a scratch on the glass can cause
the bulb to overhe at and shatter.
The headlight aim is set by the factory, and does not
need to be adjusted. Howeve r, if you regularly carry
heavy items in the trunk, have the aiming readjusted
at a dealer or by a qualified technician.
When replacing a halogen bu lb, handle it by its base,
and protect the glass from c ontact with your skin or
hard objects. If you touch the glass, clean it with
denatured alcohol and a clean cloth.
Headlights are LED type. Ha ve an authorized Honda
dealer inspect and replace the light assembly.
Models with halogen headlights
All models
Models with halogen headlights
Models with LED headlights
Models with halogen headlights
Tab Coupler
Bulb
* Not available on all models
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book 536 ページ ２０２０年８月２５日 火曜日 午後２時６分
Page 546 of 632
544
uuReplacing Light Bulbs uTaillights
Maintenance
Taillights
Taillights are LED type. Have an authoriz ed Honda dealer inspect and replace the
light assembly.
Rear License Plate Light
Rear license plate light is LED type. Have an authorized Honda dealer inspect and
replace the light assembly.
High-Mount Brake Light Bulb
When replacing, use the following bulb.
1.Open the trunk.
2. Turn the socket counter-clockwise and
remove it.
3. Remove the old bulb and insert a new bulb.
High-Mount Brake Light: 21 W
Bulb
Socket
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book 544 ページ ２０２０年８月２５日 火曜日 午後２時６分
Page 573 of 632
571
Handling the Unexpected
This chapter explains how to handle unexpected troubles.
ToolsTypes of Tools .................................. 572
If a Tire Goes Flat
Changing a Flat Tire ......................... 573
Engine Does Not Start Checking the Engine ........................ 580
If the Smart Entry Remote Battery is Weak .. 581Emergency Engine Stop ................... 582
If the Battery Is Dead ....................... 583
Shift Lever Does Not Move .............. 586
Overheating How to Handle Overheating ............. 587 Indicator, Coming On/Blinking
If the Low Oil Pressure Indicator Comes On....589
If the Charging System Indicator Comes On ...589
If the Malfunction Indicator Lamp Comes
On or Blinks ................................... 590
If the Brake System Indicator (Red) Comes On or Blinks ................................... 591
If the Brake System Indicator (Red) Comes On or Blinks at the Same Time When the Brake
System Indicator (Amber) Comes On ... 592
If the Electric Power Steering (EPS) System Indicator Comes On ....................... 593 If the Low Tire Pressure/TPMS Indicator
Comes On or Blinks ....................... 594
Fuses Fuse Locations ................................. 595
Inspecting and Changing Fuses ........ 598
Emergency Towing ........................... 599
If You Cannot Unlock the Fuel Fill Door... 600
If You Cannot Open the Trunk ........ 601
Refueling ........................................... 602
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book 571 ページ ２０２０年８月２５日 火曜日 午後２時６分
Page 574 of 632
572
Handling the Unexpected
Tools
Types of Tools
*1: 1.5 L engine models
*2: 2.0 L engine models without 235/40R18 tire
*3: 2.0 L engine models with 235/40R18 tire
1Types of Tools
The tools are stored in the trunk.
Wheel Nut Wrench/
Jack Handle Jack
Jack Handle Bar
Funnel
*3
*1, *2
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book 572 ページ ２０２０年８月２５日 火曜日 午後２時６分
Page 576 of 632
uuIf a Tire Goes Flat uChanging a Flat Tire
574
Handling the Unexpected
1. Open the trunk floor lid.
2. Take the tool case out of the trunk. Take
the jack, wheel nut wrench, and jack
handle bar out of the tool case.
3. Unscrew the wing bolt, and remove the
spacer cone. Then, remove the spare tire.
4. Place a wheel block or rock in front and rear
of the wheel diagonal to the flat tire.
■Getting Ready to Replace the Flat Tire1Getting Ready to Replace the Flat Tire
The shape of the tool case varies by model.
Tool Case
Spare Tire
Wheel
Blocks
The tire to be replaced.
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book 574 ページ ２０２０年８月２５日 火曜日 午後２時６分
Page 580 of 632
uuIf a Tire Goes Flat uChanging a Flat Tire
578
Handling the Unexpected
1. Remove the center cap.
2. Place the flat tire face down in the spare tire
well.
3. Remove the spacer cone from the wing
bolt, flip it over, and insert it back on the
bolt. Secure the flat tire with the wing bolt.
4. Securely store the jack, wheel nut wrench,
and jack handle bar back in the tool case.
Store the case in the trunk.
■Storing the Flat Tire1Storing the Flat Tire
Make sure the wire support ring is on the outer side
of the tire valve as shown.
3WARNING
Loose items can fly around the interior in a
crash and can seriously injure the
occupants.
Store the wheel, jack, and tools securely
before driving.
Models with wheel cover
Tire Valve
Wire Support Ring
Models with
aluminum
wheelsModels with aluminum wheels
Spacer Cone Wing Bolt
For
compact
spare tireFor full-
size tire
All modelsAll models
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book 578 ページ ２０２０年８月２５日 火曜日 午後２時６分
Page 602 of 632
600
Handling the Unexpected
If You Cannot Unlock the Fuel Fill Door
If you cannot unlock the fuel fill door, use the following procedure.1.Open the trunk.
2. Pull the green release cord beneath the rear
tray as shown.
u The release cord unlocks the fuel fill door
when it is pulled.
3. Open the fuel fill door.
2 How to Refuel P. 506
■What to Do If Unable to Unlock the Fuel Fill Door1What to Do If Unable to Unlock the Fuel Fill Door
After taking these steps, cont act a dealer to have the
vehicle checked.
Release Cord
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book 600 ページ ２０２０年８月２５日 火曜日 午後２時６分
