5
KEYLESS (PUSHBUTTON) STARTF
KEYED IGNITION (L AND LS MODELS ONLY)
The Remote Keyless Entry transmitter must be in the vehicle to turn on the ignition.
STARTING THE ENGINE
With the transmission in Park or Neutral, press and hold the brake pedal and then press the ENGINE START/STOP button to start the engine. The green button indica-tor will illuminate.
Note: If the Remote Keyless Entry transmitter battery is weak, place the transmitter in the pocket at the back of the small storage compartment in the center console to enable the engine to start. Replace the transmitter battery as soon as possible.
STOPPING THE ENGINE/OFF
Shift to Park and press the ENGINE START/STOP button to turn off the engine.
ACCESSORY MODE
With the engine off and the brake pedal not depressed, press the ENGINE START/STOP button to place the ignition in accessory mode to operate the radio, wi\
ndows and other accessories with the engine off. The amber button indicator wi\
ll illuminate.
See Driving and Operating in your Owner’s Manual.
STARTING THE VEHICLE
With the vehicle in Park or Neutral, rotate the key clockwise to the Start position.
TURNING OFF THE VEHICLE
Shift to Park.
Push the key all the way in (1) and then rotate the key counter-clockwise to the Lock/Off position (2).
See Driving and Operating in your Owner’s Manual.
2
1
STEERING WHEEL ADJUSTMENT
With the vehicle parked, push down the lever under the left side of the \
steering
column to adjust the steering wheel. The steering wheel can be moved up \
or down and in or out. Pull up the lever to lock the steering wheel in place.
See Instruments and Controls in your Owner’s Manual.
F Optional equipment
6
POWER FRONT SEATSF
POWER SEAT ADJUSTMENTS
A. Seat Adjustment
Move the horizontal control to move the seat forward or rearward and to tilt, raise or lower the seat.
B. Seatback Recline Adjustment
Move the vertical control to recline or raise the seatback.
C. Lumbar Support Adjustment
Press and hold the round control to adjust the lumbar support.
See Seats and Restraints in your Owner’s Manual.
POWER LIFTGATEF
OPEN/CLOSE THE POWER LIFTGATE
Press the Power Liftgate button on the Remote Keyless Entry (RKE) trans-mitter twice.
Press the Power Liftgate knob (A) on the driver’s door.
Press the touchpad (B) above the license plate to open the liftgate.
Press the button (C) on the bottom edge of the liftgate to close the l\
iftgate.
PROGRAMMING THE LIFTGATE HEIGHT
1. Turn the Power Liftgate knob to the 3/4 mode position.
2. Open the liftgate.
3. Adjust the liftgate manually to the desired height.
4. To save the setting, press and hold the button (C) on the bottom edge of the liftgate until the turn signals flash and a beep sounds.
HANDS-FREE OPERATION
To open or close the liftgate hands-free, kick your foot straight under the driver’s side of the rear bumper, left of center. The RKE transmitter must be within 3 feet of the liftgate. The Chevrolet logo is projected on the ground near the rear bumper, indicating the kicking mot\
ion location for hands-free operation. The logo is shown for 1 minute, depending on o\
perating conditions.
See Keys, Doors and Windows in your Owner’s Manual.
F Optional equipment
ABC
C
B
A
