Driving Your Vehicle
6-24
Warning messages
ORG3060031N
To release EPB, fasten seatbelt, close door,
hood and trunk
• If you try to drive with EPB applied, a
warning will sound and a message will
appear.
• If the driver's seat belt is unfastened
and the engine hood or trunk is
opened, a warning will sound and a
message will appear.
• If there is a problem with the vehicle,
a warning may sound and a message
may appear.
If the situation occurs, depress the brake
pedal and release EPB by pressing the
EPB switch.
WARNING
• Whenever leaving the vehicle or
parking, always come to a complete
stop and continue to depress the
brake pedal.
Shift the gear into P (Park), press
the EPB switch, and press the
Engine Start/Stop button to the OFF
position. Take the Key with you when
leaving the vehicle.
Vehicles not fully engaged in P (Park)
with the parking brake set are at risk
for moving inadvertently and causing
injury to yourself or others.
• NEVER allow anyone who is
unfamiliar with the vehicle to touch
the EPB switch. If EPB is released
unintentionally, serious injury may
occur.
• Only release EPB when you are
seated inside the vehicle with your
foot firmly on the brake pedal.
NOTICE
• Do not apply the accelerator pedal
while the parking brake is engaged.
If you depress the accelerator pedal
with EPB engaged, a warning will
sound and a message will appear.
Damage to the parking brake may
occur.
• Driving with the parking brake on
can overheat the braking system and
cause premature wear or damage
to brake parts. Make sure EPB is
released and the Parking Brake
warning light is off before driving.
Information
• A clicking sound may be heard while
operating or releasing the EPB. These
conditions are normal and indicate that
EPB is functioning properly.
• When leaving your keys with a parking
attendant or assistant, make sure to
inform him/her how to operate EPB.
08
8-21
When towing your vehicle in an emergency without wheel dollies:
1. Release EPB before turning off the
engine.
2. Press the Engine Start/Stop button to
the OFF position.
3. Change the gear to N (Neutral) by
pressing the P release button (need to
remove cap-cover) while pressing the
brake pedal. For more details, refer to
“Automatic Transmission” section in
chapter 6.
4. Press the Engine Start/Stop button to
the ACC position.
CAUTION
Failure to shift the gear to N (Neutral)
may cause internal damage to the
transmission.
Removable Towing Hook
1. Open the trunk, and remove the
towing hook from the tool case.
„„Front
ORG3080021
„„Rear
ORG3080018
2. Remove the hole cover by pressing
the lower part of the cover on the
bumper.
3. Install the towing hook by turning it
clockwise into the hole until it is fully
secured.
4. Remove the towing hook and install
the cover after use.
Maintenance
9-48
Instrument panel fuse panel
Fuse NameFuse Rating Circuit Protected
MODULE8 10ARear Radar LH/RH, ECS Unit, RWS Module, ADAS Unit
(Driving), ADAS Unit (Parking), Crash Pad Switch, Front
Console Switch, Steering Tilt & Telescopic Unit, LKAS Unit
MODULE5 10A
ICU Junction Block (ESU), Hazard Switch
MODULE3 10ARear Seat Console Remote Control Switch Switch, Active
Air Flap Module, Clock Spring, Steering Tilt & Telescopic
Unit, Multifunction Switch
P/WINDOW LH 30ADriver Power Window Module, Rear Power Window Module
LH
CURTAIN 10A
IBU
P/SEAT PASS2 25A
Passenger Power Seat Module
TRUNK 10A
Trunk Release Relay
AIR BAG1 15A
SRS Control Module
E-SHIFTER1 10A
Electronic ATM Shift Lever Dial
MODULE4 10A
Driver Door Module, Data Link Connector
P/SEAT DRV1 25A
Driver Power Seat Module
P/SEAT 10A
Driver/Passenger Lumbar Support Unit (3/5/7CELL)
POWER
HANDLE 15A
Steering Tilt & Telescopic Unit
IBU1 10AIAU, IBU, BLE Unit, Driver Door Outside Handle, Passenger
Door Outside Handle
POWER
OUTLET 20A
Armrest Power Outlet
P/SEAT DRV2 25A
Driver Power Seat Module
P/SEAT PASS1 25A
Passenger Power Seat Module
S/HEATER DRV 20A
Driver Power Seat Module
S/HEATER PASS 20A
Passenger Power Seat Module
DOOR LOCK 10A
Center Door Lock/Unlock Relay, Driver Door Unlock Relay
SPARE(B+) 10A
Not Used
MODULE6 10AArmrest Lamp, IBU, Low DC-DC Converter(AUX/AMP),
Electronic ATM Shift Lever Dial, Front Tray Lamp, IAU,
BRAKE SWITCH 10A
Stop Lamp Switch, IBU
