
uuOperating the Switches Around the Steering Wheel uWipers and Washers
166
Controls
When you push the lever down to  AUTO, the 
windshield wipers sweep once, and go into 
the automatic mode.
The wipers operate intermittently, at low 
speed, or at high speed and stops in 
accordance with the am ount of rainfall the 
rainfall sensor detects.
■Auto sensitivity adjustment
When the wiper function is set to  AUTO, you 
can adjust the sensitivity of the rainfall sensor 
(using the adjustment ring) so that wipers will 
operate in accordance  with your preference.
Sensor sensitivity
■Automatic Intermittent Wipers*1 Automatic Intermittent Wipers*
The rainfall sensor is in  the location shown below.
AUTO  should always be turned OFF before the 
following situations in order to prevent severe 
damage to the wiper system:
•Cleaning the windshield
•Driving through a car wash•No rain present
Rainfall Sensor
Adjustment Ring
Low sensitivity
High sensitivity
* Not available on all models
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book  166 ページ  2020年8月25日 火曜日 午後2時6分 

Continued481
uuHonda Sensing ®u Lane Keeping Assist System (LKAS)
Driving
The system can be used when th e following conditions are met.
• The lane in which you are driving has detectable lane markers on both sides, and 
your vehicle is in the center of the lane.
• The vehicle is traveling between about 45 and 90 mph (72 and 145 km/h).
• You are driving on a straight or slightly curved road.
• The turn signals are off.
• The brake pedal is not depressed.
• The wipers are not in high speed operation.
■How to activate the system
1.Press the  MAIN button.
u The LKAS  indicator comes on in the 
driver information interface.
The system is ready to use.
2. Press the LKAS button.
u Lane outlines appear on the driver 
information interface.
The system is activated.
■When the System can be Used1When the System can be Used
If the vehicle drifts toward either the left or right lane 
line due to the system appl ying torque, turn off the 
LKAS and have your vehi cle checked by a dealer.
MAIN Button
LKAS Button
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book  481 ページ  2020年8月25日 火曜日 午後2時6分 

483
uuHonda Sensing ®u Lane Keeping Assist System (LKAS)
Continued
Driving
■The system operatio n is suspended if 
you:
• Set the wipers to  HI.
u Turning the wipers o ff or setting it to LO 
resumes the LKAS.
• Set the wiper switch to  AUTO and the 
wipers operate at high speed.
u The LKAS resumes when the wipers stop 
or operate at low speed.
• Decrease the vehicle speed to about 40 
mph (64 km/h) or less.
u Increasing the vehicle  speed to about 45 
mph (72 km/h) or more resumes the 
LKAS.
• Depress the brake pedal.
u The LKAS resumes and starts detecting 
the lane lines again once you release the 
brake pedal.
■The LKAS may automatica lly be suspended when:
• The system fails to detect lane lines.
• The steering wheel is quickly turned.
• You fail to steer the vehicle.
• Driving through a sharp curve.
• Driving at a speed in excess of  approximately 90 mph (145 km/h).
Once these conditions no longer exist, the LKAS automatically resumes.
When the LKAS is suspended, 
the lane lines on the driver 
information interface change to 
contour lines, and the beeper 
sounds (if activated).
Models with automatic intermittent wipers
All models
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book  483 ページ  2020年8月25日 火曜日 午後2時6分 

uuHonda Sensing ®u Road Departure Mitigation (RDM) System
488
Driving
The system becomes ready to start sear ching for lane markings when all the 
following conditions are met:
• The vehicle is traveling between about 45 and 90 mph (72 and 145 km/h).
• The vehicle is on a straight  or slightly curved road.
• The turn signals are off.
• The brake pedal is not depressed.
• The wipers are not in continuous operation.
• The vehicle is not accelerating or braking, and the steering wheel is not being 
turned.
• The system makes a determination that the driver is not actively accelerating, 
braking or steering.
Press the RDM button to turn the system on 
and off.u The indicator in the button comes on and 
the message appears on the driver 
information interface when the system is 
on.
■How the System Activates
■RDM On and Off
1How the System Activates
The RDM system may automa tically shut off and the 
 indicator comes and stays on.
2 Indicators P. 78
RDM system function can  be impacted when the 
vehicle is:
•Not driven within a traffic lane.•Driven on the inside edge of a curve, or outside of 
a lane.
•Driven in a narrow lane.
1 RDM On and Off
When you have selected  Warning Only from the 
customized options using the driver information 
interface or audio/information screen, the system 
does not operate the steering wheel and braking. 2 Customized Features  P. 115, 325
The indicators for the Adaptive Cruise Control (ACC) 
with Low Speed Follow, Road Departure Mitigation 
(RDM), Vehicle Stability Assist
TM (VSA ®) system, 
Vehicle Stability AssistTM (VSA ®) OFF, Low Tire 
Pressure/TPMS* and Collision Mitigation Braking 
SystemTM (CMBSTM) may come on after reconnecting 
the battery. Drive a short distance at more than 12 
mph (20 km/h). The indicators should go off. If they 
do not, have your vehicl e checked by a dealer.RDM Button
Indicator
* Not available on all models
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book  488 ページ  2020年8月25日 火曜日 午後2時6分 

523
uuMaintenance Under the Hood uOpening the Hood
Maintenance
Opening the Hood
1. Park the vehicle on a level surface, and set 
the parking brake.
2. Pull the hood release handle under the 
driver’s side lower corner of the dashboard.
u The hood will pop up slightly.
3. Pull up the hood latch lever (located under 
the front edge of the hood to the center) 
and raise the hood. Once you have raised 
the hood slightly, you can release the lever.
4. Remove the support rod from the clamp 
using the grip. Mount the support rod in 
the hood.
When closing, remove the support rod, and 
stow it in the clamp,  then gently lower the 
hood. Remove your hand at a height of 
approximately 12 inches (30 cm) and let the 
hood close.1 Opening the Hood
NOTICE
Do not open the hood when the wiper arms are 
raised. The hood will strike  the wipers, resulting in 
possible damage to the hood and/or the wipers.
NOTICE
Do not press the engine cover forcibly. This may 
damage the engine cover and component parts.
When closing the hood, check that the hood is 
securely latched.
If the hood latch lever moves  stiffly, or if you can 
open the hood without lifti ng the lever, the latch 
mechanism should be cl eaned and lubricated.
3WARNING
The hood support rod can become very hot 
due to heat from the engine.
To ensure against possible burns, do not 
handle the metal section of the rod: Use 
the foam grip instead.
2.0 L engine models
Hood Release Handle
Pull
Lever
Support Rod
Grip
Clamp
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book  523 ページ  2020年8月25日 火曜日 午後2時6分 

565
uuCleaning uExterior Care
Continued
Maintenance
Exterior Care
Dust off the vehicle body after you drive.  Regularly inspect your vehicle for scratches 
on painted surfaces. A scratch on a painted  surface can result in body rust. If you 
find a scratch, promptly repair it.
Wash the vehicle regularly. Wash more frequently when driving in the following 
conditions:
• If driving on roads with road salt.
• If driving in coastal areas.
• If tar, soot, bird droppings, insects,  or tree sap are stuck to painted surfaces.
• Make sure to follow the instructions  indicated on the automated car wash.
• Fold in the door mirrors.
• For models equipped with automatic inte rmittent wipers, turn the wipers off.
• Keep sufficient distance between the  cleaning nozzle and the vehicle body.
• Take particular care around the windows. Standing too close may cause water to 
enter the vehicle interior.
• Do not spray high pressure water directly  into the engine compartment. Instead, 
use low pressure water and a mild detergent.
■Washing the Vehicle
■Using an Automated Car Wash
■Using High Pressure Cleaners
1 Washing the Vehicle
Do not spray water into the air intake vents. It can 
cause a malfunction.
Do not spray water onto the  fuel fill door directly. A 
high-pressure spray ma y cause it to open.
Do not spray water onto the capless unit when the 
fuel fill door is open. It ca n cause damage to the fuel 
system or engine.
If you need to lift the  wiper arms away from the 
windshield, first set the wiper arms to the 
maintenance position. 2 Changing the Wiper Blade Rubber  P. 545
Air Intake Vents
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book  565 ページ  2020年8月25日 火曜日 午後2時6分 

627
Index
Wi-Fi Connection.....................................  287
Window Washers .....................................  165
Adding/Refilling Fluid ..............................  535
Switch ....................................................  165
Windows (Opening and Closing) ............  148
Windshield ...............................................  165
Cleaning .........................................  563, 566
Defrosting/Defogging .............................  197
Washer Fluid ...........................................  535
Wiper Blades...........................................  545
Wipers and Washers ...............................  165
Winter Tires Snow Tires ..............................................  556
Tire Chains..............................................  556
Wipers and Washers ................................  165
Checking and Replacing Wiper Blades.....  545
Wireless Charger ......................................  187
WMA .................................................  221, 277
Worn Tires ................................................  548
21 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6500.book  627 ページ  2020年8月25日 火曜日 午後2時6分