2021 FIAT PUNTO fuel

180
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
CONTROLS
AND DEVICES
SERVICE
AND CARE
WINDSCREEN/REAR
WINDOW WIPERS
BLADES
Regularly clean the rubber part using ap-
propriate products; TUTELA PRO-
FESSIONAL SC35 is recommended.
Replace the blades if the rubber edge is
misshapen or worn. In any event, it is ad-
visable to replace them approximately
once a year.
A few simple precautions can reduce the
possibility of damage to the blades:
❒make sure that the rubber part is not
frozen to the windscreen in sub-zero
temperatures. Use an antifreeze prod-
uct to release it if required;
❒remove any snow from the glass: in ad-
dition to protecting the blades, this pre-
vents the electric motor from over-
heating;
❒do not operate the windscreen wipers
on dry glass.
Driving with worn wiper
blades is a serious hazard,
because visibility is reduced in bad
weather.
WARNING
RUBBER TUBES
As far as the brake system and fuel rubber
hoses are concerned, stick closely to the
“Scheduled Servicing Plan” in this section.
Ozone, high temperatures and a pro-
longed lack of fluid in the system may
cause hardening and cracking of the tubes,
which could result in leaks. Careful in-
spections are therefore necessary.If the pressure is too low, the
tyre will overheat and could
be seriously damaged.
WARNING
Avoid switching the tyres
from the right side of the ve-
hicle to the left side and vice versa.
WARNING
Do not re-spray alloy wheel
rims at temperatures higher
than 150 °C. The mechanical char-
acteristics of the wheels may be
compromised.
WARNING
165-184 PUNTO POP 1ed EN 07/04/14 09:35 Pagina 180

185
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
INDEX
CONTROLS
AND DEVICES
TECHNICAL
SPECIFICATIONS
IDENTIFICATION DATA ................................................. 186
ENGINE CODES – BODY WORK VERSIONS ............. 188
ENGINE ........................................................................\
.......... 189
FUEL SUPPLY ......................................................................\
.. 190
TRANSMISSION .................................................................. 190
BRAKES .......................................................................\
........... 191
SUSPENSIO NS .....................................................................\
. 191
STEERING SYSTEM ............................................................. 191
WHEELS ........................................................................\
......... 192
PERFORMANCES ................................................................ 195
DIMENSIONS .......................................................................\
196
WEIGHTS ........................................................................\
...... 197
CAPACIT IES ........................................................................\
.. 199
FLUIDS AND LU BRICANTS ............................................. 200
FUEL CONSUMPT ION ...................................................... 202
CO
2EMISSIONS .................................................................. 203
T
T
E
E
C
C
H
H
N
N
I
I
C
C
A
A
L
L


S
S
P
P
E
E
C
C
I
I
F
F
I
I
C
C
A
A
T
T
I
I
O
O
N
N
S
S
185-206 PUNTO POP 1ed EN 24/03/14 13:52 Pagina 185

189
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
INDEX
CONTROLS
AND DEVICES
TECHNICAL
SPECIFICATIONS
ENGINE
INFORMATION
Type code
Cycle
Number and layout of cylinders
Piston bore and stroke mm
Total capacity cm3
Compression ratio
Max power (EEC) kW
HP
corresponding speed rpm
Max torque (EEC) Nm
kgm
corresponding speed rpm
Spark plugs
Fuel
(●) For versions/markets, where provided (▲) Euro 5 - Euro 5+ (■) Euro 4
1.3 Multijet 75HP
199A9000(▲)
199A2000 (■)
Diesel
4 in line
69.6 × 82 1248
16.8:1(
▲)
17.6:1 (■)
55
75
4000
190
19.4
1500
–
Diesel for
motor vehicles (EN590
specifications)
1.4
350A1000
199A7000 (●)
Otto
4 in line
72 × 84 1368
11.1:1
57 / 55 (
●)
77 / 75 (●)
6000
115
11.7
3250
NGK
ZKR7A-10 Champion
RA8MCX4
Unleaded petrol 95 RON
(Specification EN228)
1.2 (Euro 4)
199A4000
Otto
4 in line
70.8 × 78.86
1242
11.1:1
48
65
5500
102
10.4
3000
NGK
ZKR7A-10 Champion
RA8MCX4
Unleaded petrol 95 RON
(Specification EN228)
1.3 Multijet 85HP
199B4000
Diesel
4 in line
69.6 x 82 1248
16.8:1
62
85
3500
200
20.4
1500
–
Diesel for
motor vehicles (EN590
specifications)
1.2 (Euro 5 - Euro 6)
169A4000
Otto
4 in line
70.8 x 78.86
1242
11.1:1
51
69
5500
102
10.4
3000
NGK
ZKR7A-10 Champion
RA8MCX4
Unleaded petrol 95 RON
(Specification EN228)
185-206 PUNTO POP 1ed EN 24/03/14 13:52 Pagina 189

190
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
INDEX
CONTROLS
AND DEVICES
TECHNICAL
SPECIFICATIONS
FUEL SUPPLY
1.2 - 1.4 1.3 Multijet
Fuel supply Multipoint electronic injection “Common Rail” Multijet direct injection
Modifications or repairs to the fuel supply system that are not carried \
out properly or do not take the system’s
technical specifications into account can cause malfunctions leading to \
the risk of fire.
WARNING
TRANSMISSION
1.2 - 1.4 - 1.3 Multijet
Gearbox Five forward gears plus reverse with synchronisersfor selecting forward gears
Clutch Self-adjusting with no free travel
Drive Front
185-206 PUNTO POP 1ed EN 24/03/14 13:52 Pagina 190

5 doors5 seats
1030
560
850
850
1590
900
40050
60
3 doors5 seats
1025
560
850
850
1585
1000 400
50
60
5 doors5 seats
1040
560
850
850
1600
1000 400
50
60
197
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
INDEX
CONTROLS
AND DEVICES
TECHNICAL
SPECIFICATIONS
WEIGHTS
1.2 1.4
Weights (kg)
Unladen weight (with all fluids,
fuel tank filled to 90% and
without optional equipment):
Payload (*) including the driver:
Maximum permitted loads (**)
– front axle:
– rear axle:
– total:
Towable loads:
– braked trailer:
– non-braked trailer:
Maximum load on roof:
Maximum load on the
ball joint (braked trailer):
(*) If special equipment is fitted (sunroof, tow hitch, etc.) the unladen \
car weight increases, thus reducing the specified payload with respect to the maximum permitted load.
(**) Loads that must not be exceeded. The driver is responsible for arranging\
the goods in the boot and/or on the load carrying platform
within the maximum permitted loads.
3 doors 5 seats
1015
560
850
850
1575
900
40050
60
185-206 PUNTO POP 1ed EN 24/03/14 13:52 Pagina 197

198
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
INDEX
CONTROLS
AND DEVICES
TECHNICAL
SPECIFICATIONS
3 doors 5 seats
1090
560
950
850
1650
1000 400
50
60
5 doors5 seats
1105
560
950
850
1665
1000 400
50
60
3 doors5 seats
1130
560
950
850
1690
1000 400
50
60
5 doors5 seats
1145
560
950
850
1705
1000 400
50
60
1.3 Multijet 75HP 1.3 Multijet 85HP
Weights (kg)
Unladen weight (with all fluids,
fuel tank filled to 90% and
without optional equipment):
Payload (*) including the driver:
Maximum permitted loads (**)
– front axle:
– rear axle:
– total:
Towable loads:
– braked trailer:
– non-braked trailer:
Maximum load on roof:
Maximum load on the
ball joint (braked trailer):
(*) If special equipment is fitted (sunroof, tow hitch, etc.) the unladen \
car weight increases, thus reducing the specified payload with respect to the maximum permitted load.
(**) Loads that must not be exceeded. The driver is responsible for arranging\
the goods in the boot and/or on the load carrying platform
within the maximum permitted loads.
185-206 PUNTO POP 1ed EN 24/03/14 13:52 Pagina 198

1.3 Multijet85HP
–
–
45
5 ÷ 7
6.7 –
–
3.0
3.2
1.7 (
■)
0.5
2.2
4.5
1.4
45
5 ÷ 7
–
–
5.3
2.4
2.6 –
–
1.5 (
●)
0.5
2.2
4.5
1.2
45
5 ÷ 7
–
–
5.3
2.4
2.6 –
–
1.5 (
●)
0.5
2.2
4.5
CAPACITIES
Fuel tank: litres
including a reserve of: litres
Fuel tank: litresincluding a reserve of: litres
Engine cooling
system: litres
Engine sump: litres
Engine sump and filter: litres
Engine sump: litres
Engine sump and filter: litres
Gearbox/differential
casing: kg
Hydraulic brake circuit: kg
Windscreen/rear window
washer fluid reservoir: litres
with headlight washers: litres
( ❒ ) For particularly harsh climate conditions, a mixture of 60% PARAFLUUPand 40% distilled water is recommended.
(
▲) Per condizioni climatiche particolarmente rigide, si consiglia l’util\
izzo di TUTELA TRANSMISSION GEARFORCE.
(*) Euro 4
(**) Euro 5 - Euro 5+
Recommended fuels
and original lubricants
Unleaded petrol with no less
than 95 R.O.N.
(EN228 Specification)
Diesel for motor vehicles
(EN590 Specification)
50-50 mixture of water and
PARAFLU
UPliquid (❒)
SELENIA K P.E.
SELENIA WR P.E.
TUTELA
CAR TECHNYX (
●) (▲)
TUTELA TRANSMISSION
GEARFORCE(■)
TUTELA TOP 4
Mixture of water and
TUTELA
PROFESSIONAL SC35
199
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
INDEX
CONTROLS
AND DEVICES
TECHNICAL
SPECIFICATIONS
1.3 Multijet
75HP
–
–
45
5 ÷ 7
7,4 *
6,7 **
–
–
3.0
3.2
1.7 (
●)
0.5
2.2
4.5
185-206 PUNTO POP 1ed EN 24/03/14 13:52 Pagina 199

200
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
INDEX
CONTROLS
AND DEVICES
TECHNICAL
SPECIFICATIONS
FLUIDS AND LUBRICANTS
Your car is equipped with an engine oil that has been thoroughly develop\
ed and tested in order to meet the requirements of the
Scheduled Servicing Plan. Constant use of the prescribed lubricants guar\
antees the fuel consumption and emission specifications .
Lubricant quality is crucial for engine operation and duration.
SPECIFICATIONS AND RECOMMENDED PRODUCTS
Use Quality specifications of fluids and lubricants Original Replacement
for correct car operation fluids and lubricants interval
Lubricants for
petrol engines
Lubricants for
diesel engines
In case of emergency, if lubricants with the prescribed specifications a\
re not available, products with the minimum indicated A CEA
performance can be used for topping up; in this case optimal performance\
of the engine is not guaranteed. SAE 5W-40 ACEA C3
grade synthetic base lubricant.
FIAT 9.55535-S2 certification.
SAE 5W-30
grade synthetic base lubricant.
FIAT 9.55535-S1 certification.
SELENIA K P.E.
Contractual Technical
Reference
N° F603.C07
SELENIA WR P.E.
Contractual Technical
Reference
N° F510.D07As per
the Scheduled
Servicing Plan
As per
the Scheduled
Servicing Plan
The use of products with specifications other than those indicated above\
could cause damage
to the engine not covered by the warranty.
185-206 PUNTO POP 1ed EN 24/03/14 13:52 Pagina 200